VIPA CP 1413plus Bedienungsanleitung

Subject to change to cater for technical progress

Manual

CP 1413plus

Order No.: VIPA SSN HB83E

Rev. 00/07

jkjlj

CP1413plus manual

Subject to change to cater for technical progress

The information contained in this manual is subject to change without notice. VIPA GmbH does not

accept any liabilities, express or implied, with this document. Any hardware and software described

in this manual is supplied on the basis of a general licence. Software usage and disclosure to third

parties is only permitted where this is subject to the contractual conditions. Anyone who prepares

copies of the software or the manual on magnetic tape, diskette or any other medium for purposes

other than for personal use will be prosecuted, unless prior written permission is obtained from

VIPA GmbH.

The software described in this manual is protected by international Copyright laws. Any information

that might have become available after this manual was printed are supplied in a file on the

accompanying disk. If this information is available insert the VIPA driver diskette #1 into drive A

and enter the following command for MS-DOS:

A>TYPE README.TXT

If you should be using Windows®, you can use "NOTEPAD" to view the file.

Ohmstraße 4, D-91074 Herzogenaurach

Tel.: +49 (91 32) 744-0

Fax.: +49 (91 32) 744-144

EMail: [email protected]

http://www.vipa.de

Hotline: +49 (91 32) 744-114

VIPA®is a registered trade mark of VIPA company for visualisation and process automation Ltd..

Windows®is a registered trade mark of Microsoft Corp.

Windows®NT is a registered trade mark of Microsoft Corp.

Windows®95 is a registered trade mark of Microsoft Corp.

MS-DOS®is a registered trade mark of Microsoft Corp.

SIMATIC®is a registered trade mark of Siemens AG.

NetWare®is a registered trade mark of Novell Corp.

IBM-LAN-Server®and OS/2®are registered trade marks of IBM

3Com®is a registered trade mark of 3Com Corp.

EtherLink®III is a registered trade mark of 3Com Corp.

Any other trade marks referred to in the text are the trade marks of the respective owner and we acknowledge their registration.

CP1413plus manual

Subject to change to cater for technical progress

About this manual

This manual describes the installation of the hardware and the software for a Industrial Ethernet

(H1) network.

The manual also contains a comprehensive description of the configuration and the programming of

a Industrial Ethernet network using VIPA H1 components.

Overview

Chapter 1: Introduction

This chapter contains a short description of two adapters that you may use for the

respective type of LAN. The chapter is concluded by a description of the operation

and properties of these two adapters.

Chapter 2: Planning a Network

Here you will find a summary of available cabling methods for networks together

with the respective hardware and guidelines as well as a list of possible

combinations. The chapter also presents an introduction to network planning and

the preparation and installation of the respective hardware.

Chapter 3: VIPA Network module CP1413plus

This chapter contains a technical description of the VIPA ethernet adapter

CP1413plus for personal computers. It also contains instructions for the

configuration and installation of the VIPA ethernet adapter for personal computers

with ISA- and PCI-bus interfaces and for the required software.

Chapter 4: Programming

This chapter contains a complete reference for the VIPA H1 interfacing software.

This includes specifications of the H1 layer 4 and the PLC layer 7 programming

interface.

Chapter 5: Files constants and structures

This chapter contains a description of the parameter file. It also contains up-to-

date listings for the header files H1Def.h, S5Access.h, DrvFCall.h and

WMKTypes.h.

Chapter 6: Examples

These examples demonstrate how you may receive and transmit with or without a

parameter file.

Chapter 7: H1-driver V3.xx for Windows NT

This chapter contains a complete description of the application of the CP1413plus

PC-adapter for Windows NT.

