Whirlpool EveryDrop EDRD101G1W Bedienungsanleitung

USE & CARE GUIDE

WATER

DISPENSER

TABLE OF CONTENTS

WARNING

DANGER

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your

appliance. Always read and obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to potential hazards that can kill or hurt

you and others.

All safety messages will follow the safety alert symbol and either

the word “DANGER” or “WARNING.”

These words mean:

You can be killed or seriously injured if

you don’t immediately follow instructions.

You can be killed or seriously injured if

you don’t follow instructions.

All safety messages will tell you what the potential hazard is, tell you how to

reduce the chance of injury, and tell you what can happen if the instructions

are not followed.

NOTE: In accordance with guidelines from the American Heart Association,

as with many products containing magnets, it is recommended that those with

implantable pacemakers/debrillators should use care and keep their device

12 inches away from the dispenser.

INTRODUCTION 4–7

Get to know your new Water Dispenser

INSTALLATION 8–18

Prepare for installation

Overview

Step-by-step instructions

USE 19–21

Get freshly ﬁltered water on demand

Important information about your ﬁlter

Learn about the EveryDrop™ ﬁlter subscription service

Winterize your Water Dispenser

CARE 22–25

Replace your ﬁlter every six months

Troubleshoot potential problems

WARRANTY 26-27

PERFORMANCE DATA SHEET 28

Watch our step-by-step installation video online at

bit.ly/edwdispenserhowto.

GET TO KNOW YOUR EVERYDROPTM WATER DISPENSER

INTRODUCTION

FILTER ACCESS DOOR

FILTER

LOCK/UNLOCK

KNOB* WATER LINE

SPOUT ON/OFF

BUTTON

WATER SPOUT

DRIP TRAY

TUBING HOLDERS

REPLACEMENT FILTER

WELCOME TO A NEW WAY TO WATER

Reﬁlling bulky pitchers, rethinking shelf space, and being concerned about

contaminants are all behind you. Now you’re ready to enjoy a steady stream

of clean water at the push of a button. Let’s get started.

*Locking the knob turns on the ﬂow of water from your water supply to the ﬁlter.

Unlocking the knob turns the ﬂow o.

IMPORTANT

• Plumbing must be installed in accordance with the International

Plumbing Code and any local codes and ordinances.

• Copper and PEX tubing connections from the household water line to

the refrigerator are acceptable and will help avoid o-taste or o-odor

water and ice. Check for leaks.

• If PEX tubing is used instead of copper, we recommend the following part

numbers: W10505928RP (7 ft. [2.14 m]) and W10267701RP (25 ft. [7.62 m] PEX).

• Install tubing only in areas where temperature will remain above freezing.

WATER SUPPLY REQUIREMENTS

A cold water supply with water pressure between 30 and 120 psi

(207 and 827 kPa) is required to operate the Water Dispenser and ice maker.

The maximum operating water temperature is 100° F (38° C).

If the water pressure is less than what is required, the ﬂow of water from

the Water Dispenser could decrease or ice cubes could be hollow

or irregularly shaped.

If you have questions about your water pressure, call a licensed, qualiﬁed plumber.

TOOLS THAT MAY BE NEEDED BASED ON

INSTALLATION REQUIREMENTS

Gather the required tools and parts before starting installation.

The required tools may vary, depending on your speciﬁc installation

requirements.

• Flat-blade screwdriver

• Pliers

• 2 adjustable wrenches

• Bucket

• Towel

NOTE: Do not use a piercing-type or 3/16"(4.76 mm) saddle valve, which

reduces water ﬂow and can clog more easily.

INTRODUCTION

PREPARING FOR INSTALLATION

1. Clean refrigerator surface using a mild dish detergent solution. Dry

thoroughly to avoid water spots.

• Wash refrigerator exterior with a clean, soft cloth or sponge and

a mild detergent in warm water. Rinse surface with clean, warm

water. (NOTE: If your refrigerator is stainless steel, always wipe

in the direction of the grain to avoid cross-grain scratching.)

2. You will need two adjustable wrenches and one pair of pliers

for tightening.

3. You will need a towel and a bucket for excess water.

INSTALLATION

INSTALLATION OVERVIEW

There are two tubes attached to your Water Dispenser. The house line

connects to your house’s cold water supply. If you have an ice maker, the

dispenser’s refrigerator line connects to your refrigerator. You will need to

remove the cap from the end of the tube to connect it to your refrigerator.

