INSTALLATION INSTRUCTIONS
3-Circuit Recessed Flanged Track System
Model: WT1M/2M/3M-RT-2
Headquarters
44 Harbor Park Drive, Port Washington, NY
Phone (516) 515.5000 •Fax (516) 515.5050
www.waclighting.com
WAC Lighting (Shanghai)
14 Lane 299, Bi Sheng Road Shanghai 201204
Phone (86.21) 3393.3558 •Fax (86.21) 3362.1598
www.waclighting.com.cn
WAC Lighting - International sales
Room 3207-3208, Building 4,Tian An Cloud Park,
ShenZhen, Guangdong 518129
www.waclighting.io
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. April 22, 2019 1 / 6
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
•Read all of these instructions before installing the track system.
•Turn off power at main switch before installing or modifying the system.
•Do not install within 15cm of any curtain or combustible materials.
•Do not install less than 1.5m above a floor.
•Do not install in damp or wet locations.
•Do not install concealed, or extended through building walls.
•Do not attempt to energize anything other than a track light fixture.
•Do not connect a track to more than one branch circuit. Although track light system may seem to operate
acceptably, a dangerous overload of the neutral may occur and result in a risk of fire.
•System is intended for installation by a qualified electrician in accordance with the National Electrical Code
and local regulations.
•All of the installations shall be in accordance with NEC and all local codes.
•Save these installation instructions and refer to them when additions or changes to the track configuration are
made.
MOUNTING OPTIONS
Surface mounting or suspension mounting can be selected according to different environments.
Do not fasten the track to the ceiling until all electrical connections have been installed.
A. Surface Recessed mounting
Ceiling Opening: 40±3mm
A1. Mounting slots can be knocked out and are
spaced every 12 inches for convenience.
A2. Option A: Hang track from the surface using
toggle bolts (included).
