WhereSafe XTracker Solar Manual
How WhereSafe and your XTracker Solar Work
1. With the WhereSafe GPS Tracking service plan, the XTracker Solar updates every 2 minutes when moving. It goes into standby mode
when no movement is detected and updates once every 24 hours.
2. The battery has a standby time of approximately 4 years (based on a full charge). It is rechargeable using the included charging
cable and wall charger, solar panel, and optional trickle charging cable.
3. During charging, the RED LED light will be on solid. When the battery is fully charged, the RED LED light will turn off. The estimated
charging time for a depleted battery is 12 hours.
4. Download the WhereSafe app (download for free from the App Store or Google Play Store) and create an account. You will be
prompted to Activate your device. If you already have an account, login to your app and click “Activate Device”, and follow the
instructions.
5. Change email, phone number and notification delivery type (Email, SMS/Push) from Account Settings, and setup your preferred
notifications:
NightWatch –Get alerts when vehicle movement is detected within a timeframe you define.
RideMonitor –Get speeding, harsh braking and acceleration alerts.
SafetyNet –Choose your city and get notified when the device enters or leaves that area.
TamperGuard –Get instant notifications when your device is disconnected.
Turning the XTracker Solar ON and OFF
The XTracker Solar can be turned on and off by using the included magnetic power pawn. It can be used by holding the pawn over the power
sensor location (see image below).
1. CHECK STATUS: You can check to see if the device is ON or OFF by tapping the
power pawn to the sensor location for 1 second (or less). If the device is ON,
the blue LED will blink twice. If the device is currently off, the red LED will blink
twice.
2. TO TURN ON DEVICE: Place the magnetic Power Pawn on the power sensor
location and hold it there for 3-5 seconds. The red LED will flash 3 times, and
then the blue LED will flash one time once it makes a network connection. This
device is now ON.
3. TO TURN OFF DEVICE: Place the magnetic Power Pawn on the power sensor
location and hold it there for 3-5 seconds. The blue LED will flash 2 times, then
the red LED will flash 15 times. This device is now OFF.
