INSTALLATION:
Shut off the power.
Firstly, screw the middle part with the sensor part together, check the right figure, ( this part is
screwed when leaving factory)
Unscrew the beside of the middle part, and install the gimbals’ base in the ceiling or other place
where you want to install, fasten the sensor part (first step in here) with the base,
screw and fix the sensor part to base.
Connect the power and load together according to the following figure.
Switch on the power and test it.
DIAGRAMĂDE CONECTARE
TEST:
After installation, Turned LUX knob clockwise to the maximum (SUN position). Turned time knob anti-
clockwise to the minimum (-).
Turn on the power, the sensor will be electrify and warm-up, 30 sec later, the item will be entered into
working estate.
5~10 seconds after the light goes out for the first time and then sensing, the load should be worked.
Turns LUX knob anti-clockwise to the minimum. If it is tested under the circumstance below 3LUX, load
should not work after induction load stop working; but if you cover the detection window with opaque
objects (towel etc), the load works. Under the condition of no induction signals, the load should stop
working within 5-15 sec.
NOTED: When testing in Daylight, please turn LUX knob to (SUN) position, otherwise, the sensor
will not induce and make the light bright.
NOTE:
Should be installed by electrician or experienced man. Avoid installing it on the unrest objects.
There shouldn’t be hindrance and moving object in front of the detection window effecting detection.
Avoid installing it near air temperature alteration zones such as air condition, central heating, etc.
