Q5: Why the local network connection is choppy after the AP installation?
A5: Shoot the trouble with below methods:
1. Change the cable to see if it is acable problem
2. Change the wireless channel to avoid the signal interference.
logging.
Q2: How does the AP work without power supply?
A2: The AP gets the power via the cable. It is called POE. Two cables are needed for the connection. STP
CAT5e cable is strongly recommended for this case.
Q3: How long the POE cable can be?
A3: The length of the cable depends on the power voltage and cable quality. For 24V power, the length of
the cable can be 40 meters, while 10-20 meters for 12 power.
Q4: Why the signal light does not work after switching the button?
A4: Please turn off the AP power first. It is recommended to do the troubleshooting test as below. For the
transmitter, keep the button from “1” to “10” UP. For the receiver, keep the button “1” DOWN, and the
button from “2” to “10” UP. After finishing, turn on the power and wait for three minutes. The distance
between the transmitter and the receiver should be more than 2meters.
