ZyXEL Communications M-202 Bedienungsanleitung

ZyXEL M-202

XtremeMIMO 802.11b/g Wireless USB Adapter

Quick Start Guide

Version 1.0

February 2006

ZyXEL M-202 Quick Start Guide

Important Information

Federal Communications Commission (FCC) Interference Statement

The 802.11g Wireless LAN Adapter has been tested to the FCC exposure

requirements (Specific Absorption Rate).

The equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment, under 47 CFR 2.1093 paragraph (d) (2).

This Transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

Refer to the User's Guide for general FCC statements.

Procedure to View a Product's Certification(s)

1.Go to www.us.zyxel.com

2.Select your product from the drop-down list box on the ZyXEL home page to

go to that product's page.

3.Select the certification you wish to view from this page.

ZyXEL M-202 Quick Start Guide

About Your ZyXELM-202

The ZyXEL M-202 is an IEEE 802.11 b/g compliant wireless LAN USB stick that

fits into any USB slot. With the ZyXEL M-202, you can enjoy the wireless mobility

within the coverage area. The ZyXEL XtremeMIMO technology provides greater

range and offers transmission rate at up to 54 Mbps. Actual speeds attained also

depend on the distance from the AP, noise, etc.

1. Installation Requirements

Before installation, make sure you have a computer with the following:

• Pentium II 300MHz or above

• A minimum of 20 MB available hard disk space

• 32MB RAM (64MB Recommended)

• A CD-ROM drive

• A USB port (with USB1.0/1.1, the ZyXEL M-202 can only transmit up to

11Mbps.)

• Windows XP or 2000 Operating Systems

Windows XP Users

Wireless Zero Configuration (WZC) is a wireless configuration utility bundled with

Windows XP. If you are a Windows XP user and wish to use WZC instead of the

bundled ZyXEL Utility, then you can either:

Install the ZyXEL Utility and then disable it (selecting

“Use Windows Zero Configuration” by first right clicking

ZyXEL M-202 Quick Start Guide

the Z icon in the system tray)

Install the driver only. In this case, you must connect the ZyXEL M-202 first.

2. ZyXEL Utility and Hardware Installation

The installation procedures are similar for all supported Windows versions.

Windows XP screen shots are shown unless otherwise specified.

! Install the ZyXEL Utility before you install the ZyXEL

M-202.

1. Insert the support CD into the CD-ROM drive on your computer. The CD

automatically runs. Otherwise, locate and double-click setup.exe on the

support CD.

2. Click Setup to start installation.

ZyXEL M-202 Quick Start Guide

3. A Welcome screen displays.

Click Next.

4. To install ZyXEL Utility, select

Utility and Driver checkbox.

Click Next to accept the default

file location or click Browse to

select an alternate folder.

ZyXEL M-202 Quick Start Guide

5. Click the Install button to begin

the installation.

6. Click Finish to restart the

computer.

7. Insert your ZyXEL M-202 into an available USB port on the computer by

using the provided USB cable.

8. The LEDs will turn on if the ZyXEL M-202 is properly inserted.

ZyXEL M-202 Quick Start Guide

! Never bend, force or twist the ZyXEL M-202 USB cable

into the slot.

9. After you install the ZyXEL Utility and insert the ZyXEL

M-202, an ZyXEL icon appears in the system tray.

10. Double click the Z icon to configure your wireless adapter.

3. Driver Installation for Windows XP

1. Insert the ZyXEL M-202 to an available USB port on

the computer. The LINK LED turns on if the ZyXEL

M-202 is properly inserted.

2. The Found New Hardware

Wizard window appears.

Select Install from a list of

specific location (Advanced)

and click Next.

ZyXEL M-202 Quick Start Guide

3. Insert the included CD into your

CD-ROM drive, select Search

removable media (floppy, CD-

ROM…) and then click Next.

4. After the driver has been installed successfully, click Finish to complete the

installation.

! Refer to the User’s Guide to configure the ZyXEL M-202.

ZyXEL M-202 Quick Start Guide

4. LED Display

Right Antenna LED

Center Antenna LED

Left Antenna LED

Link LED

The following table describes the LEDs on the ZyXEL M-202.

LED / COLOR LEDS BEHAVIOR

ON The Antenna Right is active

Right Antenna

Green OFF The Antenna Right is inactive

ON The Antenna Center is active

Center Antenna

Green OFF The Antenna Center is inactive

ON The Antenna Left is active

Left Antenna

Green OFF The Antenna Left is inactive

ZyXEL M-202 Quick Start Guide

LED / COLOR LEDS BEHAVIOR

ON The M-202 is powered or M-202 is

wirelessly associated with an AP/Router

Blinking

Slowly Wireless connection is not associated

with any AP/Router

LINK LINK

Green

Blinking

Quickly The M-202 is receiving or sending data

Andere Handbücher für M-202

Inhaltsverzeichnis

Andere ZyXEL Communications Adapter Handbücher

ZyXEL Communications

ZyXEL Communications PLA-470 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Powerline Ethernet Multiplug Center PLA491 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications AG-225H Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications G-202 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyAIR G-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL NWD2105 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4201 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA6457 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NWD2705 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications AG-120 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NWD2705 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA450 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications FN-300 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NWD210N Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications AG-220 Referenzhandbuch

ZyXEL Communications

ZyXEL Communications PLA-4 series Firmware Detection Tool Release... Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GN600 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4101 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA5215 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications NWD2205 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyAIR B-420 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA4205 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL ZyAIR B-220 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA6457 Bedienungsanleitung

Beliebte Adapter Handbücher anderer Marken

PCB Piezotronics

PCB Piezotronics 090B274 Bedienungsanleitung

Auvidea

Auvidea J20 Produkthandbuch

Gossen MetraWatt

Gossen MetraWatt AT3-III E Bedienungsanleitung

Akribis

Akribis ITF-21-BISS-MIT Bedienungsanleitung

Tenda

Tenda W54U Bedienungsanleitung

ROHO

ROHO AGILITY Bedienungsanleitung

PROLiNK

PROLiNK WN2001 Bedienungsanleitung

Hawking

Hawking HUF2 Bedienungsanleitung

Airlink101

Airlink101 AWLC4030 Bedienungsanleitung

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Bedienungsanleitung

Philips

Philips SWA4554S/10 Bedienungsanleitung

JVC

JVC TS-C9D2B Gebrauchsanweisung

NETGEAR

NETGEAR A6100 Bedienungsanleitung

D-Link

D-Link DWA-121 Bedienungsanleitung

Philips

Philips SWA2037 Bedienungsanleitung

Basalte

Basalte 0610-20 Bedienungsanleitung

Yealink

Yealink EHS40 Bedienungsanleitung

Balluff

Balluff BIC 1B0-IT1A7-Q40KFU-SM4A4A Bedienungsanleitung