Vip-Vision SLR-B Series Bedienungsanleitung

Version: VIPSLRB-Q219.1

Solar IP CCTV Surveillance

SLR-B Series Quick Install Guide

VIP Vision SLR-B Solar Surveillance Installation Manual - Version: VIPSLRB-Q219.1

1x 120W or 180W Solar Panel Assembly

(w/ remote control device)

1x 4.0MP Mini PTZ Dome Camera

(default, camera may vary)

1x Surveillance Camera

Mount Assembly

Pre-installed 128GB MicroSD

Card in Surveillance Camera

(default, card size may vary)

Ubiquiti 5.8GHz 120° Wireless

Bridge (1x Access Point, 1x

Station)

(WiFi system only)

Huawei 4G Modem Router with

WiFi

(4G system only)

Pole, base plate & SIM card not included.

Required Install Tools: T40 torx key for junction box (included), 4mm & 10mm Allen keys for solar

panel (not included), 8mm drill bit & battery drill, at head screwdriver. Laptop with RJ45 network

interface strongly recommended for camera setup.

1. Pre-Install Information

1.1 Included Components

Thank you for purchasing a SLR-B Series Solar Surveillance System.

This install guide covers basic setup, installation and use of your surveillance system.

For more information and warranty details, please visit:

www.vip-vision.com

Visit www.vip-vision.com for support 3

Professional Series 4.0MP 4x Zoom Mini PTZ Dome

Note: Camera has been preinstalled with the supplied 128GB microSD card and has been precongured

to record 4.0MP (2592 x 1520) at 25fps.

The username and password details for the camera can be found on the conguration sheet inside

the junction box. The default username is admin.

To prevent unauthorised access, we reccomend you change the admin password before completing

installation.

Default Camera Conguration

Main Stream

Stream Type General

Encode Type H.265

Resolution 4.0MP (2592 x 1520)

FPS 25

Encoding Method Variable Bit Rate

Quality 6 (Best)

Ref Stream 1536-8192Kbps

I Frame Interval 50

Watermark Yes

Sub Stream

Stream Type General

Encode Type H.265

Resolution D1 (704 x 576)

FPS 10

Encoding Method Constant Bit Rate

Bit Stream 512Kbps

Ref Stream 139-768Kbps

I Interval 20

SVC 1 (off)

1.2 Camera Information

VIP Vision SLR-B Solar Surveillance Installation Manual - Version: VIPSLRB-Q219.1

120W/180W Solar Panel with Motion-Sensing Street Light

Solar Panel Specications

SLR-B120 SLR-B180

Panel Type 120W monocrystalline silicon panel 180W monocrystalline silicon panel

Battery 12.8V/500Wh Lithium Iron Phosphate

(LiFePO4) w/ Low Voltage Cutoff

25.6V/500Wh Lithium Iron Phosphate

(LiFePO4) w/ Low Voltage Cutoff

Panel Tilt Adjust -60° ~ 60° with angle compass

Ingress Protection IP65

Wind Tolerance Up to 65m/s

Dimensions (Panel) 1321 x 525 x 161mm 1496 x 685 x 161mm

Diameter (Spigot) Ø50 ~ 60mm

This solar panel system is tted with undervoltage protection, which disconnects the load at

approximately 10V (SLR-B120) or 20V (SLR-B180). If you are not receiving any voltage on the output

wires, place the panel in direct sunlight for a minimum of one hour and re-test.

The output will be reconnected automatically when battery voltage reaches approximately 11.5V

(SLR-B120) or 23.0V (SLR-B180). For more information on panel conguration, refer to Section 4.

This product must be installed in direct sunlight. Shade will negatively impact performance.

This solar panel includes a motion-activated LED light. For more information, refer to Section 4.

1.3 Solar Panel Information

Visit www.vip-vision.com for support 5

Solar Panel Dimensions

1.3 Solar Panel Information (continued)

SLR-B120

SLR-B180

VIP Vision SLR-B Solar Surveillance Installation Manual - Version: VIPSLRB-Q219.1

Solar Panel Assembly Diagram

Lamp Arm

Optional Bird Spikes

1.3 Solar Panel Information (continued)

Accessories

# Component

1Solar panel

2LED light

3Microwave sensor

4Lamp arm

5Bird spikes

6Screws

7Safety rope

8T40 Torx

Visit www.vip-vision.com for support 7

1. Drill an 8mm hole in the pole

(minimum 15cm down from the

top of the pole) on the same side

that the camera will be mounted.

This is for the solar panel power

cable to run through. The position

of the hole will vary depending

on what position on the pole the

camera is to be mounted.

2. Feed the gure-eight power cable

connected to your solar panel

through the hole created above

3. Lift the solar panel to the top of the

pole, feeding the any loose cable

down the pole. Slide the solar panel

mounting bracket over the spigot.

