Important Regulatory and Safety Notices
Before using this product and any associated equipment, refer to the “Important Safety Instructions” listed
below so as to avoid personnel injury and to prevent product damage. Products may require specific
equipment, and /or installation procedures be carried out to satisfy certain regulatory compliance
requirements. Notices have been included in this publication to call attention to these Specific
requirements.
Symbols Meanings
This symbol on the equipment refers you to important operating and maintenance (servicing)
instructions within the Product Manual Documentation. Failure to heed this information may
present a major risk of damage or injury to persons or equipment.
The symbol with the word “Warning” within the equipment manual indicates a potentially
hazardous situation, which if not avoided, could result in death or serious injury.
The symbol with the word “Caution” within the equipment manual indicates a potentially
hazardous situation, which if not avoided, may result in minor or moderate injury. It may also be
used to alert against unsafe practices.
The symbol with the word “Notice” within the equipment manual indicates a situation, which if not
avoided, may result in major or minor equipment damage or a situation which could place the
equipment in a non-compliant operating state.
This symbol is used to alert the user that an electrical or electronic device or assembly is
susceptible to damage from an ESD event.
Important Safety Instructions
This product is intended to be a component product of the openGear 8000 series frame. Refer to the
openGear 8000 series frame User Manual for important safety instructions regarding the proper
installation and safe operation of the frame as well as it’s component products.
Certain parts of this equipment namely the power supply area still present a safety hazard, with the
power switch in the OFF position. To avoid electrical shock, disconnect all A/C power cords from the
chassis' rear appliance connectors before servicing this area.
Service barriers within this product are intended to protect the operator and service personnel from
hazardous voltages. For continued safety, replace all barriers after any servicing.
This product contains safety critical parts, which if incorrectly replaced may present a risk of fire or
electrical shock. Components contained within the product’s power supplies and power supply area,
are not intended to be customer serviced and should be returned to the factory for repair.
To reduce the risk of fire, replacement fuses must be the same type and rating.
Only use attachments/accessories specified by the manufacturer.
