APRILIA SXV 450 - 2007 Bedienungsanleitung

SXV450–550

VanDenBoschReplica

SUMMARY TABLE WITH TECHNICAL DATA

FRONT FORK

Type Marzocchi Shiver 50

Travel 267mm

Std. adjustment hydraulic brake under compression 20 clicks from all closed

Std. adjustment hydraulic brake under extension 20 clicks from all closed

Steering angle with centred bushings 25°

Steering angle with eccentric bushings 24° - 26°

Fork offset with centred bushings 14mm

Fork offset with eccentric bushings 11mm - 17mm

REAR SHOCK ABSORBER

Type Mono Sachs racing

Travel 120mm

Std. spring elasticity (K) 5.8 kgf/mm

Std. adjustment hydraulic brake under compression at high speed 10 clicks from all closed

Std. adjustment hydraulic brake under compression at low speed 15 clicks from all closed

Std. adjustment hydraulic brake under extension 20 clicks from all closed

STM CLUTCH

Calibration of primary standard spring SXV VDB 450 (wet race) 120 kg

Calibration of primary supplied spring SXV VDB 450 130 kg

Calibration of secondary standard spring SXV VDB 450 (wet race) 30 kg

Calibration of secondary supplied spring SXV VDB 450 40 kg

Calibration of primary standard spring SXV VDB 550 (wet race) 130 kg

Calibration of primary supplied spring SXV VDB 550 140 kg

Calibration of secondary standard spring SXV VDB 550 (wet race) 30 kg

Calibration of secondary supplied spring SXV VDB 550 40 kg

Wear limit clutch pack 35.00mm

PINION/SPROCKET

Standard pinion SXV VDB 450 z=13

Supplied pinion SXV VDB 450 z=14

Standard sprocket SXV VDB 450 z=45

Supplied sprocket SXV VDB 450 z=44, z=46

Standard pinion SXV VDB 550 z=15

Supplied pinion SXV VDB 550 z=14

Standard sprocket SXV VDB 550 z=46

Supplied sprocket SXV VDB 550 z=45, z=47

STARTING THE VEHICLE

This vehicle, having been designed for exclusive use in

competitions, is equipped with a small and lightweight

battery, sufficient for amperages needed during warm start-

ups and for the normal operation of the engine.

For cold start it is necessary to use the external battery that

comes with as an accessory to the vehicle.

•Remove the saddle.

•Disconnect the jack from the regular battery and connect

it to the external battery.

•Feed the injection circuit of the vehicle by connecting the

key jack on the handlebar.

•Start the engine using the ignition button on the right

side of the handlebar.

•With the engine running, disconnect the external battery

and reconnect the installed battery.

•To turn off the vehicle just press the off button on the left

side of the handlebar.

WARNING

After use the key jack has to be disconnected.

REMOTE ADJUSTMENT OF THE POSITION OF THE FRONT BRAKE

LEVER

•The vehicle is prearranged for a remote adjustment of

the distance of the front brake lever from the handlebar.

•Use the adjustment knob on the left handlebar until the

desired distance is obtained.

STARTING DEVICE

•The vehicle is set up for locking the fork under

compression as a launch control.

•Press the fork all the way.

•Press on the locking pin.

•Release the fork so that the pin engages on the slot of

the ring mounted on the fork.

•Release the pin.

ASYMMETRIC CHAIN TENSIONER PADS

•The vehicle is provided with two different chain

sprockets.

•It is possible to replace the chain sprocket and to rotate

the chain tensioner pads without having to adjust the

slack of the chain again.

•Mount the chain tensioner pads in the direction indicated

when installing the sprocket with more teeth.

•Mount the chain tensioner pads in the direction indicated

when installing the sprocket with less teeth.

WARNING

Changing the direction of the chain tensioner

pads corresponds to 1 tooth of the sprocket.

DIRECTION

OF TRAVEL

DIRECTION

OF TRAVEL

FRONT FORK

ADJUSTMENT OF THE HYDRAULIC BRAKE

•In order to adjust the hydraulic brake under compression

operate on the screw shown to the side.

•In order to adjust the hydraulic brake in extension

operate on the screw shown to the side.

DE-AERATION OF THE FRONT FORK

•To extract the air from the clutch stem, remove the dust

cap on each one of the fork legs.

•With the help of a screwdriver open the bleed valve until

the air inside is completely expelled.

ADJUSTMENT OF THE STEERING ANGLE

WARNING

To adjust the steering angle the eccentric

bushings must be first assembled.

