Advantech ICR-1601 Leitfaden
Start Guide
ICR-1601
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
Safety Instructions
Please take care to following instructions:
•Use the router in compliance with national and international law and in compliance with
any special or additional restrictions regulating use of the router in the various applica-
tions and environments.
•To avoid possible injury and/or damage to the device, observe the relevant provisions
and standards. Use only the original accessories as recommended. Unauthorized de-
vice or accessory modification, or using accessories that have not been approved can
result in router damage and/or violation of the regulations.
•Unauthorized device or accessory modification or using the accessories that have not
been approved can result in warranty termination.
•Do not open the router.
•Caution! The SIM card can be swallowed by small children.
•When connecting the device to a power supply do not exceed the defined voltage.
•Do not expose the router to extreme ambient conditions. Protect the router against dust,
moisture, and high temperature.
•It is recommended that you do not use the router at petrol filling stations. We recommend
observing local restrictions concerning the use of radio-based devices while working with
explosive material for example, at petrol filling stations, or in chemical plants.
•While using the router close to personal medical devices, such as cardiac pacemakers
or hearing aids, proceed with heightened caution.
•Operating the router too close to TV sets, radio receivers, personal computers, or tele-
phones can cause interference.
•It is recommended that you create a copy or backup of the important settings stored in
the memory of the router.
QSG-0005-EN, October 9, 2018 1Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
Product Disposal Instructions
The WEEE (Waste Electrical and Electronic Equipment: 2012/19/EU) direc-
tive has been introduced to ensure that electrical/electronic products are recy-
cled using the best available recovery techniques to minimize the impact on
the environment. This product contains high quality materials and components
which can be recycled. At the end of its life this product MUST NOT be mixed
with other commercial waste for disposal. Check with the terms and conditions
of your supplier for disposal information.
QSG-0005-EN, October 9, 2018 2Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
First Use
Before applying power to the router, connect the components that you required for your
applications. You cannot operate the router without connected antenna, inserted SIM card,
nor connected power supply.
If you do not have connected main antenna during operation of the router, the router can
be damaged!
1. Antenna
Use a SMA connector to connect the antennas to the router. The main antenna is con-
nected to the router by screwing on the ANT connector (see Figure below). The second diver-
sity antenna can also be connected to the DIV connector to improve performance.
2. SIM Card
The SIM card reader, for 3 V and 1.8 V SIM cards, is located on the front panel of the
router. If you intend to use this device to communicate over a cellular network, please place
an activated data-provisioned SIM card with an unblocked PIN into the SIM card reader. Push
your SIM card into the SIM1 or SIM2 slot until it clicks in place.
QSG-0005-EN, October 9, 2018 3Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
Before handling of the SIM card disconnect the router from power supply!
3. Power
The router requires an external DC power supply. The DC voltage required is between
+5 to +18 V DC. Please connect the power adapter DC 5 V/2 A to the PWR connector on the
panel of the router (see figure below).
QSG-0005-EN, October 9, 2018 4Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
4. Ethernet
An Ethernet cable may be connected to the LAN1 connector on the front panel (see Figure
above). By default, the Ethernet port is configured as follows:
Connector Purpose Default Setting
LAN1 LAN port (default)
Connect your laptop or PC to this port to
get a local web-server for device configu-
ration and diagnostics.
DHCP Server
IP Address: 192.168.1.1
NetMask: 255.255.255.0
Configuration
1. Configuring the Device Using the Web Browser
You can access the router for status monitoring, configuration, and administration after en-
tering the IP address of the router into the web interface. The default IP address is 192.168.1.1
(netmask 255.255.255.0). Configuration access is allowed for the user "admin" with the initial
password "admin". Attention, it is necessary to use HTTPS protocol for secure communication
over a network! For a detailed description and examples of the router configurations, see the
Configuration Manual.
2. Restoring and Backing up the Router Configuration
After you reset the router, the current configuration is overwritten by the default settings.
We recommend that you back up the router configuration before resetting the device. Refer to
the Configuration Manual for more information.
When the Status LED starts blinking, it is possible to restore the default configuration of the
router by pressing the Reset button on the panel continuously for 6 seconds. After pressing
this button, the default configuration is restored and then the router reboots.
After logging on to the device for the first time, we strongly recommend to change
the default password due to security reasons.
QSG-0005-EN, October 9, 2018 5Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Start Guide
Documentation
User’s Manual, Configuration Manual and manual for each expansion port can be found
and downloaded on this web site: www.advantech-bb.cz/download
Hereby, Advantech Co., Ltd. company declares that the radio equipment type
ICR-1601 is in compliance with EU Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following internet
address: www.advantech-bb.cz/eudoc
QSG-0005-EN, October 9, 2018 6Released in the Czech Republic
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
04-09-19
LUCOM GmbH — Flößaustr. 22a — 90763 Fürth — Tel.: +49 911/ 957 606 00 — E-Mail: [email protected] — www.lucom.de
www.lucom.de
Andere Handbücher für ICR-1601
2
Inhaltsverzeichnis
Andere Advantech Netzwerk-Router Handbücher
Advantech
Advantech ICR-2631 Bedienungsanleitung
Advantech
Advantech SmartFlex SR310 Bedienungsanleitung
Advantech
Advantech LR77 v2 Libratum Bedienungsanleitung
Advantech
Advantech ADAM-6520 Series Bedienungsanleitung
Advantech
Advantech Libratum ICR-2834 Bedienungsanleitung
Advantech
Advantech ICR-3831 Leitfaden
Advantech
Advantech ICR-2412 Bedienungsanleitung
Advantech
Advantech XR5i v2 Leitfaden
Advantech
Advantech EKI-4524I Bedienungsanleitung
Advantech
Advantech ICR-2531 Bedienungsanleitung
Advantech
Advantech ICR-2000 Leitfaden
Advantech
Advantech ICR-2041 Bedienungsanleitung
Advantech
Advantech ICR-2412 Bedienungsanleitung
Advantech
Advantech RR75i v2 Bedienungsanleitung
Advantech
Advantech B+B SmartWorx SmartMotion ST355 Bedienungsanleitung
Advantech
Advantech B+B Smartworx SEC510-2SFP-T Bedienungsanleitung
Advantech
Advantech ADAM-6520 Series Bedienungsanleitung
Advantech
Advantech ICR-3201 Series Bedienungsanleitung
Advantech
Advantech ICR-3231 Bedienungsanleitung
Advantech
Advantech SmartFlex SR304 Bedienungsanleitung
Beliebte Netzwerk-Router Handbücher anderer Marken
NETGEAR
NETGEAR FS526T - Switch Bedienungsanleitung
Korenix
Korenix JetNet 5710G Series Bedienungsanleitung
Automated Logic
Automated Logic ZN551 Betriebsanleitung
Cisco
Cisco ASR 1000 Series Bedienerhandbuch
EnGenius
EnGenius ESR-9710 Bedienungsanleitung
Cisco
Cisco 805 Series Bedienungs- und Sicherheitshinweise