wallas 3008 Bedienungsanleitung
3008
CONTROL PANEL
Cable can be connected in surface mount or trough hole.
SURFACE : HOLE: Cable connection.
Please note that cable
connector release pin is as in
picture, when connecting cable
into panel.
(there is silent click sound when
connected)
Cable release.
Press connector release clip.
see in picture , before pulling the
cable off.
Install assembly plate. Pre
drill 3*1 mm holes for screws.
Cut the cable opening in
bottom of the panel.
Slide the panel in place top-
down.
Remove display protection
tape.
Install assembly plate. Pre
drill 3*1 mm holes for
screws.
Drill 12 mm hole for cable .
Slide the panel in place
top-down.
Remove display protection
tape.
95 mm
min. 15 mm
Free space for assembly
36 mm
Andere Handbücher für 3008
4
Andere wallas Bedienfeld Handbücher
wallas
wallas 3008 Bedienungsanleitung
wallas
wallas 85 DT Bedienungsanleitung
wallas
wallas 3008 Bedienungsanleitung
wallas
wallas 3007 Bedienungsanleitung
wallas
wallas PI Thermo Bedienungsanleitung
wallas
wallas 3008 Bedienungsanleitung
wallas
wallas PI Bedienungsanleitung
wallas
wallas 3008 Bedienungsanleitung
