Adaptec AFM-600 Bedienungsanleitung

Installation Instructions

Adaptec Flash Backup Module AFM-600 for Adaptec Unified Serial™RAID Controllers

some jurisdictions.

Part Number: MAN-00260-01-A Rev B

Using the appropriate static protection, remove the controller from your computer.

1Insert screws through the bottom of the controller board, as shown in Figure 1.

Then, insert spacers on the screws.

2Attach the AFM-600DB (daughterboard) to the controller by mating the two black

connectors. Affix a hex nut to the end of each of the screws, as shown in Figure 2.

Caution: The torque should be less than 0.06Nm to avoid deformation. Do not use a

tool to hold the nut in place to avoid damaging the semi-conductor components on the

daughterboard near the screw holes. Be sure that the controller is not bent after

attaching the daughterboard to the controller card.

3Attach the AFM-600CC supercapacitor module to the controller by inserting the

connector into the socket on the AFM-600DB, as shown in Figure 3. The connector

attaches to the socket in only one direction.

4Choose a location on the chassis or in the system to fix the tethered supercapacitor

module using the included cable-ties such that (i) the cable (18.5") reaches the

mating location on the controller when it is installed in the expansion slot;

(ii) wiring is routed and secured so that it does not contact any moving parts (fans,

for instance); and (iii) the supercapacitor module is protected from heat.

5Thread the cable-ties through the slots on the supercapacitor module and fix to the

selected location on the computer chassis. The cable-ties should completely encircle the supercapacitor module to ensure that it is held

in place securely, as shown in Figure 4. Be careful not to restrict air-flow in your system.

6Reinstall the controller, and restart your computer.

7The supercapacitor starts charging automatically. It should reach full charge in 3-4 minutes.

Warning: (i) Do NOT remove or insert a fully charged supercapacitor module. Always discharge the unit first to avoid damage to the controller or

flash backup module. The factory ships with discharged units, so they are safe to install when you receive them. To ensure that an installed unit

is discharged, switch the system OFF, then wait 5 minutes. After a dirty shutdown, wait 3 minutes after backup is complete, then remove the

unit. (ii) There is a risk of explosion if the supercapacitor module is replaced by an incorrect type.

Figure 1 Figure 2

Spacers

Figure 3 Figure 4

Supercapacitor module

Inhaltsverzeichnis

Andere Adaptec Computerhardware Handbücher

Adaptec

Adaptec FireWire 1394 Bedienungsanleitung

Adaptec

Adaptec PM3754U2 Bedienungsanleitung

Adaptec

Adaptec RAID 2405Q Bedienungsanleitung

Adaptec

Adaptec 2100S - SCSI RAID Controller Sicherheitsleitfaden

Adaptec

Adaptec AHA-2940 - SCSI Card Bedienungsanleitung

Adaptec

Adaptec CDP-00277-01-A Bedienungsanleitung

Adaptec

Adaptec DuraStor 6200S Bedienungsanleitung

Adaptec

Adaptec PowerDomain 29160 Bedienungsanleitung

Adaptec

Adaptec ACB-232XD Bedienungsanleitung

Adaptec

Adaptec RAID 2405 Bedienungsanleitung

Adaptec

Adaptec RAID Solutions Handbuch

Adaptec

Adaptec ACB-2370 Bedienungsanleitung

Adaptec

Adaptec RAID 5085 Bedienungsanleitung

Adaptec

Adaptec SATA RAID FOR ADAPTEC Bedienungsanleitung

Adaptec

Adaptec AAA-130SA SERIES Montageanleitung

Adaptec

Adaptec Serial Attached SCSI (SAS) Expander Card Bedienungsanleitung

Adaptec

Adaptec 1200A Bedienungsanleitung

Adaptec

Adaptec ARO-1130SA Montageanleitung

Adaptec

Adaptec PowerDomain 2940UW Bedienungsanleitung

Adaptec

Adaptec ACB-2320 Bedienungsanleitung

Adaptec

Adaptec RAID 6805Q Bedienungsanleitung

Adaptec

Adaptec RAID 5405Z Bedienungsanleitung

Adaptec

Adaptec AHA-1520 Bedienungsanleitung

Adaptec

Adaptec ACB-2370 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung