· Please read the manual carefully before the installation in order to make use the
camera to be set up correctly and to have the best picture quality.
· Please keep the manual in good condition for your future reference and service
application.
· Installation and services should only be carried out by an authorized personnel
according to local safety regulations.
· If any liquid or solid matter gets into the housing, immediately disconnect the
camera
from power supply and have it checked by your authorized dealer before reusing.
· Avoid installing the camera at extremely hot or cold places.
· If you are not a certified person, never try to dismantle the camera. To avoid
electric
shock, never remove the screws or covers. There are no parts inside that need
maintenance by the user. All maintenance should be carried by qualified personnel.
· Avoid installing the camera at a place of high humidity.
· Avoid installing the camera at the place exposed to gas or oil.
· Keep the top glass of the lens always clean in order to obtain the best picture
quality
all the time. Be careful not to be stained by fingerprint.
· Don't face the camera directly toward sunlight or sunlight reflecting area.
CCD may go defective at this condition.
· Please give a special attention to keep the unit from dangerous drop or external
shock
during the process of transportation or handling.
· Never try to touch the camera in wet hand. It may cause an electric shock.
· Do not put objects inside the unit. Make sure that no metal objects or flammable
substances get into the camera. It could cause fire, short-circuits or damages.
· Do not expose the camera to radioactivity. It causes a serious damage on the
CCD.
· Install away from electric or magnetic fields.
4 5
1. Precautions 2. Limitation of liability
3. Disclaimer of warranty
Make sure to use a regulated 12VDC or 24VAC power source.
Check the power with the power tester to make sure if the power supply gives an
exact 12VDC or 24VAC regulation. Even sometimes UL marked power supply unit
generates unstable power causing the camera to burn in many cases.
☞Note for 12VDC/24VAC Power type camera user
This publication is provided “AS IS” without warranty of any kind, either express
or implied, including but not limited to, the implied warranties of merchantability,
fitness for any particular purpose, or noninfringement of the third party's right. This
publication could include technical inaccuracies or typographical errors. Changes are
added to the information herein, at any time, for the improvements of this
publication and/or the corresponding product(s).
In no event shall seller be liable to any party or any person, except for replacement
or reasonable maintenance of the product, for the cases, including but not limited to
below :
(1) Any damage and loss, including without limitation, direct or indirect, special,
consequential or exemplary, arising out of or relating to the product;
(2) Personal injury or any damage caused by inappropriate use or negligent
operation
of the user;
(3) unauthorized disassemble, repair or modification of the product by the user;
(4) Inconvenience or any loss arising when images are not displayed, due to any
reason
or cause including any failure or problem of the product;
(5) Any problem, consequential inconvenience, or loss or damage, arising out of the
system combined by the devices of third party.
(6) Any claim or action for damages, brought by any person or organization being
photogenic subject, due to violation of privacy with the result of that surveil-
lance-
camera's picture, including saved data, for some reason, becomes public or is
used
for the purpose other than surveillance.
