Installation of the alarm unit
Glass Plastic Wood
1. Mount the alarm unit standing vertically or lying
horizontally according to the picture. The GPS signal
passes normally through wood, plastic and glass but
not solid metal. Try to place the alarm unit in an open
environment to get a strong GPS signal. The GPS
signal also gets stronger with fewer layers of materials.
If the alarm is used in a metal boat the alarm unit
should be placed close to a window. Also note that
computers and transformer may jam the GPS signal.
If you don’t get any GPS reception with the app, or if
the app often shows an old position, then the alarm
unit has to be moved. However, note that it may take
several hours to get the GPS position for the rst time
when the alarm is new.
2. Connect the alarm unit to a voltage source (red cable
= positive, black cable = ground). See more information
below regarding the white cable.
+ 12 / 24volt (GPS alarm version HW003):
White conductor output extends to ground when
active. Load max 3A at the output, it will turn o at high
load / current. Fuse the feed to the load. If load current
exceeds 1A, a relay on output between output and load
should be used.When connecting a siren, red cable goes
to red and black cable to the white on the G32.
Red conductor, fuse alarm, 3A.
Black leader, ground. Out 0V
+12/24 VDC
0V/Ground
Connect fuse,
see info above
Technical specications
Size:
Weight:
Temperature:
External supply (VDC):
Power consumption:
GSM/GPS antennas:
GSM band:
Internal battery:
Enclosure:
Tracking time on
internal battery:
Alarm detection on
internal battery:
Additions or adjustments to this manual can be found at
www.yachtsafe.se under the Manuals tab.
74x48x28 mm
150 g
-30 to +70°C*
12-24 V
2 or 7 mA
built-in
850/900/1800/1900
2 Ah
IP68
up to 2 weeks
up to 3 months
(Up to 3 months applies when activating low power function.
The function is set via the remote control. Please note: when
the alarm is set to low power mode, it is not possible to com-
municate with the alarm via the app or by SMS commands. The
alarm returns to normal mode in case of Sabotage or Movement
alarm and an SMS will be sent to the alarm receiver.)
