Aprimatic WK120 Bedienungsanleitung

BASIC WK120 selector

LBT0430

Rev.00 Last print date Thursday 9 February 2017 Page 1to 3

DRAFT

DESCRIPTION

The BASIC Selector is a device controlling the automatic doors and can replace the mechanical

selector; communication with WK120 control unit is carried out through the S485 interface.

Upon switch-on, the Selector will run a test of all LEDs, then the LED corresponding to the

automatic door status will turn on.

In case of error the red LED with warning symbol will turn on, whereas if the battery is low the red LED with battery

symbol will turn on.

The Selector software cannot be updated through the PUA device (AP IMATIC Universal Programmer).

–

SELECTOR LAYOUT

There are 8 blue LEDs indicating the status of the

automatic door, 2 red LEDs signalling errors and a push-

button to select the statuses and, if necessary, to reset

the board WK120.

–

WK120 AUTOMATIC DOOR BOARD RESET

Simply press the push-button for more than 10

seconds, until all blue LEDs light up in clockwise sequence, to reset the board of the automatic door.

The reset cycle lasts approximately 10 seconds.

–

AUTOMATIC DOOR STATUS

Upon switch-on, the Selector will display the automatic door status by turning on first the flashing blue LED of the

It flashes in

"PROGRAMMING"

mode

Blu Led

Red Led

Button

Press the Button over 10

seconds RESET in progress:

Led rotating clockwise

BASIC WK120 selector

LBT0430

Rev.00 Last print date Thursday 9 February 2017 Page 2to 3

DRAFT

bidirectional status, then the steady blue LED of the door status.

- Push-button: To change the door status press the central push-button for 2 seconds until the LED starts

flashing; then press the push-button up to the desired status, after 2 seconds the LED will be steady on and the door

will set to the selected status.

If a "lock delay" higher than zero has been programmed and the "lock status" is chosen, the output status LED

(internal radar) will turn on together with the flashing padlock LED; once time runs out the lock status LED will

stay on and the automatic door will lock.

Double way External RADAR PARTIAL Pharmacy

Lock OPEN Internal RADAR Delayed Lock

BASIC WK120 selector

LBT0430

Rev.00 Last print date Thursday 9 February 2017 Page 3to 3

DRAFT

–

ERROR SIGNALLING

Signalling through red LED with triangle warning symbol:

1. fast flashing = S485 communication error with control unit.

2. slow flashing =error relevant to board PA1013.

3. steady on =cyclic test in progress.

Should a low battery error occur (control unit error E05), this will not be signalled through the red LED with the

triangle warning symbol, but through the slow flashing of the red LED with the battery symbol.

NOTE During parameter editing from the equipment and/or the PRO keyboard, the danger symbol continues flashing

until edit parameters mode is quitted.

Error signalling table

T IANGLE symbol red LED

BATTE Y symbol red LED

no communication with control unit

fast flashing

off

120

control unit error

slow flashing

off

cyclic test in p

rogress

steady on

off

low battery

off

slow flashing

–

ELECTRIC CONNECTIONS

WK120

Andere Handbücher für WK120

Inhaltsverzeichnis

Andere Aprimatic Toröffner Handbücher

Aprimatic

Aprimatic G-matic AP350 Betriebsanleitung

Aprimatic

Aprimatic ALZO EM 51 Bedienungsanleitung

Aprimatic

Aprimatic R223 Kurzanleitung

Aprimatic

Aprimatic XT2500 Betriebsanleitung

Aprimatic

Aprimatic ONDA 623 Kurzanleitung

Aprimatic

Aprimatic ONDA 500 Bedienungsanleitung

Aprimatic

Aprimatic ONDA 324 N Bedienungsanleitung

Aprimatic

Aprimatic ZT40 7M Bedienungsanleitung

Aprimatic

Aprimatic G-matic AP350 Betriebsanleitung

Aprimatic

Aprimatic TWENTY 270 Series Kurzanleitung

Aprimatic

Aprimatic FORTY 5500 Kurzanleitung

Aprimatic

Aprimatic AP424 Kurzanleitung

Aprimatic

Aprimatic APRIBOX 600 Kurzanleitung

Aprimatic

Aprimatic ZT 71 Bedienungsanleitung

Aprimatic

Aprimatic ZT4 C Bedienungsanleitung

Aprimatic

Aprimatic AT50-EM51-ALZO Handbuch

Aprimatic

Aprimatic ZT44 Bedienungsanleitung

Aprimatic

Aprimatic ZT 72 Bedienungsanleitung

Aprimatic

Aprimatic R1-24 Kurzanleitung

Aprimatic

Aprimatic SLIDE 230 Kurzanleitung

Aprimatic

Aprimatic ZT40 7M Bedienungsanleitung

Aprimatic

Aprimatic AT 92 T Kurzanleitung

Aprimatic

Aprimatic ZT42 (B-SR) Bedienungsanleitung

Aprimatic

Aprimatic R251FM Kurzanleitung

Beliebte Toröffner Handbücher anderer Marken

Elite

Elite CSW200UL Bedienungsanleitung

CAME

CAME FROG-PM4 Bedienungsanleitung

SOMFY

SOMFY FX230 Bedienungsanleitung

Turnstiles

Turnstiles FSW 900 Bedienungsanleitung

Erreka

Erreka BUL BL33 Betriebsanleitung

Erreka

Erreka VULCAN S Bedienungsanleitung

Beninca

Beninca R1-2 WBV Bedienungsanleitung

Erreka

Erreka VULCAN D Bedienungsanleitung

Motorline professional

Motorline professional FORT Bedienungsanleitung

Beninca

Beninca BOB5024 Bedienungsanleitung

AGA

AGA GATEMASTER 900 HD Bedienungsanleitung

Chamberlain

Chamberlain MotorLift HC280ML Bedienungsanleitung

SOMFY

SOMFY Dexxo RTS Pro Bedienungsanleitung

Cardin

Cardin BL Series Bedienungsanleitung

Westfalia

Westfalia 85 27 06 Bedienungsanleitung

CAME

CAME F500 Bedienungsanleitung

Extel

Extel VERA Bedienungsanleitung

Comunello Automation

Comunello Automation ABACUS 220 Bedienungsanleitung