Intercom System Configuration
The process to set up your Intercom system may vary depending upon your system structure. Please
see the following examples of system structures and follow the process which best meets your
requirements.
System Structure A –Standalone 1 to 1 by direct connection
This configuration has only 1 of each unit and requires a single Cat5e network cable to run directly from
the Indoor Monitor to the Door Station.
System Structure B –Standalone 1 to 1 system via a network switch
This configuration has only 1 of each unit and requires a Cat5e network cable from each Indoor Monitor
and Door Station, to the network switch.
System Structure C –Standalone 1 to 1 system via an existing computer network
This configuration still has only 1 of each unit but has a Cat5e network cable from both the Indoor
Monitor and Door Station, to your network switches and then uses the existing LAN to connect. Even
through the Intercom system will be running across your network, it will still use its Default IP address
range.
System Structure D –Multiple Door Stations to a Monitor via a network
This configuration is more complex as you can use 2 or more Door Stations with an Indoor Monitor but
you will need to change some IP addresses. You will require a Cat5e network cable from each the Indoor
Monitor and Door Station, to a network switch or to your existing LAN.
System Structure E –Single Door Stations to Multiple Monitors via a network
This configuration is more complex as you can use your Door Stations with 2 or more Indoor Monitors
but you will need to change some IP addresses. You will require a Cat5e network cable from each the
Indoor Monitor and Door Station, to a network switch or existing LAN to connect.
System Structure F –Multiple Door Stations to Multiple Monitors via a network
This configuration is the most complex as you will need to change the IP address of each Door Station
and each Indoor Monitor. It will allow you to use up to 6 Indoor Monitors and 6 Door Stations together.
You will also require a Cat5e network cable from each the Indoor Monitor and Door Station, to a network
switch or to your existing LAN.
The User Password is 123456 which may be used for basic operation of the Intercom System.
The Project Password 002236 is required only for configuration and set up of additional devices.
The Door stations own web interface of will require the Username admin and a Password of admin.
