page 8
Location Trigger Flextime
1. Press the enter button while Trig-
ger is selected. The highlighted
option will be blinking.
2.Press the left or right navigation
button to move to different op-
tions. Press the enter button to
save the setting.
TRIGGER:
PIR MODE: Takes a photo only when the PIR
sensor is triggered.
FLEXTIME(Time Lapse): Takes time lapse images
at set intervals during the key movement pe-
riods of the day, depending on your Flextime
settings.
BOTH: Both PIR and Flextime are active.
This setting allows you to choose the mode in
which the camera will be capturing images. 1. Press the enter button while Flex-
time is selected. The highlighted
option will be blinking.
2.Press the left or right navigation
button to move to different op-
tions. Press the enter button to
save the setting.
The Interval setting is set by the Delay Set-
ting on the camera with a 1 minute minimum
Flextime delay. See chart on the next page for
Flextime options.
NOTE: Camera needs at least 48 hours in the
field to acclimate to the environment for Flex-
time to function properly.
Reminder: Only use “Flextime” and “Both”
modes if you are wanting to use time lapse
technology. These modes can reduce battery
life versus the standard “PIR” mode.
POWERENTER
UP
LEFTRIGHT
DOWN
POWERENTER
UP
LEFTRIGHT
DOWN
POWERENTER
UP
LEFTRIGHT
DOWN
POWERENTER
UP
LEFTRIGHT
DOWN
