Analog Devices EZ-KIT Lite ADSP-21364 Bedienungsanleitung

ADSP-21364 EZ-KIT Lite®

Evaluation System Manual

Revision 2.0, January 2005

Part Number

82-000840-01

Analog Devices, Inc.

One Technology Way

Norwood, Mass. 02062-9106 a

ment may not be reproduced in any form without prior, express written

consent from Analog Devices, Inc.

Printed in the USA.

Limited Warranty

The EZ-KIT Lite evaluation system is warranted against defects in materi-

als and workmanship for a period of one year from the date of purchase

from Analog Devices or from an authorized dealer.

Disclaimer

Analog Devices, Inc. reserves the right to change this product without

prior notice. Information furnished by Analog Devices is believed to be

accurate and reliable. However, no responsibility is assumed by Analog

Devices for its use; nor for any infringement of patents or other rights of

third parties which may result from its use. No license is granted by impli-

cation or otherwise under the patent rights of Analog Devices, Inc.

Trademark and Service Mark Notice

The Analog Devices logo, VisualDSP++, the VisualDSP++ logo, SHARC,

CROSSCORE, the CROSSCORE logo, and EZ-KIT Lite are registered

trademarks of Analog Devices, Inc.

All other brand and product names are trademarks or service marks of

their respective owners.

Regulatory Compliance

The ADSP-21364 EZ-KIT Lite evaluation system has been certified to

comply with the essential requirements of the European EMC directive

89/336/EEC (inclusive 93/68/EEC) and, therefore, carries the “CE”

mark.

The ADSP-21364 EZ-KIT Lite evaluation system had been appended to

Analog Devices Development Tools Technical Construction File refer-

enced “DSPTOOLS1” dated December 21, 1997 and was awarded CE

Certification by an appointed European Competent Body and is on file.

The EZ-KIT Lite evaluation system contains ESD

(electrostatic discharge) sensitive devices. Electro-

static charges readily accumulate on the human

body and equipment and can discharge without

detection. Permanent damage may occur on devices

subjected to high-energy discharges. Proper ESD

precautions are recommended to avoid performance

degradation or loss of functionality. Store unused

EZ-KIT Lite boards in the protective shipping

package.

CONTENTS

iv ADSP-21364 EZ-KIT Lite Evaluation System Manual

ADSP-21364 EZ-KIT Lite Evaluation System Manual v

CONTENTS

PREFACE

Purpose of This Manual ................................................................. xii

Intended Audience ........................................................................ xiii

Manual Contents .......................................................................... xiii

What’s New in This Manual ........................................................... xiv

Technical or Customer Support ...................................................... xiv

Supported Processors ....................................................................... xv

Product Information ....................................................................... xv

MyAnalog.com .......................................................................... xv

Processor Product Information .................................................. xvi

Related Documents .................................................................. xvi

Online Technical Documentation ........................................... xviii

Accessing Documentation From VisualDSP++ .................... xviii

Accessing Documentation From Windows ............................ xix

Accessing Documentation From Web ................................... xix

Printed Manuals ....................................................................... xix

VisualDSP++ Documentation Set .......................................... xx

Hardware Tools Manuals ....................................................... xx

Processor Manuals ................................................................. xx

CONTENTS

vi ADSP-21364 EZ-KIT Lite Evaluation System Manual

Data Sheets .......................................................................... xx

Notation Conventions ................................................................... xxi

USING EZ-KIT LITE

Package Contents ......................................................................... 1-2

Default Configuration .................................................................. 1-3

Installation and Session Startup ..................................................... 1-5

Evaluation License Restrictions ..................................................... 1-6

External Memory .......................................................................... 1-6

Analog Audio ............................................................................... 1-7

LEDs and Push Buttons ................................................................ 1-9

Example Programs ...................................................................... 1-10

Background Telemetry Channel .................................................. 1-11

VisualDSP++ Interface ................................................................ 1-11

Boot Load ............................................................................. 1-11

Target Options ...................................................................... 1-12

While Target is Halted and On Emulator Exit Options ...... 1-12

Other Options .................................................................. 1-12

Core Hang Conditions .......................................................... 1-13

Hardware Breakpoints ........................................................... 1-15

Data Hardware Breakpoints .............................................. 1-16

Instruction Hardware Breakpoints ..................................... 1-17

Other Breakpoints ............................................................ 1-18

Common Hardware Breakpoint Attributes ........................ 1-19

Global Hardware Breakpoint Options ............................... 1-19

ADSP-21364 EZ-KIT Lite Evaluation System Manual vii

CONTENTS

Miscellaneous ................................................................... 1-19

EZ-KIT LITE HARDWARE REFERENCE

System Architecture ...................................................................... 2-2

Parallel Port ............................................................................. 2-3

DAI Interface .......................................................................... 2-5

SPI Interface ........................................................................... 2-6

FLAG Pins .............................................................................. 2-6

Expansion Interface ................................................................. 2-7

JTAG Emulation Port .............................................................. 2-8

Switch Settings .............................................................................. 2-8

Electret Microphone Select Switch (SW6) ................................ 2-8

Codec Setup Switch (SW7) ...................................................... 2-8

Push Button Enable Switch (SW9) ......................................... 2-10

Boot Mode and Clock Ratio Select Switch (SW10) ................. 2-11

Loop-Back Test Switch (SW11) ............................................. 2-12

LEDs and Push Buttons .............................................................. 2-12

General Purpose LEDs (LED8–1) .......................................... 2-12

Reset LEDs (LED9 and LED12) ............................................ 2-12

Power LED (LED10) ............................................................. 2-13

