14
Op ration
Op ration
15
It is not necessary to rinse normal food soils off the dishes
before putting them in the dishwasher although larger solid
particles such as bones seeds skins pits and toothpicks
should be removed.
If you are not going to run the dishwasher immediately after
loading it is best to rinse salty and highly acidic foods off
stainless steel silver and silverplate flatware. Prolonged
contact of foods—including lemon juice salt vinegar mustard
mayonnaise and salad dressings—with stainless steel can
cause corrosion (pitting).
B for Op ration
1. Load the dishes per recommended loading. See section
on Loading Dishwasher.
2. Make sure there is rinse agent in the dispenser. Add rinse
agent if needed. See section on Rinse Agent.
3. Add proper amount of detergent and pre-wash. See
section on Dishwasher Detergent.
4. Select the desired cycle and option(s).
5. Push both top and bottom racks in.
6. Press “START”. The “START” symbol will illuminate to
indicate the unit is ready.
7. Close the door tightly until you hear a click. Otherwise the
dishwasher will not start.
Option R strictions
All options are not available for all cycles. Please note the
following:
• The option “HI TEMP WASH” is not available in the
“ECONO/CHINA” cycle.
• No options are available in the “RINSE/HOLD” cycle.
After selecting the wash cycle and options depress “START”
button. The start symbol will illuminate. This merely means the
machine is ready. Close the door securely within 4 seconds of
pressing the “START” button.
Changing a Program
Changing a Program Aft r th Unit has Start d
The dishwasher is programmed to stop operating if the door is
opened during a cycle. To change a program or option after
starting the machine open the door slightly to let the spray
arms stop rotating and avoid getting sprayed with water. Press
and hold “START” for four seconds to cancel the current
selection then press the touchpad(s) for your desired selection.
Press “START” again and close the door. The drain pump will
run to remove any dirty water from the dishwasher before
starting the newly selected cycle. Check to make sure there is
still detergent in the detergent dispenser.
Op ning th Door aft r Cycl has Start d
If the door is opened after the cycle has started the ”START”
button will flash to indicate that the dishwasher is in Standby
Mode. Press the “START” button and close the door securely
within 4 seconds to restart the cycle.
Preparing Dishes
