Aiwa FR-A200EZ Bedienungsanleitung
d
FR-A200EZ
RADIO RECEIVER
WARNING
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR
MOISTURE.
OPERATING INSTRUCTIONS
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
PRECAUTIONS
Read the Operating Instructions carefully and completely
before operating the unit. Be sure to keep the Operating
Instructions for future reference. All warnings and cautions in
the Operating Instructions and on the unit should be strictly
followed, as well as the safety suggestions below.
Installation
1 Water and moisture — Do not use this unit near water,
such as near a bathtub, washbowl, swimming pool, or the
like.
2 Heat — Do not use this unit:
–near sources of heat, including heating vents, stoves, or
other appliances that generate heat
–in an area exposed to direct sunlight
–inside a parked car, where could be a considerable rise in
temperature.
3 Mounting surface — Place the unit on a flat, even surface.
4 Ventilation — The unit should be situated with adequate
space around it so that proper heat ventilation is assured.
Allow 10 cm clearance from the unit.
–Do not place the unit on a bed, rug, or similar surface that
may block the ventilation openings.
–Do not install the unit in a bookcase, cabinet, or airtight
rack where ventilation may be impeded.
5 Objects and liquid entry — Take care that objects or
liquids do not get inside the unit through the ventilation
openings.
6 Wall or ceiling mounting — The unit should not be
mounted on a wall or ceiling, unless specified in the
Operating Instructions.
2
English
PRECAUTIONS
Electric Power
1 Power sources — Connect this unit only to power sources
specified in the Operating Instructions, and as marked on
the unit.
2 AC power cord
–When disconnecting the power cord, pull it out by the AC
power plug.
Do not pull the cord itself.
–Never handle the AC power plug with wet hands, as this
could result in fire or shock.
–Do not walk on the power cord or pinch it by items placed
upon or against it, as these could result in fire or shock.
–Avoid overloading power sockets and extension cords
beyond their capacity, as this could result in fire or shock.
3 When not in use — Unplug the AC power cord from the
power socket if the unit will not be used for several months
or more. When the cord is plugged in, a small amount of
current continues to flow to the unit, even when the power is
turned off.
4
English
PRECAUTIONS
Damage Requiring Service
Have the units serviced by a qualified service technician if:
–The AC power cord or plug has been damaged
–Foreign objects or liquid have gotten inside the unit
–The unit has been exposed to rain or water
–The unit does not seem to operate normally
–The unit exhibits a marked change in performance
–The unit has been dropped, or the cabinet has been
damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
6
English
BACKUP FUNCTION
If the AC power supply is interrupted, the clock display goes
off and the alarm setting is canceled. To back up the clock and
alarm, insert a 6F22 battery in the battery compartment on the
rear of the unit.
• The backup battery is not for radio reception.
Note
The backup function lasts about 10 minutes. Set the clock
again if 10 minutes passed after a power interruption.
Replacing the battery
Replace the battery with new one if the clock display flashes or
the alarm timer does not work properly when you connect the
AC power cord again.
Note on battery
•
When you are not going to use the unit for a long period of time,
remove the battery to prevent possible electrolyte leakage.
• To prevent the risk of electrolyte leakage or explosions,
never recharge the battery, apply heat to it, or take it apart.
8
English
6F22
SETTING THE CLOCK →A
1 Connect the AC power cord to a wall outlet (a).
The clock display begins flashing.
2 While holding down CLOCK, press HOUR to set the
hour.
3 While holding down CLOCK, press MIN to set the
minute.
The clock starts running at “00” seconds.
To display the seconds, press SLEEP while holding down
ALARM.
The seconds are displayed while the buttons are pressed.
→B
bThe 1st digit of the minute
cSeconds
10
English
2,3
1
2
3
ALARM
SLEEP
A
B
RADIO RECEPTION
1 Set ALARM/POWER to ON.
2 Set BAND to select FM or AM.
3 Turn the TUNING control to tune in to a station.
4 Adjust the volume.
To turn off the radio
Set ALARM/POWER to nSTANDBY.
For better reception → A
FM: The AC cord functions as the FM antenna. Keep it
extended.
AM: Turn the unit to find the position which gives the best
reception.
12
English
3
4
2
1
AFM
AM
ALARM SETTING
The radio or buzzer automatically sounds at the designated
time every day.
1 While holding down ALARM, press HOUR or MIN to set
the alarm time.
