Viking BVGRC8366BWSS Technisches Handbuch
Viking Range Corporation
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information
call 1-888-VIKING1 (845-4641)
or visit the Viking Web site at
vikingrange.com
F21040 EN
(102512)
Viking Use/Installation Guide
Brigade Range/Rangetop Accessories
32
screw
holes
HIGH-SHELF BACK
(rear view)
Rear Trim Accessories
Rear Trim Accessories
Backguards come equipped with Nylon Spacers (See Figure 1), which are needed to space the range off a
combustible wall at a prescribed safe distance.
Important: If installing the range with a backguard against a combustible wall, then the spacers are
mandatory and must remain in place on the backguard.
If installing the range with a backguard against a non-combustible wall, then the spacers can be removed
(See Figure 2).
Once you determine whether or not your product needs the provided spacers, the backguard is ready to be
attached.
ATTACHING HIGH-SHELF
Simply slide the high-shelf back down onto the rear of the unit until it settles on the shoulder screws located on
the back of the range.
ATTACHING BACKGUARD
Figure 1 Figure 2
Simply slide the backguard down onto the
rear of the unit until it settles on the shoulder
screws located on the back of the range.
screw
holes
Once the backguard is in position, attach using the
(4) screws provided.
Once the high-shelf back is in position, attach using the (4) screws provided. Once secured to the range, place
the top rolled edge (X) of the high shelf over the front lip of the high-shelf back.
X
HIGH-SHELF
(side-view)
54
Place the countertop side trim template against the side of the range or rangetop. The flange of the
template should be wrapped around the back of the unit. The top of the template should be even
with the top edge of the outer trim. Mark the holes and remove template. Using a 9/64” drill bit, drill
the three designated holes into the side of the range or rangetop. Place the countertop side trim into
place and secure with the (3) provided screws.
Countertop Side Trim
A
1. Locate screw hole openings (A) on back of island trim near the top.
2. Align screw hole openings on countertop rear trim with the ones on the back of the island trim.
3. Attach rear trim to island trim with enclosed screws.
Countertop Rear Trim
76
Curb Bases
Alternate Curb Base View
for Custom Ranges
STANDARD CURB BASE FRONT
1. The standard curb base front (A) is completely assembled.
2. Remove the assembly from the carton and simply clip onto the front range legs.
3. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet toe front is
possible. Loosen brackets on each side, but allow snug fit. Clip assembly onto range legs; determine
front to back setting; remove, tighten bolts, and reattach.
A
Important Note: The range must be installed as specified in the range installation guide for proper airflow
when using the standard curb base.
CUSTOM CURB BASE FRONT
1. Remove the standard curb base front assembly from the carton.
2. Remove the front (A) from the mounting assembly (B).
3. Attach locally supplied front (C) to the mounting assembly (B) and simply clip onto the front
range legs.
Important Note: The locally supplied front must not be any taller than 3-1/8” (7.9 cm) tall. Fronts taller
than 3-1/8” (7.9 cm) could obstruct the airflow.
4. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet
toe front is possible. Loosen brackets on each side, but allow snug fit. Clip assembly onto
range legs; determine front to back setting; remove, tighten bolts, and reattach.
B
C
Curb Bases
Important Note: The range must be installed as specified in the range installation guide for proper
airflow when using the custom curb base.
98
Stainless Steel Surface Grates
To install the accessory stainless steel surface grates, simply remove the cast iron grate which came standard
with the range or rangetop.
Replace with the appropriate stainless grate.
Stainless Steel Grate Care
and Cleaning Tips
These stainless steel surface burner grates are the same as what is commonly used in commercial and
restaurant style ranges. Over time they will naturally start to darken and discolor. This is the standard process
of how stainless steel reacts when it is exposed to high heat temperatures. The discoloration of the grates will
not affect the performance.
While the stainless steel surface burner grates will never return to the original color, there are some steps which
can be taken to help minimize the discoloration of these components. To ensure that the stainless steel
maintains adequate corrosion resistance, it should be cleaned regularly. Surface contaminates vary in terms of
corrosiveness, effect on surface finish, and ease of removal. The mildest form of cleaning should always be
used first.
To clean a lightly soiled surface
•It is recommended to use warm water, a mild, non-abrasive detergent, and a soft cloth.
For more highly soiled/discolored surfaces
•It is recommended to scrub the grates using a dry heavy duty green Scotch Brite pad. Note -
scrubbing the grates with a Scotch Brite pad will help improve the look of the heat tarnished grate but
will not completely restore it to its original look.
Things to avoid when cleaning stainless steel
•Steel brushes or steel wool
•Abrasive cleaners
•Bleach or hydrochloric acid based cleaners
•Detergents containing chloride
•Avoid using cleaning cloths that have been used on ordinary steel
•Never rub against the grain with a cleaning agent or polish as it will alter the surface of the steel and
reduce the corrosion resistance.
•DO NOT permit citrus or tomato juice to remain on stainless steel surface, as citric acid will
permanently discolor stainless steel. Wipe up any spills immediately
1110
Andere Handbücher für BVGRC8366BWSS
2
Dieses Handbuch passt für folgende Modelle
1
Andere Viking Reichweite Handbücher
Viking
Viking VGSC530-4B* Bedienungsanleitung
Viking
Viking VGIC245-Q* Bedienungsanleitung
Viking
Viking VGCC5364QSS Bedienungsanleitung
Viking
Viking Viking 970 Bedienungsanleitung
Viking
Viking VGIC306-4B Series Bedienungsanleitung
Viking
Viking RDSCG230 Bedienungsanleitung
Viking
Viking RDSCD2305BSS Bedienungsanleitung
Viking
Viking Professional Custom VISC5304B Bedienungsanleitung
Viking
Viking Professional Custom VISC5304B Bedienungsanleitung
Viking
Viking RVGR3302 Bedienungsanleitung
Viking
Viking VGIC5302 Bedienungsanleitung
Viking
Viking BVGRC836-6B-W Bedienungsanleitung
Viking
Viking Designer DCCG1304BSS Bedienungsanleitung
Viking
Viking RDSCG230-5B Bedienungsanleitung
Viking
Viking RVER330 Bedienungsanleitung
Viking
Viking RVGR330 Bedienungsanleitung
Viking
Viking 30" W Bedienungsanleitung
Viking
Viking D3 Series Bedienungsanleitung
Viking
Viking RDGSU2005B Bedienungsanleitung
Viking
Viking 3 Series Bedienungsanleitung