4. Align the panel in a north-south

orientation, with the LED light end

of the panel pointing south.

5. Tightly fasten the included security

screws to the bracket (Fig. 2.1b)

8mm

Fig. 2.1a

Solar panel power cable drill location

Fig. 2.1b

Installed grub screws

Caution: Solar panel must be placed so it is in direct sunlight all day - Any shading will

greatly reduce the solar panel’s performance.

For poles greater than 4m in height, tapered poles are preferable for camera stability and pole

strength - Contact VIP Vision if you require further information.

2. Installation

2.1 Mounting the Solar Panel to the Pole

VIP Vision SLR-B Solar Surveillance Installation Manual - Version: VIPSLRB-Q219.1

To ensure your solar panel absorbs as much light as possible, it’s important to adjust the solar panel

angle to match your region. (refer to table below).

For Australia and all locations in the southern hemisphere, the lower edge of the solar panel must

point north. Locations in the northern hemisphere must have the power edge of the panel pointing

south.

The angle of tilt is determined by the installation location and is calculated as installation latitude + 15°

IMPORTANT: Failure to direct the panel correctly will cause system failure through insufcient power

Ideal panel angles (H°) by Australian city

Sydney Melbourne Canberra Perth Brisbane Hobart Adelaide Darwin

49° 53° 50° 47° 42.5° 58° 50° 27.5°

1. Use a at head screwdriver to remove the bracket cover (Fig. 2.2a).

2. Once the cover is removed, use the supplied T40 torx loosen the panel adjustment screw and tilt the

panel to the required angle with the LED light at the high side. (Fig. 2.2b).

3. Tighten the bolt after adjusting the angle to secure the solar panel in place.

4. Replace the cover.

How to adjust tilt angle:

2.2 Adjusting the Solar Panel Angle

For example, Sydney has a latitude of 34°, therefore the solar panel should be tilted directly north with

an angle of 34 + 15 = 49°.

If you are uncertain the of your area, Google makes it easy to nd the latitude for any location: For

example, searching for “latitude Newcastle NSW Australia” will return 32.9283° S, 151.7817° E. The

latitude is the rst number shown (32.9283) which rounds up to 33°.

Tilt Angle

North

Visit www.vip-vision.com for support 9

2.2 Adjusting the Solar Panel Angle (continued)

CDE

Included

Band Clamps

# Part

A Camera

B Camera Adapter

C Right Angle Bracket

DJunction Box

E Pole Mount Bracket

F Pole

The camera, camera adapter, right angle bracket and junction box are supplied

preassembled (A, B, C & D).

• Mount the pole mount bracket to the pole rst.

• After the pole mount is installed, mount the junction box to the pole mount.

• Open the junction box and tighten the screws inside to securely fasten it

to the pole mount.

2.3 Mounting the Camera to the Pole

Fig. 2.2a

Solar panel angle

screw cover

Fig. 2.2b

Solar panel angle

adjustment screw

VIP Vision SLR-B Solar Surveillance Installation Manual - Version: VIPSLRB-Q219.1

1. Mount the pole mount bracket onto the pole using 3 included band clamps (Fig. 2.3b).

Note: There are two sets of included band clamps, 65-89mm and 80-150mm covering poles sizes from approximately

55-135mm in diameter - please choose the most appropriate clamps for your pole.

Fig. 2.3a

Mounted pole bracket (front)

Fig. 2.3b

Mounted pole bracket (back)

2.3 Mounting the Camera to the Pole (continued)

Andere Handbücher für SLR-B Series

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Vip-Vision Sicherheitskamera Handbücher

Vip-Vision

Vip-Vision FBIR Series Bedienungsanleitung

Vip-Vision

Vip-Vision SLR-B Series Bedienungsanleitung

Vip-Vision

Vip-Vision VDIRM Series Bedienungsanleitung

Vip-Vision

Vip-Vision VDIRME Series Bedienungsanleitung

Vip-Vision

Vip-Vision PTZIRW Series Bedienungsanleitung

Vip-Vision

Vip-Vision SLR-B Series Bedienungsanleitung

Vip-Vision

Vip-Vision VDIRME Series Bedienungsanleitung

Vip-Vision

Vip-Vision Solar Series Bedienungsanleitung

Vip-Vision

Vip-Vision SLR-B Series Bedienungsanleitung

Vip-Vision

Vip-Vision VSIP12MPFEIRV2 Bedienungsanleitung

Vip-Vision

Vip-Vision Pinhole Series Bedienungsanleitung

Vip-Vision

Vip-Vision Panoramic Series Bedienungsanleitung

Vip-Vision

Vip-Vision VSIP2MPVDIRFV2 Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung

Lumens

Lumens VC-A50PNW Bedienungsanleitung