CP1413plus manual Contents

Rev. 00/07 i

Contents

1 INTRODUCTION...........................................................................................................1-1

1.1 Safety and handling precautions for the user....................................................1-1

1.1.1 Handling electrostatically sensitive modules ....................................................1-1

1.1.2 Shipping electrostatically sensitive modules.....................................................1-2

1.1.3 Tests and modifications to electrostatically sensitive modules.........................1-2

1.2 General...................................................................................................................1-3

1.3 Operation...............................................................................................................1-4

1.4 Construction..........................................................................................................1-4

1.5 Communication functions....................................................................................1-5

1.6 Access functions...................................................................................................1-5

1.7 Special features.....................................................................................................1-5

2 NETWORK PLANNING.................................................................................................2-1

2.1 Ethernet network-terminology.............................................................................2-1

2.2 Thin-ethernet-cable networks..............................................................................2-3

2.2.1 Thin-ethernet-cable network-layout..................................................................2-5

2.2.2 Regulations and specifications.........................................................................2-6

2.2.3 Technical data thin-ethernet.............................................................................2-7

2.3 Thick-ethernet-cable networks ............................................................................2-8

2.3.1 Thick-ethernet-cable network-layout...............................................................2-10

2.3.2 Regulations and specifications.......................................................................2-11

2.3.3 Technical data thick-ethernet .........................................................................2-13

2.4 Combining thin/thick ethernet cable in networks ............................................2-14

2.4.1 Combination of thin/thick ethernet cable hardware ........................................2-14

2.4.2 Thin/thick ethernet cable combination network-layout....................................2-15

2.5 Twisted Pair.........................................................................................................2-16

2.5.1 Twisted pair-cable network-layout..................................................................2-16

2.6 Planning a network-layout..................................................................................2-18

2.7 Standards and specifications ............................................................................2-19

3 VIPA CP1413PLUS NETWORK ADAPTER .................................................................3-1

3.1 Z'nyx PCI-bus adapter...........................................................................................3-2

3.1.1 Properties.........................................................................................................3-2

3.1.2 Shipment..........................................................................................................3-2

3.1.3 Hardware installation........................................................................................3-4

3.1.4 Software installation .........................................................................................3-7

3.2 3COM ISA-bus adapter .......................................................................................3-30

3.2.1 Properties.......................................................................................................3-30

3.2.2 Shipment........................................................................................................3-30

3.2.3 Hardware installation......................................................................................3-32

3.2.4 Software installation .......................................................................................3-39

3.3 Entry into protocol file [H1PROT_NIF] ..............................................................3-62

Contents CP1413plus manual

ii Rev. 00/07

4 PROGRAMMING.......................................................................................................... 4-1

4.1 General information on programming................................................................ 4-1

4.1.1 Summary, operation - procedure..................................................................... 4-3

4.1.2 Description of the H1-parameters.................................................................... 4-6

4.1.3 Error messages from .Fehler........................................................................... 4-8

4.1.4 Determining the ethernet address.................................................................. 4-10

4.2 H1 Layer 4 program interface............................................................................ 4-11

4.2.1 General information on the H1 program interface.......................................... 4-11

4.2.2 General H1 Layer 4 functions........................................................................ 4-13

4.2.3 Specific H1 Layer 4 functions ........................................................................ 4-29

4.3 PLC Layer 7 program interface .........................................................................4-41

4.3.1 General information on the PLC program interface....................................... 4-41

4.3.2 General Layer 7 functions.............................................................................. 4-42

4.3.3 File functions Layer 7.....................................................................................4-47

4.3.4 Specific Layer 7 functions..............................................................................4-61

5 FILES, CONSTANTS AND STRUCTURES.................................................................. 5-1

5.1 Parameter file description ................................................................................... 5-1

5.2 Constants and structures.................................................................................... 5-4

5.2.1 H1 protocol driver definitions............................................................................. 5-4

5.2.2 Layer 7 interface definition...............................................................................5-7

5.2.3 Definition of calling codes for drivers............................................................. 5-10

5.2.4 Definition of call types....................................................................................5-12

6 EXAMPLES .................................................................................................................. 6-1

