4
INSPECTION AND STORAGE
At the time of receiving the equipment carefully cross check all the elements against the shipping documents in
order to ensure that all the crates and boxes have been received. Inspect all the units for any visible or hidden
damage.
In the event of shipping damage, write precise details of the damage on the shipper’s delivery note
and send immediately a registered letter to the shipper within 48 hours, clearly stating the damage
caused. Forward a copy of this letter to the manufacturer or his representative.
Never store or transport the unit upside down. It must be stored indoors, completely protected from rain, snow etc.
The unit must not be damaged by changes in the weather (high and low temperatures). Excessively high temperatures
(above 60 °C) can harm certain plastic materials and cause permanent damage.
WARRANTY
Any modification to the units without the manufacturer’s prior approval, shall automatically render the warranty
null and void.
The following conditions must be respected in order to maintain the validity of the warranty:
²Commissioning shall be performed by specialised technicians from technical services approved by
the manufacturer.
²Maintenance shall be performed by technicians trained for this purpose.
²Only Original Equipment spare parts shall be used.
²All the operations listed in the present manual shall be performed within the prescribed
SCHEDULE.
THE WARRANTY SHALL BE NULL AND VOID IN THE EVENT
OF NON-COMPLIANCE WITH ANY OF THE ABOVE CONDITIONS.
PRODUCT PRESENTATION
The buffer tank is required when the volume of water in the installation is insufficient for correct system operation.
It protects the PAC from the effects of short-cycling that would harm the compressors service life. It also improves
operation during de-icing phases.
This tank can be used as a mixing tank. In this case, the actual volume of water used in the installation is only 70
litres.
This tank is insulated with CFC-free polyurethane foam and is equipped with 4 water circuit connection points
(1"1/4) and a drain outlet (1"). The tank is intended only for floor-standing installation.