USB Monitor LED (LED13) ................................................. 2-13

Push Buttons (SW4–1) .......................................................... 2-14

Board Reset Push Button (SW5) ............................................ 2-14

Connectors ................................................................................. 2-15

Expansion Interface (J3–J1) ................................................... 2-16

CONTENTS

viii ADSP-21364 EZ-KIT Lite Evaluation System Manual

Audio In RCA Connector (J4) ............................................... 2-17

Audio Out RCA Connector (J5) ............................................ 2-17

Headphone Out Jack (J6) ...................................................... 2-17

Power Jack (J7) ..................................................................... 2-17

SPDIF Coax Connectors (J8 and J9) ..................................... 2-18

SPI Header (P2) .................................................................... 2-18

DAI Header (P3) .................................................................. 2-19

USB Connector (P4) ............................................................. 2-19

JTAG Header (P5) ................................................................ 2-19

BILL OF MATERIALS

INDEX

ADSP-21364 EZ-KIT Lite Evaluation System Manual ix

PREFACE

Thank you for purchasing the ADSP-21364 EZ-KIT Lite®, Analog

Devices, Inc. evaluation system for SHARC®processors.

The SHARC processors are based on a 32-bit super Harvard architecture

that includes a unique memory architecture comprised of two large

on-chip, dual-ported SRAM blocks coupled with a sophisticated IO pro-

cessor, which gives a SHARC processor the bandwidth for sustained

high-speed computations. SHARC processors represents today’s de facto

standard for floating-point processor targeted for premium audio

applications.

The evaluation system is designed to be used in conjunction with the

VisualDSP++®development environment to test the capabilities of the

ADSP-21364 SHARC processors. The VisualDSP++ development envi-

ronment gives you the ability to perform advanced application code

development and debug, such as:

• Create, compile, assemble, and link application programs written

in C++, C, and ADSP-21364 assembly

• Load, run, step, halt, and set breakpoints in application program

• Read and write data and program memory

• Read and write core and peripheral registers

• Plot memory

x ADSP-21364 EZ-KIT Lite Evaluation System Manual

Access to the ADSP-21364 processor from a personal computer (PC) is

achieved through a USB port or an optional JTAG emulator. The USB

interface gives unrestricted access to the ADSP-21364 processor and the

evaluation board peripherals. Analog Devices JTAG emulators offer faster

communication between the host PC and target hardware. Analog Devices

carries a wide range of in-circuit emulation products. To learn more about

Analog Devices emulators and processor development tools, go to

http://www.analog.com/dsp/tools/.

LThe ADSP-21364 EZ-KIT Lite installation is part of the Visu-

alDSP++ installation. The EZ-KIT Lite is a licensed product that

offers an unrestricted evaluation license for the first 90 days. Once

the initial unrestricted 90-day evaluation license expires:

• VisualDSP++ allows a connection to the ADSP-21364

EZ-KIT Lite via the USB Debug Agent interface only. Con-

nections to simulators and emulation products are no longer

allowed.

• The linker restricts a users program to 10922 words of

internal memory for code space with no restrictions for data

space.

ADSP-21364 EZ-KIT Lite provides example programs to demonstrate the

capabilities of the evaluation board.

The board features:

• Analog Devices ADSP-21364 processor

D136-pin BGA package

D300 MHz Core Clock Speed

Andere Handbücher für EZ-KIT Lite ADSP-21364

Inhaltsverzeichnis

Andere Analog Devices Computerhardware Handbücher

Analog Devices

Analog Devices ADAU1961 Bedienungsanleitung

Analog Devices

Analog Devices ADSP-219 Series Anwendungshandbuch

Analog Devices

Analog Devices AD9830 Bedienungsanleitung

Analog Devices

Analog Devices Linear Technology LTC6953 Kurzanleitung zur Einrichtung

Analog Devices

Analog Devices ADSP-CM419F Bedienungsanleitung

Analog Devices

Analog Devices ADF7021-V Bedienungsanleitung

Analog Devices

Analog Devices MicroConverter ADuC832 Bedienungsanleitung

Analog Devices

Analog Devices Linear ADP5070 Kurzanleitung zur Einrichtung

Analog Devices

Analog Devices EV-RPG2 Bedienungsanleitung

Analog Devices

Analog Devices ADSP-21261 SHARC Anwendungshandbuch

Analog Devices

Analog Devices ADSP-2186 Bedienungsanleitung

Analog Devices

Analog Devices ADSP-21000 Benutzerhandbuch

Analog Devices

Analog Devices SHARC ADSP-21065L Bedienungsanleitung

Analog Devices

Analog Devices SHARC Series Bedienungsanleitung

Analog Devices

Analog Devices ADT7460 Bedienungsanleitung

Analog Devices

Analog Devices EVAL-ADuCM420QSP1Z Bedienungsanleitung

Analog Devices

Analog Devices ADSP-SC573 EZ-KIT Bedienungsanleitung

Analog Devices

Analog Devices DC3089A Bedienungsanleitung

Analog Devices

Analog Devices Blackfin Bedienungsanleitung

Analog Devices

Analog Devices SHARC ADSP-21367 Bedienungsanleitung

Analog Devices

Analog Devices Blackfin FPGA EZ-Extender Bedienungsanleitung

Analog Devices

Analog Devices Blackfin ADSP-BF537 Anwendungshandbuch

Analog Devices

Analog Devices ADM1060 Bedienungsanleitung

Analog Devices

Analog Devices ADT7473 Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

AMD

AMD Phenom II Betriebshandbuch

Intel

Intel NUC 12 Pro Bedienungsanleitung

dbx

dbx Zone Pro 1260 Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung