ZyXEL Communications GS-105A Bedienungsanleitung

GS-105/GS-108

Gigabit Switch

User’s Guide

Version 1.0

April 2003

GS-105/GS-108 Gigabit Switch

iii

Interference Statements and Warnings

FCC Interference Statement

This device complies with Part 15 of the FCC rules. Operation is subject

to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including

interference that may cause undesired operations.

FCC Warning

This equipment has been tested and found to comply with the limits for a

Class A digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely

to cause harmful interference in which case the user will be required to

correct the interference at his own expense.

CE Mark Warning

This is a class A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

Taiwanese BSMI (Bureau of Standards,

Metrology and Inspection) A Warning

Certifications

Refer to the product

page at

www.zyxel.com.

GS-105/GS-108 Gigabit Switch

ZyXEL Limited Warranty

ZyXEL warrants to the original end user (purchaser) that this product is

free from any defects in materials or workmanship for a period of up to

two (2) years from the date of purchase. During the warranty period and

upon proof of purchase, should the product have indications of failure due

to faulty workmanship and/or materials, ZyXEL will, at its discretion,

repair or replace the defective products or components without charge for

either parts or labor and to whatever extent it shall deem necessary to

restore the product or components to proper operating condition. Any

replacement will consist of a new or re-manufactured functionally

equivalent product of equal value, and will be solely at the discretion of

ZyXEL. This warranty shall not apply if the product is modified, misused,

tampered with, damaged by an act of God, or subjected to abnormal

working conditions.

Note

Repair or replacement, as provided under this warranty, is the exclusive

remedy of the purchaser. This warranty is in lieu of all other warranties,

express or implied, including any implied warranty of merchantability or

fitness for a particular use or purpose. ZyXEL shall in no event be held

liable for indirect or consequential damages of any kind of character to the

purchaser.

To obtain the services of this warranty, contact ZyXEL's Service Center

for your Return Material Authorization number (RMA). Products must be

returned Postage Prepaid. It is recommended that the unit be insured when

shipped. Any returned products without proof of purchase or those with an

out-dated warranty will be repaired or replaced (at the discretion of

ZyXEL) and the customer will be billed for parts and labor. All repaired

or replaced products will be shipped by ZyXEL to the corresponding

return address, Postage Paid. This warranty gives you specific legal rights,

and you may also have other rights that vary from country to country.

GS-105/GS-108 Gigabit Switch

Getting to Know Your Switch

Introduction

The switch is a multi-port switch that can be used to build high-

performance switched networks. The switch is a store-and-forward device

that offers low latency for high-speed networking. The switch is designed

for SOHO (Small Office Home Office) businesses.

Standalone Workgroup Application

The switch can be used as a standalone switch to which computers, servers

and print server are directly connected to form a small workgroup.

Standalone Workgroup Example

Hardware Installation and Connection

The switch is suitable for an office environment where it can be placed on

a desktop.

GS-105/GS-108 Gigabit Switch

Desktop Installation

Step 1. Make sure the switch is clean and dry.

Step 2. Set the switch on a smooth, level flat space strong enough to

support the weight of the switch and the connected cables.

Make sure there is a power outlet nearby.

Step 3. Use the supplied power adapter to connect your switch to a

power source. Refer to the label on the power adapter for more

information.

Do not block the ventilation holes.

Rear Panel Power Connection

Connect one end of the supplied power adaptor to the power port on the

rear panel of the switch and the other end to the appropriate power source.

The PWR LED turns on.

Port Connection

For GS-105, the Ethernet ports are located on the rear panel. For GS-108,

the Ethernet ports are located on the front panel.

Figure 1 Rear Panel: GS-108

Figure 2 Rear Panel: GS-105

GS-105/GS-108 Gigabit Switch

RJ-45 Auto-negotiating Ports

Your switch comes with 5 or 8 10/100/1000M RJ-45 ports depending on

the model of your switch. The auto-negotiation feature allows the switch

to detect the speed of incoming transmission and adjust appropriately

without manual intervention. It allows data transfers of 10 Mbps, 100

Mbps or 1000 Mbps in either half-duplex or full-duplex mode depending

on your Ethernet network.

Auto-sensing (MDI/MDIX) Ethernet Ports

Each Ethernet port allows you to connect to a computer or to a hub using

either a straight-through or a crossover Ethernet cable.

The following table describes the types of network cable used for the

different connection speeds.

Table 1 Ethernet Cable Type

SPEED NETWORK CABLE TYPE

10 Base-T 100Ω2-pair UTP/STP Category 3, 4 or 5

100 Base-TX 100Ω2-pair UTP/STP Category 5

1000 Base-T 100Ω4-pair UTP/STP Category 5

Cable length between connections must not

exceed 100 meters (328 feet).

Front Panel LEDs

The LEDs on the front panel indicate the real-time status of the switch.

Figure 3 Front Panel LED: GS-108

The following table gives descriptions of the LEDs.

GS-105/GS-108 Gigabit Switch

Table 2 Front Panel LED Descriptions

LED COLOR STATUS DESCRIPTION

PWR Green On The switch is on and receiving power.

Off The switch is not receiving power.

100/1000 Green On The port is operating at 1000Mbps.

Off The port is operating at 10Mbps or no device is attached.

Orange On The port is operating at 100Mbps.

Off The port is operating at 10Mbps or no device is attached.

LNK/ACT Green On The port is connected to an Ethernet network.

Off The port is not connected to an Ethernet network.

Blinking The port is receiving or transmitting data.

Orange On The port is operating in full-duplex mode.

Blinking Packet collision occurred on this port.

FDX/COL

Off The port is operating in half-duplex mode or no Ethernet

device is connected to this port.

Andere Handbücher für GS-105A

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ZyXEL Communications Schalten Handbücher

ZyXEL Communications

ZyXEL Communications Dimension ES-3024 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications MS-7206 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ES-105E Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GS1350 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications XGS1010-12 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ES-305 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ES1100-16 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Dimension ES-108A Referenzhandbuch

ZyXEL Communications

ZyXEL Communications GS1910 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications XGS1250-12 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ES-315 - V3.70 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications XGS4700 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications XGS-4728F Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications MGS3700-12C Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications Dimension GS-3012F Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GS-1116A Handbuch

ZyXEL Communications

ZyXEL Communications Dimension GS-3012F Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications XS3800-28 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GS3700 Series Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications ZyXEL Dimension GS-1008 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GS-2724 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PoE-80 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications PLA5456 Bedienungsanleitung

ZyXEL Communications

ZyXEL Communications GS2210-8 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung