APRILIA RX 50 - 1996 Bedienungsanleitung

ONLY FOR THE CATALYTIC VERSION

USE ONLY UNLEADED PETROL IN CONFORMITY WITH THE DIN 51607 STANDARD, MIN. O.N. 95

(N.O.R.M.) AND 85 (N.O.M.M.) AND HIGH PERFORMANCE SYNTHETIC OIL FOR 2 STROKE ENGINES.

THE USE OF FUELS AND LUBRICANTS DIFFERENT FROM THOSE INDICATED CAUSES SEVERE

FUNCTIONAL INCONVENIENCES TO THE VEHICLE AND THE VOIDING OF THE

aprilia

GUARANTEE.

ONLY FOR THE CATALYTIC VERSION

To have the catalytic converter functioning correctly for long periods and to reduce possible

problems regarding the contamination of the thermal unit and of the exhaust, it is necessary to

avoid covering long distances with the engine running at constantly low rpm.

It is sufficient to alternate these periods with periods in which the engine runs at relatively high rpm,

even if only for a few seconds, but rather frequently.

What has been stated above assumes particular importance for the cold starting of the engine: in this

case, in order to reach a rpm regime sufficient to enable the “priming” of the catalytic reaction, you just

need to make sure that the temperature of the thermal unit has reached at least 50°C, which generally

occurs a few seconds after starting the engine.

CATALYTIC SILENCER

The catalytic version of the RX50 is fitted with a silencer with metal catalytic converter of the “platinum-

rhodium bivalent” type. This device provides for the oxidation of the CO (carbon monoxide) and of the

HC (unburned hydrocarbons) contained in the exhaust gases, changing them into carbon dioxide and

steam, respectively. Due to the catalytic reaction, the high temperature reached by the exhaust gases

results in the burning of the oil particles, thus keeping the silencer clean and eliminating the exhaust

fumes.

Avoid parking the catalytic vehicle near dry brush wood or in places easily accessible to chil-

dren, as the catalytic silencer becomes extremely hot during use; be very careful and avoid any

kind of contact before it has completely cooled down.

First edition: february 1996

Reprint: september 1996, march 1997, april 1998

Produced and printed by:

Studio Tecno Public

Viale del Progresso - 37038 Soave (VR) - Italy

Tel. +39 - 045 76 11 911

Fax +39 - 045 76 12 241

www.stp.it

E-mail: [email protected]

On behalf of:

aprilia s.p.a.

via G. Galilei, 1 - 30033 Noale (VE) - Italy

Tel. +39 - 041 58 29 111

Fax +39 - 041 44 10 54

www.aprilia.com

This manual contains all the main information and the

instructions required for normal use and maintenance

of your vehicle.

For controls and check-ups that cannot be carried out

easily with the standard equipment supplied, we ad-

vise you to consult our Dealers who can assure you

of quick and careful servicing.

To keep your

aprilia

vehicle always in perfect operat-

ing conditions, we advise you to insist on Original

Spares and to have repairs carried out only by

aprilia

Authorized Outlets and Official Dealers.

When ordering spare parts from the Dealers, always

quote the spares code which is stamped on a sticker

placed under the saddle.

It is a good idea to make a note of the identification

code in the space provided in this manual, so that

you will always have a record of it even if the identifi-

cation sticker comes off.

All information is purely indicative and may be sub-

ject to variation without notice.

aprilia

CODICE RICAMBI spare parts code number

N˚ I.M. ABCDE

IUKAPSFBDF E

GR NL CH DK J SGP PL IL ROK

MAL RCH BM USA AUS

Carefully observe the instructions preceded by the

following warning signs:

Safety norms and regulations to protect

the driver and other people from severe

injuries or grave risks

Caution norms and suggestions to avoid

damaging the vehicle and/or hurting your-

self or other people

Indications to make the operations easier.

Technical information

CONTENTS

Pag.

Technical features ....................................................5

Identiﬁcation data.....................................................8

Arrangement of the controls.....................................9

Instructions for use.................................................12

Maintenance...........................................................15

Electrical system ....................................................35

Cleaning.................................................................40

Long inactivity ........................................................40

Periodic maintenance chart....................................41

Lubricant chart .......................................................42

Importers................................................................43

Wiring diagram.......................................................45

automatic light switching version

(Automatic Switch-on Device)

catalytic version

Italy version

Denmark version

United Kingdom version

Japan version

Austria version

Singapore version

Portugal version

Poland version

Finland version

Israel version

Belgium version

South Korea version

Germany version

Malaysia version

France version

Chile version

Spain version

Bermuda version

Greece version

United States

of America version

Holland version

Switzerland version

Australia version

TECHNICAL FEATURES

MOTOR

Model..................................................................AM6

Type...................................... 2 stroke single-cylinder

with lamellar inlet

Cooling..........................Liquid with forced circulation

Lubrication .................................................. Separate

Bore / stroke...................................40,3 mm / 39 mm

Displacement ............................................49,75 cmC

Compression ratio.............................................12 : 1

KICK START

To pedal (Kick-starter)