REFRIGERATOR CONNECTION HOUSE CONNECTION

WATER DISPENSER

MAGNETIC TUBE HOLDER

Excessive Weight Hazard

Use two or more people to

move and install refrigerator.

Failure to do so can result in

back or other injury.

Electrical Shock Hazard

Disconnect power

before servicing.

Replace all parts and panels

before operating.

Failure to follow these

instructions can result in

death or electrical shock.

OFF

10 11

INSTALLATION

MOVE AND UNPLUG REFRIGERATOR

Slide the refrigerator out so

you can access the water

connections behind it. Then,

unplug the refrigerator

power cord.

NOTE:

Your refrigerator is heavy. When moving

the refrigerator for cleaning or service,

be sure to cover the ﬂoor with cardboard

or hardboard to avoid ﬂoor damage.

Always pull the refrigerator straight out

when moving it. Do not wiggle or “walk”

the refrigerator when trying to move it,

as ﬂoor damage could occur.

3DISCONNECT WATER LINE

Disconnect the water line

that is running between your

refrigerator and the house at

the refrigerator end.

2SHUT OFF WATER

If your refrigerator does not

have an ice maker, skip ahead

to step 5.

If your refrigerator does

have an ice maker, ﬁnd

the water shut-o valve

for your house’s water line

and turn o your water.

IMPORTANT: Turn the water

back on before plugging your

refrigerator back in.

12 13

INSTALLATION

EMPTY WATER LINE

4MOUNT DISPENSER

5MOUNT TUBING

Empty any excess water that

may be in the water line tube

into a bucket.

Route the dispenser’s tubing

through the prongs on the

back of the unit and place the

dispenser on the front or side

of your refrigerator with its

integrated magnets. If hanging

on the front, mount the

dispenser 2–3 inches from the

hinge side to allow the tubing

to move freely within the

Tubing Holders on the side.

Mount the two Tubing Holders

to the side of the refrigerator

and run the tubing through

the holder—do this prior to

making any water connections.

Mount the holders 2–3 inches from

the front and back of refrigerator.

BACK OF

WATER DISPENSER

14 15

CONNECT TO REFRIGERATOR

If you don’t have an ice maker,

skip this step. Simply leave

the cap on the dispenser’s

refrigerator line and move on

to step 9.

If your refrigerator has an ice

maker, remove the cap from

the end of the dispenser’s

refrigerator line and connect

the line to your refrigerator.

Hand-tighten the nut, then use

a wrench to give it a half-turn.

Be careful not to overtighten the

nut, and avoid kinks in the line.

INSTALLATION

CONNECT TO WATER SUPPLY

Disconnect the old hose from

your house water line and

replace it with the dispenser’s

house water line. Use your

hand to tighten the nut,

then use a wrench to give

it a half-turn.

WATER LINE PARTS

A. Sleeve

B. Nut

C. Copper tubing

(to refrigerator)

D. Household supply

line (1/2"min.)

CONNECTION POINT

A. Compression

sleeve

B. Compression

nut

C. Copper tubing

HOSE

A. Copper tubing

B. P-clamp

C. Compression nut

D. Compression sleeve

Excessive Weight Hazard

Use two or more people to

move and install refrigerator.

Failure to do so can result in

back or other injury.

Electrical Shock Hazard

Disconnect power

before servicing.

Replace all parts and panels

before operating.

Failure to follow these

instructions can result in

death or electrical shock.

16 17

TURN WATER ON

Turn your house’s water back

on. Make sure water isn’t

leaking anywhere. If it is,

check the connections and

tighten if necessary.

INSTALLATION

PLUG IN REFRIGERATOR

AND MOVE IT BACK

Plug the refrigerator power

cord back into the outlet

and slide the refrigerator

back into place.

NOTE:

Your refrigerator is heavy. When moving

the refrigerator for cleaning or service,

be sure to cover the ﬂoor with cardboard

or hardboard to avoid ﬂoor damage.

Always pull the refrigerator straight out

when moving it. Do not wiggle or “walk”

the refrigerator when trying to move it,

as ﬂoor damage could occur.

MINUTES

(4 Gallons)

18 19

FLUSH FILTER

Your EveryDrop™ Water

Dispenser is now ready to use.

Enjoy great-tasting ﬁltered

water at the push of a button.

INSTALLATION

12 ENJOY

USE

HOW TO USE THE PRODUCT

The purpose of the EveryDropTM Water Dispenser is to deliver ﬁltered tap

water when and where you want it. The built-in magnet allows you to attach

the dispenser anywhere on the magnetic surface of your refrigerator.

The EveryDropTM Water Dispenser includes a pull-out Drip Tray that is intended

to catch any drips. The Drip Tray is not intended to support a glass or container.

To use the Water Dispenser, place a glass or container under the Spout.

With your other hand, press the Spout On/O Button to dispense the water.

Continue pressing the button until your glass or container has the amount

of water you would like. Release the button to stop the water ﬂow. Rated

service ﬂow is 0.5 gpm (1.89 lpm).

NOTE: The Spout On/O Button is harder to push when water pressure is

applied. For the best experience, press along the raised line on the button face.

NOTE: The Filter Lock/Unlock Knob also controls the water valve. Locking the

knob turns on the ﬂow of water from your water supply to the ﬁlter. Unlocking

the knob turns the ﬂow o.

Hold a bucket under the Spout.

Press and hold the Spout

On/O Button for a total of

eight minutes, emptying your

bucket when necessary. This

will ﬂush out your ﬁlter. Repeat

this process every time you

replace your water ﬁlter.

Inhaltsverzeichnis

Andere Whirlpool Wasserspender Handbücher

Whirlpool

Whirlpool UKF7003 Bedienungsanleitung

Whirlpool

Whirlpool 8LIECH-SCDSSFWL Bedienungsanleitung

Whirlpool

Whirlpool HD1000XSC7 Handbuch

Whirlpool

Whirlpool HD1000JS Service-Handbuch

Whirlpool

Whirlpool 8171413 Bedienungsanleitung

Whirlpool

Whirlpool WHES40 Bedienungsanleitung

Whirlpool

Whirlpool WHES20 Bedienungsanleitung

Whirlpool

Whirlpool 8LIECH-SC-SSS-5L-W Bedienungsanleitung

Whirlpool

Whirlpool WHED20 Bedienungsanleitung

Whirlpool

Whirlpool WHES40 Bedienungsanleitung

Whirlpool

Whirlpool WHES48 Bedienungsanleitung

Whirlpool

Whirlpool WHES48 Bedienungsanleitung

Whirlpool

Whirlpool WHER25 Bedienungsanleitung

Whirlpool

Whirlpool 7LIECK-W-WL Bedienungsanleitung

Whirlpool

Whirlpool WHES3T Bedienungsanleitung

Whirlpool

Whirlpool WHES40 Bedienungsanleitung

Whirlpool

Whirlpool WHES18 Bedienungs- und Montageanleitung

Whirlpool

Whirlpool WHES20 Bedienungsanleitung

Whirlpool

Whirlpool WDAB600XWX Bedienungsanleitung

Whirlpool

Whirlpool WHESCS Bedienungsanleitung

Whirlpool

Whirlpool L30P Bedienungsanleitung

Whirlpool

Whirlpool 8LIECH-SCSSFP5W Bedienungsanleitung

Whirlpool

Whirlpool W10295370 Bedienungsanleitung

Whirlpool

Whirlpool WHES40 Bedienungsanleitung

Beliebte Wasserspender Handbücher anderer Marken

Monarch Water

Monarch Water ULTIMATE MINI AQUA HE Bedienungsanleitung

Haier

Haier HLM-109B Bedienungsanleitung

abc

abc Fleck 5600SXT Bedienungsanleitung

GE GXOF18G Betriebsanleitung

Kenmore

Kenmore 625.385560 UltraFilter 650 Bedienungsanleitung

Innova

Innova CEV+ Kurzanleitung

Aries

Aries Hydra DI Handbuch

GE GNCF02H Bedienungsanleitung

ProFlo

ProFlo PFB Series Bedienungsanleitung

A.O. Smith

A.O. Smith FREZYA 300S Bedienungsanleitung

Frakco

Frakco Travelsoft RV 2400HD Bedienungsanleitung

Avanti

Avanti WD31EC Bedienungsanleitung

Avanti

Avanti WD360 Bedienungsanleitung

BRIO

BRIO CLCTTL520 Benutzerhandbuch

3M HCD-1 Bedienungsanleitung

Elkay

Elkay EFHFA8_2CJO Installationshandbuch

Coway

Coway CHP-671L Bedienungsanleitung

Aqua Essentials

Aqua Essentials Borg & Overström B4 Bedienungsanleitung