Holiday Mode: Hold down the rotary button for 3 seconds, select the button to enter holiday mode. Select your
preferred days, and temperature and pressing the rotary button to confirm each selection. The temperature range is
between 5~15
℃
(default 10
℃
). Holiday mode can be cancelled by pressing .
Evening-Saving Mode: Hold down the rotary button for 3 seconds, rotate the button to select the option to enter
the evening-saving mode. Rotate the button to set the preferred temperature (default 17 degrees), press the button
to confirm the selection and when returning to the last interface, it will skip the next setting icon automatically.
Comfort Mode: When entering the mode selection, rotate the dial to choose and press the rotary button to select
comfort mode. The temperature can be adjusted (default 17 degrees) to suit and by pressing the rotary button it will
automatically skip the last interface option .
Receiver Comments:
◼Power light: Green light illuminated
Signal Light: Orange light within 10s after the power comes on (matching IP). The signal light turns off when it matches with the
controller. The orange light will blink within 10s when the power turns off.
◼Fault/load light: Red light
◼IP connection is faulty (IP: FFFF). This red light will blink 2 times (0.25 seconds spacing).
◼This light will blink 3 times when it does not receive wireless signal for 1 hour (0.25 seconds spacing).
This light will blink 4 times when the external sensor is faulty (0.25 seconds spacing).
External sensor temperature alarm for electric/water/underfloor heating:
①The detected temperature by external sensor is above the setting temperature of A5 (Advanced options), this will in turn
then trigger high temperature protection and will flash.
②Detected temperature by external sensor is below setting temperature of A6 (Advanced options). This will then trigger low
temperature protection and appear ,it will auto open relay to heat and the will reappear
Advanced One-Click Options: Hold down the rotary button for 3 seconds, enter the advanced option setting by
rotating the button to advanced , and press the dial.
