Winegard RD-9146 Bedienungsanleitung

WINEGARD ®

46 cm Portable Satellite System

Models RD-9046/RD-9146

UNPACKING/ASSEMBLY

After unpacking the system, verify that you have a level,

compass (attached to base), and 25 feet of coax. If you

do not, call Winegard Company at 1-800-288-8094

between the hours of 8:00 a.m. and 4:00 p.m. central

time, Monday through Friday.

SAVE THE CARTON. This carton is designed to be

reused to store your system in when not in use.

Signal from satellite

24° look angle

Antenna Reflector at 90°

ANTENNA/MOUNT

MADE IN U.S.A.

U.S. Patents 5,532,710

& 5,646,638

OPERATION

STEP 1. Connect coax from LNBF to receiver. If

additional cable length is required, use a high grade

RG-6/U type foam cable suitable for satellite signal and

an FS-8100 cable splice.

STEP 2. Plug in the receiver and TV.

STEP 3. Turn TV and receiver ON.

STEP 4. Tune TV to ch. 3 or 4 (to the same channel as

the output on the receiver.)

STEP 5. Determine azimuth (direction) and elevation

required for your position. Refer to receiver manual.

STEP 6. Loosen clamp knobs. Elevate reflector to the

correct elevation. Align degree of elevation required

with front of the slide bracket. Each mark indicates 5

degrees of elevation with the first mark being 00 (mark

closest to compass/level). See Figures 1 and 2. Tighten

clamp knobs.

STEP 7. Level base using bubble level recessed into

the base.

STEP 8. Using compass recessed into base, rotate

the base slowly (3oincrements) to the desired azimuth

(direction) for the high power satellites. The signal is

digital, you must wait a few seconds after each move to

allow the receiver to process the signal.

NOTE: Disregard the compass markings, the red

compass needle always points North. Rotate the

base so that the other end of the needle points at the

correct heading (direction) on the antenna base. DO

NOT USE THE DEGREE MARKINGS ON THE

COMPASS.

NOTE: If you have the unit sitting on a tailgate or on

other metal items, it is recommended that you remove

the compass from the base and stand away (15'

min.) to find the correct azimuth. Compass is

attached to base with velcro.

STEP 9. Adjust azimuth (direction) and elevation (up/

down) for strongest signal.

NOTE: If you do not get a picture, check the following:

1. Make sure antenna has clear view of the high

power satellites, no buildings, trees, etc.

blocking the view.

2. Make sure coax connections are good.

3. Check coax for breaks, crimps, cuts etc.

4. If base is not level, you will have to adjust the

elevation to compensate.

5. Check that TV is tuned to correct channel.

CAUTION: DO NOT DROP SYSTEM. IF ANTENNA IS

DAMAGED, IT WILL REDUCE THE GAIN (HOW MUCH

SIGNAL THE ANTENNA SENDS TO THE RECEIVER)

OF THE ANTENNA. THIS CAN RESULT IN A

DEGRADED PICTURE.

FIGURE 4

Coil Coax

Around

Clips

Reflector

FIGURE 1 Point Towards Satellite

Use Front of Slide

Bracket for Proper

Degree of Elevation

Required. Unit shown

at 50o.

Clamp Knobs

0 Degrees Elevation

(Next Mark Indicates 50)

LNBF

FIGURE 2

Reflector Support

Post

FIGURE 3

Use Front of Slide

Bracket for Proper

Degree of Elevation

Required. Unit shown

at 60o.

RETURNINGANTENNATOTRAVELPOSITION

STEP 1. Turn receiver and TV OFF.

STEP 2. Disconnect coax from receiver.

STEP 3. Loosen clamp knobs and put antenna in

travel position. See Figure 3.

STEP 4. Coil coax under base. See Figure 4.

NOTE: The carton the system came in is designed

to be reused. It is suggested that you store your

system in it when not in use.

NOTE: When ready to use antenna again, you must

uncoil the coax before raising antenna. The antenna

will not raise if the coax is coiled up under the base.

TOP VIEW

How To Hook A Satellite System To A RV Cable Input

Satellite Receiver

RD-9046 Portable

Satellite System

WINEGARD MOBILE PRODUCTS LIMITED WARRANTY

(2 YEARS PARTS; 1 YEAR LABOR)

Winegard Company warrants this product against defects in materials or workmanship for a period of two (2) years from the date of original purchase. During year one (1) of such

warranty, Winegard Company will also pay authorized labor costs to an authorized Winegard dealer to repair or replace defective products. No warranty claim will be honored unless

at the time the claim is made, Customer presents proof of purchase to an authorized Winegard dealer (to locate the nearest authorized Winegard dealer, contact Winegard Company,

3000 Kirkwood Street, Burlington, Iowa 52601, Telephone 800-288-8094 or visit www.winegard.com). Customer must provide proof of purchase with a dated sales receipt for the

Winegard product to verify the product is under warranty. If the date of purchase cannot be verified, the warranty period shall be considered to begin thirty (30) days after the date of

manufacture.

If a defect in material or workmanship is discovered, Customer may take the product to an authorized Winegard dealer for service. Customer must provide proof of purchase to

verify the product is under warranty. If the product is brought to an authorized Winegard dealer for service prior to expiration of year one (1) of the warranty period and a defect in

material or workmanship is verified by Winegard Technical Services, Winegard Company will cover the Winegard dealer’s labor charges for warranty service. The Winegard dealer

must contact Winegard Technical Services in advance for pre-approval of the service. Approval of the service is at the sole discretion of Winegard Company.

Alternatively, Customer may ship the product prepaid to Winegard Technical Services (located at 3111 Kirkwood Street, Burlington, Iowa 52601, Telephone 800-788-4417).

Customer must return the product along with a brief description of the problem and provide Winegard Technical Services with Customer’s name, address, and phone number.

Customer must also provide proof of purchase to verify the product is under warranty. If the product is returned before the expiration of the warranty period, Winegard Company will

(at its option) either repair or replace the product.

This Limited Warranty does not apply if the product has been damaged, deteriorates, malfunctions or fails from: improper installation, misuse, abuse, neglect, accident, tampering,

modification of the product as originally manufactured by Winegard in any manner whatsoever, removing or defacing any serial number, usage not in accordance with product

instructions or acts of nature such as damage caused by wind, lightning, ice or corrosive environments such as salt spray and acid rain.

RETURN AUTHORIZATION POLICY

A Return Material Authorization (RMA) is required prior to returning any product to Winegard Company or Winegard Warranty Services under this warranty policy. Please call our

Technical Services Department at 800-788-4417 or send an e-mail to [email protected] to obtain the RMA number. Please furnish the date of purchase when requesting an

RMA number. Enclose the product in a prepaid package and write the RMA number in large, clear letters on the outside of the package. To avoid confusion or misunderstanding, a

shipment(s) without an RMA number(s) or an unauthorized return(s) will be refused and returned to Customer freight collect.

WINEGARD COMPANY DOES NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BY ANY OTHER PERSON.

ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORYINCLUDING WARRANTIES OF FITNESS FORAPARTICULAR PURPOSE AND MERCHANTABILITY

ARE LIMITED TO THE TWO YEAR PERIOD OF THIS WARRANTY.

In states that do not allow limitations on implied warranties, or the exclusion of limitation of incidental or consequential damages, the above limitations or exclusions do not apply.

Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of limitation of incidental or consequential damages, so the above limitations or

exclusions may not apply to you.

This warranty gives Customer specific legal rights. Customer may also have other rights that may vary from state to state.

SATELLITE RECEIVER WARRANTY:

See manufacturer’s limited warranty policy.

Rev. 2/08

2200816

Base

(2) 2240021

Rubber Bumper

2160691

0.312 x 2.91

Round Head Pin

2160692

0.312 x 3.36

Round Head Pin

2780258

Level

(2) 2200096

Clamp Knob

ANTENNA EXPLODED PARTS VIEW

Below is the exploded parts view for the 46 cm portable

satellite system. If you require a replacement part, call

Winegard Company at 1-800-288-8094 between the

hours of 8:00 a.m. and 4:00 p.m central time, Monday

through Friday. Credit card orders only.

(5) 2160027

5/16" Washer

(2) 2745048

Pivot Link

2200921

Reflector Bracket 2780190

LNBF

2753065

25' Coax

2745307

46 cm Reflector, White

(4) 2160361

5/16-18 x 5/8" Flat Head Bolt

(4) 2160230

5/16-18 Hex Nut

(4) 2160690

0.312 x 0.660

Round Head Pin

2780257

Compass

2160821

Spring (not shown)

3201818

Slide W/Inserts

(6) 2160696

E-Clip Retainer

RECEIVER WARRANTY

Receiver is warranted by the manufacturer. See

instruction manual packed with receiver for warranty

information. DO NOT SEND receiver to Winegard

Company; it will be returned you. Only Echostar

receivers will be accepted and ONLY from dealers.

Printed in U.S.A. Winegard Company, 3000 Kirkwood St., Burlington, IA 52601-2000 319/754-0600 FAX 319/754-0787 © Winegard Company 2006 2451148 Rev 2/08

2744846

FEED SUPPORT

ARM

2160353

1/4-20 X 1.25 LONG

CARRIAGE BOLT

2160220

1/4-20

HEX NYLOCK NUT

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Winegard Antenne Handbücher

Winegard

Winegard YA-6260 Bedienungsanleitung

Winegard

Winegard TRAV'LER SHAW DIRECT SK-7003 Bedienungsanleitung

Winegard

Winegard Sensar HV CC-10HV Bedienungsanleitung

Winegard

Winegard Movin' View MV3500A Bedienungsanleitung

Winegard

Winegard Rayzar.Air RVRZ25W Bedienungsanleitung

Winegard

Winegard WX980 Bedienungsanleitung

Winegard

Winegard YA-7000 Bedienungsanleitung

Winegard

Winegard HD-8800 Bedienungsanleitung

Winegard

Winegard AS-2003 Betriebsanleitung

Winegard

Winegard Movin' View MV-0099 Bedienungsanleitung

Winegard

Winegard TRAV’LER DISH 1000 Bedienungsanleitung

Winegard

Winegard TR-6100 Bedienungsanleitung

Winegard

Winegard MA1000W Bedienungsanleitung

Winegard

Winegard In-Motion MVT-35W Bedienungsanleitung

Winegard

Winegard Prostar 1000 PR-7010 Bedienungsanleitung

Winegard

Winegard SENSAR III ANTENNA Bedienungsanleitung

Winegard

Winegard HD7082P Bedienungsanleitung

Winegard

Winegard HD-6000 Bedienungsanleitung

Winegard

Winegard DS-4248 Bedienungsanleitung

Winegard

Winegard MA1000W Bedienungsanleitung

Winegard

Winegard Sensar HV Bedienungsanleitung

Winegard

Winegard Movin' View MV3535A Bedienungsanleitung

Winegard

Winegard Freevision FV-HD30 Bedienungsanleitung

Winegard

Winegard HD6055P Bedienungsanleitung

Beliebte Antenne Handbücher anderer Marken

Alfa Network

Alfa Network APA-L01 Bedienungsanleitung

Naval

Naval PR-422CA Bedienungsanleitung

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Bedienungsanleitung

TERK Technologies

TERK Technologies TV44 Bedienungsanleitung

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Bedienungsanleitung

HP J8999A Bedienungsanleitung

MobilSat

MobilSat MSP-S Bedienungsanleitung

Steren

Steren ANT-UHF 13 Bedienungsanleitung

Novatel

Novatel 600-G Bedienungsanleitung

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Bedienungsanleitung

TRENDnet

TRENDnet TEW-AO12O Bedienungsanleitung

Radio Shack

Radio Shack 15-1837 Bedienungsanleitung

CommScope

CommScope CMAX-OMFX-43M-I53 Bedienungsanleitung

Ramsey Electronics

Ramsey Electronics DAP25 Bedienungsanleitung

COBHAM

COBHAM SAILOR 800 VSAT Gebrauchs- und Pflegehandbuch

Trango Systems

Trango Systems AD900-9 Bedienungsanleitung

Steren

Steren ANT-100 Bedienungsanleitung

Proxim

Proxim 5054-PA-23 Bedienungsanleitung