Vivotek SD9361-EHL Bedienungsanleitung

Quick Installation Guide

VIVOTEK INC.

6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.

|T:+886-2-82455282|F:+886-2-82455532|E:[email protected]

VIVOTEK USA, INC.

2050 Ringwood Avenue, San Jose, CA 95131

|T: 408-773-8686 |F: 408-773-8298 |E: [email protected]

2MP • 20x/30x Zoom • 60fps • NEMA 4x • IP68 • Extreme Weatherproof

All specications are subject to change without notice.

P/N:625033602G Rev.: 1.2

SD9362-EH/EHL Speed Dome

Network Camera

English 繁中日本語 Español Português

簡中 Français Deutsch Italiano Türkçe Polski Русский Česky Svenska

Dansk

Nederlands

Indonesia

VIVOTEK Europe

Randstad 22-133, 1316BW Almere, The Netherlands

T:+31(0)36-5298-434 E:[email protected]

SD9361-EHL

EN-1

English

Warning Before Installation

Refer to your user’s manual for the

operating temperature.

Power off the Network Camera as soon as

smoke or unusual odors are detected.

Do not touch the Network Camera during

a lightning storm.

Do not disassemble the Network Camera.

Do not drop the Network Camera.

Do not insert sharp or tiny objects into the

Network Camera.

Do not manually pan and tilt the Network

Camera when the power is on.

Package Contents

Software CD

Wall Mount Bracket / ScrewsSD9361/ SD9362

Quick Installation Guide

I/O Combo Cable

Screws / Alignment Sticker / T20 and T25

L-wrench / Desiccant Bags

IMPORTANT:

Below are the requirements for powering the the speed dome:

Feature Power Consumption

Normal w/ heater 48W, requires a 60W PoE injector (AP-GIC-010A-060) or PoE switch (AW-

IHU-0100, -0200, -0600); AC24V (3.5A) also applies

w/ IR unit 95W, VIVOTEK's AW-IHU-0101 & AW-IHU-0201

DC 24V (3.5A) applies, AC 24V is not sufcient.

EN-2

Top View

IR unit connector

Lens

Outer View

Physical Description

LAN connector

Status LED

Reset Button

This drawing shows a camera with its dome

cover removed.

MicroSD card slot

Safety wire hook

I/O combo connector

Alignment marks

EN-3

English

Hardware Installation

Ø 9.5mm or 3/8”

1. Jot down the camera's MAC address for later reference.

2. The camera weighs 3kg. Select a rigid mounting location to prevent vibration to the

camera. Attach the alignment sticker to the wall.

3. Drill 4 pilot holes (9.5mm in diameter and 4cm deep) into the wall, and then hammer

in threaded anchors. Note that you should hammer the anchors with hex nuts on

them so that the threaded poles will not be deformed! If preferred, drill another hole

for routing cables.

4. Remove the hex nuts, washers, and leave one washer on each of the threaded poles.

0002D10766AD

SDXXXX

EN-4

LAN I/O combo

5. Connect power or I/O wires, and use foam tapes or seal foam to ensure the back-end

connection is waterproof.

6. Route your I/O combo and Ethernet cables along the routing guide poles to form drip

loops.

EN-5

English

7. Secure the bracket to wall.

15cm

8. Remove the cable gland from the LAN port. If I/O wires

or 24V power are preferred, use the T20 L-wrench to

remove the top cover on the I/O connectors.

T20

The cable length hanging on the out-

side of the bracket should be 15cm

IMPORTANT:

Make sure all waterproof cable glands have

been properly installed. Water leakage will

cause irrepairable damage to the camera.

EN-6

9. Hook up the safety wire between the bracket and the camera.

4.3 ~ 6.4mm

10. Install the components of the waterproof cable gland to the Ethernet and I/O com-

bo cables.

The outer jacket

of the combo

cable is ush with

cabling hole.

EN-7

English

11. Connect the I/O wire headers to camera and then secure the top cover.

T20

12. Connect the Ethernet cable (along with its cable gland) to the camera.

NOTE:

To disconnect a LAN cable, loosen the cable

gland and pull the cable against the socket

wall towards the side of the locking tab.

EN-8

13. Install the camera to bracket by aligning the mark on bracket with the #1 marking

on the camera.

14. Turn the camera clockwise. The camera should be locked in place.

15. Secure the connection using the T25 L-wrench from

the top.

T25

EN-9

English

16. Open the dome cover using the T20 L-wrench. Install a microSD card, and replace

the desiccant bag on the inner side of camera chassis.

icro

T20

17. Remove the foam blocks in the chassis, and the front and rear of the lens module.

Also remove the plastic sheet from the inside of the dome cover.

18. When done, secure the dome cover

using the T20 L-wrench.

Andere Handbücher für SD9361-EHL

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Vivotek Sicherheitskamera Handbücher

Vivotek

Vivotek FD8371EV Bedienungsanleitung

Vivotek

Vivotek IP32133 Bedienungsanleitung

Vivotek

Vivotek FD8136 Bedienungsanleitung

Vivotek

Vivotek NetworKam IP3111 Bedienungsanleitung

Vivotek

Vivotek FD8171 Bedienungsanleitung

Vivotek

Vivotek IP8371E Bedienungsanleitung

Vivotek

Vivotek PT1111M Bedienungsanleitung

Vivotek

Vivotek IP8172 Bedienungsanleitung

Vivotek

Vivotek IP7142 Bedienungsanleitung

Vivotek

Vivotek FD8154 Bedienungsanleitung

Vivotek

Vivotek FD7132 Bedienungsanleitung

Vivotek

Vivotek IB8156-C Bedienungsanleitung

Vivotek

Vivotek ip8364-c Bedienungsanleitung

Vivotek

Vivotek IP8330 Bedienungsanleitung

Vivotek

Vivotek FD8171 Bedienungsanleitung

Vivotek

Vivotek SD7313 Bedienungsanleitung

Vivotek

Vivotek FD8154 Bedienungsanleitung

Vivotek

Vivotek sd6112v Bedienungsanleitung

Vivotek

Vivotek IP6114 Bedienungsanleitung

Vivotek

Vivotek Supreme SD8363E-M Bedienungsanleitung

Vivotek

Vivotek IB9387-HT-A Bedienungsanleitung

Vivotek

Vivotek IP8332-C Bedienungsanleitung

Vivotek

Vivotek IP8371 Bedienungsanleitung

Vivotek

Vivotek FD8163 Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung

Lumens

Lumens VC-A50PNW Bedienungsanleitung