5
English
- Do Not position this product too close to draperies because
they may be drawn into the rear grill, cutting off airflow.
- Use this circulator only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
- Operate this circulator only in its upright position.
-Do Not use this circulator on a circuit that has a variable speed
device operating, such as a blender or a variable speed fan.
User Servicing Instructions
Grasp plug and remove from the receptacle or other outlet de-
vice. Do not unplug by pulling on cord. Open fuse cover (A.) by
sliding access cover on top of attachment plug towards blades.
Remove fuse carefully (B.) by gently prying out the ends of the
fuse from the receptacle. Risk of fire. Replace fuse only with 2.5
Amp, 125 Volt fuse. Contact Vornado customer service for re-
placement fuse. Phone: 1-800-234-0604, email:
support@vornadobaby.com
Install replacement fuse (C.) by first placing the end of the fuse
into the fuse receptacle which is opposite of the blades of the
plug, then carefully push in the other end. Only push against the
metal end of the fuse, not the glass center portion. Close the fuse
access cover (D.) by sliding the cover back into the plug until it is
completely closed, latches and is flush with the face of the plug.
Risk of fire. Do not replace attachment plug. Contains a safety
device (fuse, AFCI, LCDI) that should not be removed. Discard
product if the attachment plug is damaged.
Note: This equipment has been tested and found to comply with
the limits for Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the re-
ceiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) his device must accept
any interference received, including interference that may cause
undesired operation.
Industry Canada ICES-003 Compliance: CAN ICES-3
(B)/NMB-3(B)
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
READ AND SAVE THESE INSTRUCTIONS
A. B. C. D.
