Alarm Lock INSIDE BATTERY KIT Bedienungsanleitung

16. Make sure the Battery Connec-

tor Wire is routed through the

correct hole to meet up with the

center oval hole drilled in step 10.

INSIDE BATTERY KIT

INSTALLATION INSTRUCTIONS

WI1516 2/06

345 Bayview Avenue

Amityville, New York 11701

For Sales and Repairs 1-800-ALA-LOCK

For Technical Service 1-800-645-9440 © ALARM LOCK 2006 Publicly traded on NASDAQ Symbol: NSSC www.alarmlock.com

7. Secure the Bat-

tery Mounting

Bracket using the

top door mount-

ing screw that is

located away

from the edge of

the door.

6. Remove lock from door.

8. Using a center-

punch, mark two

holes for drilling:

•Mark the bottom

Bracket hole for

securing the

Mounting Bracket

(shown)

--and--

•Mark in the center

oval for routing the

remote battery

wires.

9. Use a #21 drill for

both the bottom

Bracket hole

(shown), and the

center oval.

11. Tap #10-32 threads into the bot-

tom Bracket hole drilled in step 9.

Now the lock's Rear Cover Plate

must be removed, as shown in step

12:

12. Remove the flat-head mounting

screws located at both ends of the

lock.

13. With the Rear Cover Plate

separated from the lock body,

find and disconnect the Battery

Pack Connector.

14. Battery Pack Connector wire is

glued in two locations (shown).

Carefully lift and remove wire from

glue to detach.

15. Replace the Rear Cover Plate.

Route the Battery Connector Wire

through the correct hole as shown

in step 16.

3. Unscrew four through-door

mounting screws (in two door

plates) that secure the lock to the

door.

2. Remove the decorative door

plate covers by sliding them up

from the door plates.

4. Remove Latch

Face Plate.

5. Deadbolt models only: Loosen

the interface cylinder set screw

(skip this step for springlatch

models).

Decorative door

plate covers

Door Plate

Some installations require the batteries powering the door lock be placed inside the protected premises. The following in-

structions describe how to install the Inside Battery Kit for your narrow stile door lock.

Set Screw

Bottom

Bracket Hole

1. Loosen the battery cover screw

and slide the battery cover off the

lock.

Battery Cover

Screw

Glue

Align the

Engager pin

and the

Driver hole

Mark

here

Battery

Connector

Wire

Battery Pack Connector

10. Enlarge the center

oval hole to 7/16".

This center oval hole

is the only hole that

must be drilled all the

way through the

door.

Note: Remove the

Battery Mounting

Bracket before

enlarging this hole.

Enlarge to 7/16"

Center Oval

continued

17. Replace all screws removed in

step 12, securing the Rear Cover

Plate.

18. From outside the door, route the

Battery Pack Connector wire through

the 7/16" center oval "through hole"

drilled in step 10.

22. Place the

battery pack

inside the

bracket. Be sure

the batteries are

fresh.

19. Use needle-nose pliers (or simi-

lar tool) to pull the plug through the

7/16" center oval "through hole"

drilled in step 10.

20. Secure the

through-door

mounting screw

(in its door plate),

further securing

the lock to the

door. Install its

decorative door

plate cover by

sliding it over the

door plate.

21. Replace the

Mounting Bracket

and secure with

both the through-

door mounting

screws and the

10-32 screw

(provided).

Connect the bat-

tery pack plug to

the battery wire.

23. Place the

battery cover

over the Battery

Mounting

Bracket using

the two screws

provided.

Door Plate

Battery

Wire

24. Be sure to use

the second bottom

screw to secure

cover.

Inhaltsverzeichnis

Andere Alarm Lock Sperren Handbücher

Alarm Lock

Alarm Lock Trilogy PDK3000 Series Installationshandbuch

Alarm Lock

Alarm Lock Trilogy PDL3500 Bedienungsanleitung

Alarm Lock

Alarm Lock TRILOGY DL2700 Bedienungsanleitung

Alarm Lock

Alarm Lock Trilogy DL3500 Bedienungsanleitung

Alarm Lock

Alarm Lock Trilogy DL3500 Bedienungsanleitung

Alarm Lock

Alarm Lock Trilogy ETDL Installationshandbuch

Alarm Lock

Alarm Lock PDL3300 Bedienungsanleitung

Alarm Lock

Alarm Lock TRILOGY DL2700 Bedienungsanleitung

Alarm Lock

Alarm Lock Networx DL1325NW Leitfaden

Alarm Lock

Alarm Lock Trilogy DL2700LD Installationshandbuch

Alarm Lock

Alarm Lock Trilogy DL1300 Installationshandbuch

Alarm Lock

Alarm Lock 700 SERIES Handbuch

Alarm Lock

Alarm Lock Trilogy DL4100 Series Addendum Installationshandbuch

Alarm Lock

Alarm Lock Trilogy DK3000 Series Installationshandbuch

Alarm Lock

Alarm Lock Trilogy PL3000 Installationshandbuch

Alarm Lock

Alarm Lock DL 2700WP Bedienungsanleitung

Alarm Lock

Alarm Lock DL2500-SERIES Bedienungsanleitung

Alarm Lock

Alarm Lock Trilogy PDL1300 Installationshandbuch

Alarm Lock

Alarm Lock Trilogy DL1200 Leitfaden

Alarm Lock

Alarm Lock DL6500 Installationshandbuch

Alarm Lock

Alarm Lock Trilogy PDL3500 Bedienungsanleitung

Alarm Lock

Alarm Lock DL 3000WP Bedienungsanleitung

Alarm Lock

Alarm Lock Wireless Networx PDLN4100 Installationshandbuch

Alarm Lock

Alarm Lock NEW KEY LOGGING FEATURE Addendum Bedienungsanleitung

Beliebte Sperren Handbücher anderer Marken

Magic

Magic 105 Bedienungsanleitung

Gantner

Gantner GAT NET.Lock 7020 System Kurzanleitung

Wittkopp

Wittkopp Insys 7202 Bedienungsanleitung

Dorma

Dorma Studio Classic Bedienungsanleitung

Securam

Securam ECSL-601 Bedienungsanleitung

Sudhaus

Sudhaus 3003 Bedienungsanleitung

Safety 1st

Safety 1st 48517 Bedienungsanleitung

Pado

Pado FDS-10 Bedienungsanleitung

Esco

Esco systeQ Series Bedienungsanleitung

COMPX

COMPX National D8951 Bedienungsanleitung

secureo

secureo Key Box Bedienungsanleitung

Stock Loks

Stock Loks C8713 Bedienungsanleitung

COMPX

COMPX 1T-058 Betriebsanleitung

Auslock

Auslock T11 Bedienungsanleitung

ELCOM

ELCOM 7205 Bedienungsanleitung

Stealth SAFES

Stealth SAFES ShadowVault Bedienungsanleitung

Knox

Knox KeySecure 5 Bedienungsanleitung

Kwikset

Kwikset 48334/01 Bedienungsanleitung