2 Set ALARM/POWER to RADIO or BUZZER.
When the preset time comes, the radio or buzzer sounds.
To turn off the alarm, press ALARM or SNOOZE/SLEEP
OFF. When SNOOZE/SLEEP OFF is pressed, the buzzer will
automatically come on again after about 9 minutes.
To check the alarm time
Press ALARM. The alarm time will be displayed.
To change the alarm time
Set the alarm time again.
Listening to radio while the alarm is set
Set ALARM/POWER to ON. After listening, set the switch to
RADIO or BUZZER.
Note
• The radio or buzzer automatically turns off after about
2 hours.
• To cancel the alarm before the preset time comes, set
ALARM/POWER to nSTANDBY. The ALARM indicator (a)
goes out.
• The buzzer volume is fixed and cannot be set with the
VOLUME control.
14
English
1
2
1
1
SNOOZE/
SLEEP OFF
HOUR
MIN
ALARM
SLEEP TIMER SETTING
You can use the sleep timer to turn the radio off automatically
after up to 1 hour 59 minutes.
• Before setting, tune in to a station. (See page 12.)
1 Set ALARM/POWER to nSTANDBY.
2 While holding down SLEEP, press MIN to set the time to
turn off the radio.
To cancel the sleep timer, press SNOOZE/SLEEP OFF.
To set the time longer than 59 minutes
While holding down SLEEP, press HOUR once in step 2, then
press MIN.
To use both the sleep timer and the alarm
You can fall asleep listening to the radio and still be awakened
by the radio/buzzer alarm at a preset time.
1Set the alarm timer referring to steps 1 – 2 on page 14.
2While holding down SLEEP, press MIN to set the sleep
timer.
Note
You cannot check the remaining time of sleep timer.
16
English
2
12
SNOOZE/
SLEEP OFF
HOUR
MIN
SLEEP
SPECIFICATIONS
Power source AC 230 V, 50 Hz
Output 280 mW (EIAJ)
Power consumption 4 W
Speaker 57 mm, 8 ohms
Frequency range FM: 87.5 – 108 MHz
AM: 530 – 1,605 kHz
Antennas FM line antenna
Ferrite bar antenna for AM
Dimensions (W ×H ×D) 205 ×160 ×68 mm
(8 1/8×6 3/8×2 3/4in.)
Weight Approx. 680 g (1.5 lbs.)
• The specifications and external appearance are subject to
change without notice.
• Specifications, trade mark, model name and double square
symbol sare marked on the bottom of the unit.
Note
Keep cassette tapes, magnetic cards and other magnetically
recorded materials away from the speaker as the recorded
information may be erased or noise on cassette tapes may
occur.
To clean the cabinet
Use a soft cloth lightly moistened with a mild detergent
solution.
Do not use strong solvents, such as alcohol, benzine or
thinner.
18
English
Inhaltsverzeichnis
Andere Aiwa Empfänger Handbücher
Aiwa
Aiwa FR-DA400 Bedienungsanleitung
Aiwa
Aiwa FR-DA400 Bedienungsanleitung
Aiwa
Aiwa FR-A250UB Bedienungsanleitung
Aiwa
Aiwa FR-IC555 Bedienungsanleitung
Aiwa
Aiwa CR-DX501 Bedienungsanleitung
Aiwa
Aiwa CR-SP40 Bedienungsanleitung
Aiwa
Aiwa FR-A255 Bedienungsanleitung
Aiwa
Aiwa CR-AS18 Bedienungsanleitung
Aiwa
Aiwa CR-LD100 Bedienungsanleitung
Aiwa
Aiwa NSX-T9 Bedienungsanleitung
Aiwa
Aiwa FR-A250 Bedienungsanleitung
Aiwa
Aiwa AV-D57 Bedienungsanleitung
Aiwa
Aiwa FR-A45 Bedienungsanleitung
Aiwa
Aiwa FR-A705 Bedienungsanleitung
Aiwa
Aiwa CR-AS24 Bedienungsanleitung
Aiwa
Aiwa CR-LD100M2 Bedienungsanleitung
Aiwa
Aiwa FR-DAW450 Bedienungsanleitung
Aiwa
Aiwa NSX-T99 LH Bedienungsanleitung
Aiwa
Aiwa CR-IC90 Bedienungsanleitung
Aiwa
Aiwa FR-A255 Bedienungsanleitung
