6 808081NZ v1.00 03.21 Industrial Tap Instructions
1Top Touch Tap Font Installation
Font Installation (optional)
Industrial Top
Touch Tap
Black plastic
spacer
Font
Spacer ring
under Font
Benchtop
Steel washer
Spider clamp
Fixing nut
• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
tap hoses and USB cable.
• Cut the holes as shown in the template.
• Apply a light smearing of silicone
sealant on the underside of the spacer
under the Font. Locate the spacer
under the Font base.
• Pass the tubes and USB cable through
the hole and use a tube spanner to
secure the tap in place.
• Position the Font template (provided
in the kit) on the bench, so that the
Command Centre is within reach of the
tap hoses and USB cable.
• Cut the holes as shown in the template.
• Apply a light smearing of silicone sealant
on the underside of the spacer under the
Font. Locate the spacer under the Font
base.
• From below the bench, feed the three
tubes and USB cable through the clamp
block, noting the orientation marker.
• Fit the 3 cap screws and spring
washers. Tighten with an allen key.
• Use a tube spanner to secure the fixing nut.
2Side Touch Tap Font installation Industrial Side
Touch Tap -
Tapered base
O-ring seal
Font
Spacer ring
under font
Benchtop
Clamp block
Spring washer
Fixing nut
Cap screws x3