•Loosen the headstock nut.

•Loosen the screw that closes the upper plate.

•By operating on both fork legs, loosen the tightening

screws on the upper plate.

•Slightly lift the upper plate, by pulling it out by a few

millimetres from the fork legs.

•Using a hook spanner, loosen the bearings preload ring

nut.

•The ring nut to work on is the upper one, immediately

below the steering plate.

WARNING

At this stage do not work on the ring nut for

adjusting the steering angle, located

immediately under the bearings preload ring

gear.

•Loosen the screw that locks the lower eccentric ring nut.

•Loosen the screw that locks the upper eccentric ring nut.

•Using a hook spanner, turn the upper eccentric ring nut

by 180°.

WARNING

Accurately line up the notch on the ring nut with

the point where the tubes of the frame meet

(vehicle axis).

•Restore the vehicle following, in reverse, the procedure

just described.

FORK OFFSET ADJUSTMENT

•Loosen the headstock nut.

•Loosen the screw that closes the upper plate.

•Loosen the screw that closes the lower plate.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere APRILIA Motorrad Handbücher

APRILIA

APRILIA HABANA 125 - PART2 Bedienungsanleitung

APRILIA

APRILIA RS 50 Benutzerhandbuch

APRILIA

APRILIA PEGASO 650 IE - PART1 01-2001 Stücklistenhandbuch

APRILIA

APRILIA RSV4 BROCHURE 2009 Bedienungsanleitung

APRILIA

APRILIA RS 660 2020 Bedienungsanleitung

APRILIA

APRILIA RSV mille TUONO Bedienungsanleitung

APRILIA

APRILIA SCARABEO 500 - 2008 Bedienungsanleitung

APRILIA

APRILIA SR 50 - DEALER INSTRUCTION SHEET 2005 Bedienungsanleitung

APRILIA

APRILIA SL 750 SHIVER Leitfaden

APRILIA

APRILIA SL 750 SHIVER - 2007 Bedienungsanleitung

APRILIA

APRILIA SX 125 Leitfaden

APRILIA

APRILIA SR MAX 125 ie Leitfaden

APRILIA

APRILIA RSV4 FACTORY Leitfaden

APRILIA

APRILIA RSV mille 956X Installations- und Betriebsanleitung

APRILIA

APRILIA PEGASO 650 STRADA-TRAIL Bedienungsanleitung

APRILIA

APRILIA SR 50 I.E - 2001 Bedienungsanleitung

APRILIA

APRILIA Tuono V4 Bedienungsanleitung

APRILIA

APRILIA CAPONORD 1200 Leitfaden

APRILIA

APRILIA RSV MILLE - PART 1 1999 Bedienungsanleitung

APRILIA

APRILIA TUONO 1000 - 2006 Bedienungsanleitung

APRILIA

APRILIA TUONO 1000 R Bedienungsanleitung

APRILIA

APRILIA DORSODURO 750 ABS Bedienungsanleitung

APRILIA

APRILIA SR 50 Bedienungsanleitung

APRILIA

APRILIA RS4 125 Leitfaden

Beliebte Motorrad Handbücher anderer Marken

OHVALE

OHVALE GP-0 Stücklistenhandbuch

Yamaha

Yamaha Star XV19CTSZ 2009 Bedienungsanleitung

KTM

KTM 350 XCF-W USA Bedienungsanleitung

HYOSUNG

HYOSUNG ST7 Bedienungsanleitung

Husqvarna

Husqvarna FC 250 2016 Bedienungsanleitung

Ducati

Ducati SCRAMBLER 800 Gebrauchsanweisung

Yamaha

Yamaha 2006 YZF-R1V Bedienungsanleitung

KTM

KTM Freeride E-XC 2021 Bedienungsanleitung

Fantic

Fantic Enduro 125 Bedienungsanleitung

Ducati

Ducati Supersport 750 desmodue Bedienungsanleitung

MV Agusta

MV Agusta 2008 F4 312RR 1078 Gebrauchsanweisung

Yamaha

Yamaha XVS650A Bedienungsanleitung

Yamaha

Yamaha YZF-R6T(C) Handbuch

Ducati

Ducati 748 monoposto strada Bedienungsanleitung

ATK

ATK 1988 250 Bedienungsanleitung

Excelsior-HENDERSON

Excelsior-HENDERSON 1999 HCX Bedienungsanleitung

Triumph

Triumph Thunderbird Bedienungsanleitung

Yamaha

Yamaha 2006 FJR1300A Bedienungsanleitung