6.1 Simple H1 transmission example........................................................................6-1

6.2 PLC reception example using a parameter file.................................................. 6-3

6.2.1 Source listing ................................................................................................... 6-3

6.2.2 Source diagrams.............................................................................................. 6-5

6.2.3 The respective PLC program...........................................................................6-8

6.2.4 The respective CP143plus parameter settings................................................6-9

6.2.5 The respective parameter file Net.net............................................................6-10

7 H1 DRIVER V3.XX FOR WINDOWS NT ...................................................................... 7-1

7.1 General.................................................................................................................. 7-1

7.2 Uninstalling older Windows NT drivers.............................................................. 7-1

7.3 Installation of the VIPA CP1413plus network adapter....................................... 7-1

7.4 Installation of the H1 driver V3.xx for Windows NT 3.51................................... 7-2

7.4.1 Installation of SSN-BG88 (Z'nyx adapter) for PCI bus..................................... 7-2

7.4.2 Installation of SSN-BG85C (3COM adapter) for ISA-Bus................................ 7-3

7.5 Installation of the H1 driver V3.xx for Windows NT 4.0..................................... 7-4

7.5.1 Installation of SSN-BG88 (Z'NYX adapter) for PCI-Bus...................................7-4

7.5.2 Installation of SSN-BG85C (3COM adapter) for ISA-Bus................................ 7-5

7.5.3 Extensions to the configuration options........................................................... 7-6

CP1413plus manual Contents

Rev. 00/07 iii

7.6 Programming.........................................................................................................7-7

7.6.1 General notes on programming........................................................................7-7

7.6.2 H1 Layer 4 programming interface.................................................................7-21

7.6.3 PLC Layer 7 software interface......................................................................7-55

7.6.4 PLC Net file functions.....................................................................................7-85

7.6.5 Files, constants and structures.......................................................................7-97

Appendix...................................................................................................A-1

A Technical data......................................................................................................... A-1

B Abbreviations..........................................................................................................B-1

C List of figures..........................................................................................................C-1

D Index ........................................................................................................................D-1

Contents CP1413plus manual

iv Rev. 00/07

1 Introduction

1.1 Safety and handling precautions for the user 1-1

1.1.1 Handling electrostatically sensitive modules 1-1

1.1.2 Shipping electrostatically sensitive modules 1-2

1.1.3 Tests and modifications to electrostatically sensitive modules 1-2

1.2 General 1-3

1.3 Operation 1-4

1.4 Construction 1-4

1.5 Communication functions 1-5

1.6 Access functions 1-5

1.7 Special features 1-5

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere VIPA Netzwerk-Hardware Handbücher

VIPA

VIPA System 300S Bedienungsanleitung

Beliebte Netzwerk-Hardware Handbücher anderer Marken

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Bedienungsanleitung

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Bedienungsanleitung

Yudor

Yudor YDS-16 Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-320L Bedienungsanleitung

Samsung

Samsung ES1642dc Gebrauchsanweisung

Honeywell Home

Honeywell Home LTEM-PV Montageanleitung

evertz

evertz 7700 Series Bedienungsanleitung

D-Link

D-Link ShareCenter DNS-343 Bedienungsanleitung

Asante

Asante AsanteBridge 1012 Bedienungsanleitung

FireBrick

FireBrick FB2700 Bedienungsanleitung

Audiovox Electronics

Audiovox Electronics ARWH2T Bedienungsanleitung

ADC

ADC DSX-1 Handbuch

NetComm

NetComm NF2 Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 5620 Bedienungsanleitung

Dell EMC

Dell EMC XC6420 Series Bedienungsanleitung

Lanner

Lanner NCA-1020A Bedienungsanleitung

Allied Telesis

Allied Telesis AT-TN121-A Bedienungsanleitung

Arista

Arista CCA-ETM-Q12 Bedienungsanleitung