CLUTCH

Light alloy multiple disc oil bath

GEARS

Frontal clutch 6 speed unit

TRANSMISSION

Primary ........................................Helical teeth gears

Ratio 3,55 (Z=20/71)

Secondary.........chain 1/2"x3,16" = Roller Ø7,75 mm

Ratio: 4,25 (Z=12/51)

CARBURETTOR

Model .................................................. Dell’Orto SHA

Diffuser...................................................Ø 12-14 mm

AIR FILTER

Sponge

IGNITION

Type........................................................... electronic

Spark advance reference...............................1,5 mm

correspondent to 20° before T.D.C.

Spark plug............................................ NGK BR8 ES

FUEL

Running-in (500 km) .........................unleaded petrol

according to the DIN 51607 standard

min. O.N. 95 (N.O.R.M.)

and 85 (N.O.M.M.)

Aferwords:.........................................unleaded petrol

according to the DIN 51607

min. O.N. 95 (N.O.R.M.)

and 85 (N.O.M.M.)

Fuel tank capacity...............................................9,5l

Reserve (with mechanical operation)..................1,5l

Mixer oil tank capacity.........................................1,3l

Reserve (with warning light on the dashboard)...0,5l

LUBRICATION

Gearbox and primary transmission 820 cmCof oil (*)

COOLING

Cooling circuit capacity ................................. 0,9l(*)

(60% antifreeze + 40% water)

Minimum operating temperature.......................-17°C

FRAME

High-resistance one-beam structure, split over the

exhaust

REAR FORK

Made of rectangular-profile steel, mounted on anti-

friction bushings

SUSPENSIONS

Front....................................aprilia telehydraulic fork

with reversed rods

with advanced pin, rods Ø 35

stroke 250 mm

Rear ................................aprilia Progressive System

adjustable hydraulic mono-shock absorber

Rear wheel stroke.........................................260 mm

(*) see “LUBRICANT CHART”

BRAKES

Front........................................ disc brake Ø 230 mm

with hydraulic control

and floating caliper with two parallel pins

Rear ........................................ disc brake Ø 220 mm

with hydraulic control

and fixed caliper

with two opposing pins Ø 28 mm

TYRES

Front....................................90/90 x 21" Enduro type

inflation pressure: 1,6 bar

Rear ..................................110/80 x 18" Enduro type

inflation pressure: 1,8 bar

RIMS

Front.............................................................21 x 1,6"

Rear ...........................................................18 x 1,85"

DIMENSIONS

Max. length..................................................2060 mm

Wheelbase (slot center) ..............................1360 mm

Handlebars width ..........................................810 mm

Max. height..................................................1350 mm

Seat height....................................................890 mm

Footboard height...........................................355 mm

TYRE INFLATION PRESSURE

Maximum front and rear pressure: 2,5 bar

Low pressure can cause handling prob-

lems and the tendency to weave and in

extreme cases loss of control.

Moreover this will cause a great increase of roll-

ing friction.

The results are: high consumption of fuel and re-

duced maximum speed.

The disadvantage may cause a damage of the cover,

due to excessive local deformation.

Tyre pressure must be checked when the

tyres are at environment temperature,

that is, when the vehicle has not been moved in

the last 2 or 3 hours for more than 1 km.

Check the depth of the tyre tread often, if

it is worn below the allowable limit (2 -

3 mm.) change the tyre.

– The tyre should often be inspected for signs of

damage or cuts.

– Blowings or irregular wavings are showing in-

ternal damages, which request the prompt re-

placement of the tyre.

Remember: 1 mile = 1.6 km

1 km = 0.625 miles

Kind of drive Driver only

Front Rear

Off-road 1,3 bar 1,4 bar

On mixed roads 1,5 bar 1,6 bar

On asphalt

paved roads 1,6 bar 1,8 bar

IDENTIFICATION DATA

It is a good rule to write down the frame and engine

numbers in the space provided in this manual.

The frame number can be used for the purchase of

spare parts.

Do not alter the identification numbers if

you do not want to incur severe penal and

administrative sanctions. In particular, the altera-

tion of the frame number results in the immediate

invalidity of the guarantee.

FRAME NUMBER (Fig. 1)

The frame number is stamped on the left side of the

steering head.

