Xylem Laing Thermotech ecocirc E Series Bedienungsanleitung

INSTRUCTION MANUAL

6-71-075-108

REVISION A

ecocirc®E Series E10 Bronze Pumps

Xylem Inc.

3878 S. Willow, Suite 104

Fresno, CA 93725

Tel: (559) 265-4730 (800) 554-6853

Fax: (559) 265-4740 (800) 453-7523

www.xyleminc.com/brands/laingthermotech

Laing Thermotech is a trademark of Xylem Inc. or one of its subsidiaries.

Symptom LED Sequence Code LED Sequence

Code Error Possible Causes Corrective Action*

Intermittent Operation

1x Long, 4x Short

1x Long, 3x Short, 1x Long

1x Long, 2x Short, 1x Long, 1x Short

1X Long, 2x Short, 2x Long

1x Long, 1x Short, 1x Long, 2x Short

1x Long, 1x Short, 1x Long, 1x Short, 1x Long

Run Error #1

Run Error #2

Run Error #3

Run Error #4

Run Error #5

Run Error #6

1. Improperly Wired

2. Foreign object in impeller and housing

3. Overheated pump electronics

1. Check Motor wiring diagram

2. Disassemble pump, remove object, and clean

motor separating wall and impeller

3. Disconnect the power to the pump and let

the pump cooled down to ambient room

temperature. Check the ﬂuid’s temperature for

proper setting.

Pump will not prime 1x Long, 1x Short, 2x Long, 1x Short Dry-Run Error

1 . Leak, Obstruction, or kink in suction line

2 . Suction line closed

3. Pump is worn

1. Repair as necessary.

2. Open,then reset the pump by unplugging power

to the pump

3. Replace parts.

Little or no discharge Solid Light No Error

1. Housing not ﬁlled with water

2. Suction piping too small

3. Total head too high

4. Impeller plugged

1. Properly prime housing

2. Increase to pump inlet size or one size larger

3. Reduce discharge head

4. Disassemble pump and clean motor separating

wall and impeller

Noisy pump operation Solid Light No Error

1. Air trapped in housing

2. Rotor bearing worn

3. Debris in housing

1. Check pump prime,also turn pump on and off

several times to bump air pocket out of pump

2. Replace rotor assembly

3. Dissemble pump and remove debris

No Operation No Light Not Powered 1. Blown Fuse or open circuit breaker

2. Loose or broken wiring

1. Replace fuse or circuit breaker after reason for

overload has been corrected

2. Tighten connections,repair wiring

Trouble Shooting Chart

LED Indicator: Solid green LED indicates pump is powered and functioning properly. If ﬂashing green LED please follow the

Corrective Actions for the errors below.

* If the LED sequence code continues after all corrective actions have been veriﬁed and applied, please contact your representative

for assistance and report the run error sequence when the pump is returned for a warranty replacement.

Dieses Handbuch passt für folgende Modelle

Andere Xylem Wasserpumpe Handbücher

Xylem

Xylem Jabsco 15170 Series Bedienungsanleitung

Xylem

Xylem GSP0311 Bedienungsanleitung

Xylem

Xylem JABSCO Ballast SuperKing Bedienungsanleitung

Xylem

Xylem Goulds Marlow Series Bedienungsanleitung

Xylem

Xylem Lowara Z8 Series Bedienungsanleitung

Xylem

Xylem Ai1 Series Bedienungsanleitung

Xylem

Xylem LOWARA Sekamatik 408 Series Bedienungsanleitung

Xylem

Xylem Lowara LSB Series Handbuch

Xylem

Xylem Bell & Gossett Domestic 616PF Bedienungsanleitung

Xylem

Xylem JABSCO 2620 Series Bedienungsanleitung

Xylem

Xylem Bell & Gossett 60 Series Bedienungsanleitung

Xylem

Xylem GOULDS WEHT0311M Handbuch

Xylem

Xylem GOULDS e-SVE Series Bedienungsanleitung

Xylem

Xylem Bell & Gossett TECHNOForce e-HV Series Bedienungsanleitung

Xylem

Xylem Flygt 2400 Bedienungsanleitung

Xylem

Xylem rule Tournament 401C Handbuch

Xylem

Xylem rule LoPro 4708856181 Bedienungsanleitung

Xylem

Xylem FLYGT P7030 Series Bedienungsanleitung

Xylem

Xylem LOWARA e-SHE Series Bedienungsanleitung

Xylem

Xylem GOULDS e-SVI Series Bedienungsanleitung

Xylem

Xylem Lowara GHV Bedienungsanleitung

Xylem

Xylem Goulds MPVN Series Bedienungsanleitung

Xylem

Xylem JABSCO 6400 Series Bedienungsanleitung

Xylem

Xylem JABSCO 777 Series Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

moyno

moyno 2000 CC Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung