VIZpin Solar Kit Bedienungsanleitung
Solar Kit Instructions
V 011719
VIZpin.com +1 717-327-4244
The VIZpin Solar Kit includes:
Solar Panel
Solar Panel
Mounting Bracket
12VDC Lock/Latch
Cable
VIZpin 12VDC
Lock/Latch
Controller
Solar Panel Cable
Environmental
Enclosure Mounting
Hardware
Solar Panel Mounting
Hardware
Battery Backup
Battery Velcro
Cable Tie-wraps
Environmental
Enclosure
Solar Controller
Battery Cables
Liquid-tight fittings
Solar Kit Instructions
V 011719
VIZpin.com +1 717-327-4244
How to install it:
1. Safely mount the environmental enclosure to a sturdy fence or pole. When possible, do not
mount it in direct sunlight. Each installation has unique requirements or codes, and may require
additional mounting hardware to ensure compliance.
2. Safely mount the solar panel to a sturdy fence or pole. The solar panel should remain clear of
shade and facing true south.
The unit is designed to operate continuously
with 3 hours of direct sunlight each day. This is based on
100 activations/day of a 12VDC lock/latch with a
maximum of 250mA and each activation < 3 seconds.
VIZpin
Solar
Kit
+
12 VDC
Lock/Latch
-
Solar Kit Instructions
V 011719
VIZpin.com +1 717-327-4244
1. If the existing grommeted cable openings will not be used, create new openings by removing
knockouts on the environmental enclosure. Install liquid-tight fittings as per local requirements
and codes.
2. Uncoil the solar panel cable (red tape and zip ties) and feed it through the appropriate opening
of the environmental enclosure
3. Connect the red wire of the solar panel cable to the (+) side of the solar panel
4. Connect the black wire of the solar panel cable to the (-) side of the solar panel
5. Uncoil the 12VDC lock/latch cable (yellow tape and zip ties) and feed it throug the appropriate
opening of the environmental enclosure
6. Connect the red wire of the 12VDC lock/latch cable to the (+) side of the lock/latch
7. Connect the black wire of the 12VDC lock/latch cable to the (-) side of the lock/latch
Solar Panel (-)
Solar Panel (+)
Solar Kit Instructions
V 011719
VIZpin.com +1 717-327-4244
8. While keeping the cables out of the way, peel off the front of the battery Velcro and slide the
battery back along the bottom shelf of the environmental enclosure until it is pressed firmly
against the battery Velcro
9. Connect the red battery cable to the (+) side of the battery, and the black battery cable to the (-)
side of the battery
10. Confirm that the VIZpin controller LED is pulsing red
Battery Velcro
Red Battery Cable
Black Battery Cable
VIZpin Controller LED
Inhaltsverzeichnis
Andere VIZpin IP-Zugriffskontrollsysteme Handbücher