Frame n°

ENGINE NUMBER (Fig. 2)

The engine number is printed in the space provided

upper the pinion.

Engine n°

Fig. 1

Fig. 2

ARRANGEMENT OF THE CONTROLS

The control devices are positioned as indicated in fig-

ures 3 and 4, as follows:

Fig. 3

1) Clutch lever

2) Front brake lever

3) Twist grip

4) Rear brake pedal

5) Kick-starter

6) Gear pedal

Fig. 4

1) Turn indicator switch (c)

2) Horn push button (f)

3) Dimmer light switch (b- p) and low beam si-

gnalling push button (b)

3a) %_Dimmer light switch (a- b) and high

beam signalling push button (a)

4) Trip odometer control knob

5) Speedometer/odometer with trip counter

6) Mixer oil reserve warning light (j)

7) Low beam warning light (b)

7a) High beam warning light (a) %_

8) Neutral indicator warning light (q)

9) Revolution counter (rpm)

10) Turn indicator warning light (c)

11) Ignition switch / steering lock / light switch

(s- m- n- o)

Remember: 1 mile = 1.6 km

1 km = 0.625 miles

Fig. 3

Fig. 4

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere APRILIA Motorrad Handbücher

APRILIA

APRILIA Pegaso 650 Installations- und Betriebsanleitung

APRILIA

APRILIA Amico 50 1997 Bedienungsanleitung

APRILIA

APRILIA PEGASO 650 STRADA Leitfaden

APRILIA

APRILIA SCARABEO 50 - 2000 Bedienungsanleitung

APRILIA

APRILIA RSV4 FACTORY Bedienungsanleitung

APRILIA

APRILIA RXV 450 - 07-2007 Bedienungsanleitung

APRILIA

APRILIA RS 125 Gebrauchsanweisung

APRILIA

APRILIA RS4 125 Leitfaden

APRILIA

APRILIA RS 50 - 1995 Bedienungsanleitung

APRILIA

APRILIA SCARABEO 100 4T - 06-2001 PART10 Bedienungsanleitung

APRILIA

APRILIA SL 750 SHIVER Leitfaden

APRILIA

APRILIA SHIVER 750 - Bedienungsanleitung

APRILIA

APRILIA TUONO R - 02-2007 Bedienungsanleitung

APRILIA

APRILIA RS 125 TUONO - 2003 Bedienungsanleitung

APRILIA

APRILIA PEGASO 650 IE - PART2 01-2001 Bedienungsanleitung

APRILIA

APRILIA SCARABEO 125 Bedienungsanleitung

APRILIA

APRILIA SCARABEO 500 - 2003 Bedienungsanleitung

APRILIA

APRILIA SPORTCITY CUBE 300 Bedienungsanleitung

APRILIA

APRILIA RSV MILLE Bedienungsanleitung

APRILIA

APRILIA MX 125 - ED01 2004 Bedienungsanleitung

APRILIA

APRILIA SR 50 Bedienungsanleitung

APRILIA

APRILIA TUAREG 660 Leitfaden

APRILIA

APRILIA RXV 550 450 Stücklistenhandbuch

APRILIA

APRILIA RALLY 50 - 2002 Bedienungsanleitung

Beliebte Motorrad Handbücher anderer Marken

OHVALE

OHVALE GP-0 Stücklistenhandbuch

Yamaha

Yamaha Star XV19CTSZ 2009 Bedienungsanleitung

KTM

KTM 350 XCF-W USA Bedienungsanleitung

HYOSUNG

HYOSUNG ST7 Bedienungsanleitung

Husqvarna

Husqvarna FC 250 2016 Bedienungsanleitung

Ducati

Ducati SCRAMBLER 800 Gebrauchsanweisung

Yamaha

Yamaha 2006 YZF-R1V Bedienungsanleitung

KTM

KTM Freeride E-XC 2021 Bedienungsanleitung

Fantic

Fantic Enduro 125 Bedienungsanleitung

Ducati

Ducati Supersport 750 desmodue Bedienungsanleitung

MV Agusta

MV Agusta 2008 F4 312RR 1078 Gebrauchsanweisung

Yamaha

Yamaha XVS650A Bedienungsanleitung

Yamaha

Yamaha YZF-R6T(C) Handbuch

Ducati

Ducati 748 monoposto strada Bedienungsanleitung

ATK

ATK 1988 250 Bedienungsanleitung

Excelsior-HENDERSON

Excelsior-HENDERSON 1999 HCX Bedienungsanleitung

Triumph

Triumph Thunderbird Bedienungsanleitung

Yamaha

Yamaha 2006 FJR1300A Bedienungsanleitung