Analog Devices ADSP-21369 EZ-KIT Lite Bedienungsanleitung
a
ADSP-21369 EZ-KIT Lite®
Evaluation System Manual
Revision 2.4, July 2012
Part Number
82-000196-01
Analog Devices, Inc.
One Technology Way
Norwood, Mass. 02062-9106
Copyright Information
© 2012 Analog Devices, Inc., ALL RIGHTS RESERVED. This docu-
ment may not be reproduced in any form without prior, express written
consent from Analog Devices, Inc.
Printed in the USA.
Disclaimer
Analog Devices, Inc. reserves the right to change this product without
prior notice. Information furnished by Analog Devices is believed to be
accurate and reliable. However, no responsibility is assumed by Analog
Devices for its use; nor for any infringement of patents or other rights of
third parties which may result from its use. No license is granted by impli-
cation or otherwise under the patent rights of Analog Devices, Inc.
Trademark and Service Mark Notice
The Analog Devices logo, CrossCore, EngineerZone, EZ-Extender,
EZ-KIT Lite, SHARC, and VisualDSP++ are registered trademarks of
Analog Devices, Inc.
All other brand and product names are trademarks or service marks of
their respective owners.
Regulatory Compliance
The ADSP-21369 EZ-KIT Lite is designed to be used solely in a labora-
tory environment. The board is not intended for use as a consumer end
product or as a portion of a consumer end product. The board is an open
system design which does not include a shielded enclosure and therefore
may cause interference to other electrical devices in close proximity. This
board should not be used in or near any medical equipment or RF devices.
The ADSP-21369 EZ-KIT Lite has been certified to comply with the
essential requirements of the European EMC directive 2004/108/EC and
therefore carries the “CE” mark.
The ADSP-21369 EZ-KIT Lite has been appended to Analog Devices,
Inc. EMC Technical File (EMC TF) referenced DSPTOOLS1, issue 2
dated June 4, 2008 and was declared CE compliant by an appointed
Notified Body (No.0673) as listed below.
Notified Body Statement of Compliance: Z600ANA1.025
Issued by: Technology International (Europe) Limited
60 Shrivenham Hundred Business Park
Shrivenham, Swindon, SN6 8TY, UK
The EZ-KIT Lite evaluation system contains ESD (electrostatic discharge)
sensitive devices. Electrostatic charges readily accumulate on the human
body and equipment and can discharge without detection. Permanent
damage may occur on devices subjected to high-energy discharges. Proper
ESD precautions are recommended to avoid performance degradation or
loss of functionality. Store unused EZ-KIT Lite boards in the protective
shipping package.
ADSP-21369 EZ-KIT Lite Evaluation System Manual v
CONTENTS
PREFACE
Product Overview .......................................................................... x
Purpose of This Manual .............................................................. xiii
Intended Audience ...................................................................... xiii
Manual Contents ......................................................................... xiv
What’s New in This Manual ......................................................... xiv
Technical Support ......................................................................... xv
Supported Processors .................................................................... xvi
Product Information .................................................................... xvi
Analog Devices Web Site ........................................................ xvi
EngineerZone ........................................................................ xvii
Related Documents .................................................................... xviii
Notation Conventions ................................................................ xviii
USING THE ADSP-21369 EZ-KIT LITE
Package Contents .......................................................................... 1-2
Default Configuration ................................................................... 1-3
CCES Install and Session Startup .................................................. 1-4
Session Startup ........................................................................ 1-6
Contents
vi ADSP-21369 EZ-KIT Lite Evaluation System Manual
VisualDSP++ Install and Session Startup ....................................... 1-8
Session Startup ........................................................................ 1-8
CCES Evaluation License ........................................................... 1-10
VisualDSP++ Evaluation License ................................................. 1-11
External Memory ........................................................................ 1-11
ELVIS Interface .......................................................................... 1-13
Analog Audio ............................................................................. 1-14
LEDs and Push Buttons .............................................................. 1-15
Example Programs ...................................................................... 1-17
Board Design Database ............................................................... 1-17
ADSP-21369 EZ-KIT LITE HARDWARE REFERENCE
System Architecture ...................................................................... 2-2
External Port ........................................................................... 2-3
DAI Interface .......................................................................... 2-4
DPI Interface .......................................................................... 2-5
FLAG Pins .............................................................................. 2-6
External PLL ........................................................................... 2-7
Expansion Interface ................................................................. 2-7
JTAG Emulation Port ............................................................. 2-8
Switches ....................................................................................... 2-9
Boot Mode and Clock Ratio Select Switch (SW2) .................. 2-10
Codec Setup Switch (SW3) ................................................... 2-11
Electret Microphone Select Switch (SW4) .............................. 2-12
UART Enable Switch (SW5) ................................................. 2-12
ADSP-21369 EZ-KIT Lite Evaluation System Manual vii
Contents
Loopback Test Switches (SW6 and SW14) ............................. 2-12
Push Button Enable Switch (SW7) ......................................... 2-13
SPI Disable Switch (SW15) ................................................... 2-13
ELVIS Oscilloscope Configuration Switch (SW1) ................... 2-13
ELVIS Function Generator Configuration Switch (SW13) ...... 2-14
LEDs and Push Buttons .............................................................. 2-15
General Purpose LEDs (LED1–8) .......................................... 2-16
Power LED (LED9) ............................................................... 2-16
Reset LEDs (LED10) ............................................................. 2-16
USB Monitor LED (ZLED3) ................................................. 2-16
Push Buttons (SW8–11) ........................................................ 2-17
Board Reset Push Button (SW12) .......................................... 2-17
Jumpers ...................................................................................... 2-18
VCO Select Jumper (JP1) ...................................................... 2-19
ELVIS Select Jumper (JP2) .................................................... 2-19
ELVIS Voltage Selection Jumper (JP3) ................................... 2-20
ELVIS Programmable Flag Jumper (JP4) ................................ 2-20
Connectors ................................................................................. 2-21
Expansion Interface Connectors (J1–3) .................................. 2-22
Audio In RCA Connector (J10) ............................................. 2-22
Audio Out RCA Connector (J5) ............................................ 2-23
Headphone Out Jack (J9) ...................................................... 2-23
Power Jack (J4) ...................................................................... 2-23
RS-232 Connector (J6) .......................................................... 2-24
Contents
viii ADSP-21369 EZ-KIT Lite Evaluation System Manual
S/PDIF Coax Connectors (J7 and J8) .................................... 2-24
DPI Header (P3) ................................................................... 2-25
DAI Header (P4) .................................................................. 2-25
JTAG Header (ZP4) .............................................................. 2-25
ADSP-21369 EZ-KIT LITE BILL OF MATERIALS
ADSP-21369 EZ-KIT LITE SCHEMATIC
INDEX
ADSP-21369 EZ-KIT Lite Evaluation System Manual ix
PREFACE
Thank you for purchasing the ADSP-21369 EZ-KIT Lite®, Analog
Devices, Inc. evaluation system for SHARC®processors.
SHARC processors are based on a 32-bit super Harvard architecture that
includes a unique memory architecture comprised of two large on-chip,
dual-ported SRAM blocks coupled with a sophisticated I/O processor,
which gives a SHARC processor the bandwidth for sustained high-speed
computations. SHARC processors represents today’s de facto standard for
floating-point processing, targeted toward premium audio applications.
The evaluation system is designed to be used in conjunction with the
CrossCore®Embedded Studio (CCES) and VisualDSP++®development
environments to test capabilities of the ADSP-21369 SHARC processors.
The development environment aids advanced application code develop-
ment and debug, such as:
• Create, compile, assemble, and link application programs written
in C++, C, and ADSP-21369 assembly
• Load, run, step, halt, and set breakpoints in application programs
• Read and write data and program memory
• Read and write core and peripheral registers
• Plot memory
Access to the ADSP-21369 processor from a personal computer (PC) is
achieved through a USB port or an external JTAG emulator. The USB
interface provides unrestricted access to the ADSP-21369 processor and
Product Overview
x ADSP-21369 EZ-KIT Lite Evaluation System Manual
evaluation board peripherals. Analog Devices JTAG emulators offer faster
communication between the host PC and target hardware. Analog Devices
carries a wide range of in-circuit emulation products. To learn more about
Analog Devices emulators and processor development tools, go to
http://www.analog.com/dsp/tools.
The ADSP-21369 EZ-KIT Lite provides example programs to demon-
strate the product capabilities.
Product Overview
The board features:
• Analog Devices ADSP-21369 SHARC processor
• 256-pin SBGA package
• 400 MHz core clock speed
• Synchronous dynamic random access memory (SDRAM)
• 1M x 32-bit x 4 banks
• Synchronous random access memory (SRAM)
• 512K bit x 8-bit
• Flash memory
• 1M x 8-bit
• Serial peripheral interface (SPI) flash memory
•2Mbit
Andere Handbücher für ADSP-21369 EZ-KIT Lite
1
Inhaltsverzeichnis
Andere Analog Devices Computerhardware Handbücher
Analog Devices
Analog Devices ADSP-21261 SHARC Anwendungshandbuch
Analog Devices
Analog Devices EZ-Board ADSP-21489 Bedienungsanleitung
Analog Devices
Analog Devices ADSP-219 Series Anwendungshandbuch
Analog Devices
Analog Devices ADuCM322 Bedienungsanleitung
Analog Devices
Analog Devices LTC3728EG Bedienungsanleitung
Analog Devices
Analog Devices AD9883A Bedienungsanleitung
Analog Devices
Analog Devices EVAL-ADA4570SDZ Bedienungsanleitung
Analog Devices
Analog Devices Linear ADI Power LT1964 Kurzanleitung zur Einrichtung
Analog Devices
Analog Devices TigerSHARC ADSP-TS201S Bedienungsanleitung
Analog Devices
Analog Devices LTM4683 Bedienungsanleitung
Analog Devices
Analog Devices adsp-2100 Bedienungsanleitung
Analog Devices
Analog Devices Linear ADP5070 Kurzanleitung zur Einrichtung
Analog Devices
Analog Devices EZ-KIT Lite ADSP-BF537 Bedienungsanleitung
Analog Devices
Analog Devices AD9830 Bedienungsanleitung
Analog Devices
Analog Devices ADM8611 Bedienungsanleitung
Analog Devices
Analog Devices Linear LT3383 Kurzanleitung zur Einrichtung
Analog Devices
Analog Devices ADSP-BF535 Blackfin Anwendungshandbuch
Analog Devices
Analog Devices HPUSB Bedienungsanleitung
Analog Devices
Analog Devices Linear SCP-LT8362-S-EVALZ Kurzanleitung zur Einrichtung
Analog Devices
Analog Devices ADSST-EM-3040 Bedienungsanleitung
Beliebte Computerhardware Handbücher anderer Marken
EMC2
EMC2 VNX Series Betriebsanleitung
Panasonic
Panasonic DV0PM20105 Bedienungsanleitung
Mitsubishi Electric
Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung
Gigabyte
Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung
Raidon
Raidon iT2300 Bedienungsanleitung
National Instruments
National Instruments PXI-8186 Bedienungsanleitung
