APS IBoard IB-R009 Bedienungsanleitung

Customer Support: info@iboardauto.com

Rev. 20220401

iBoard

iBoard® by APS PART#: IB-R009

READ INSTRUCTIONS CAREFULLY BEFORE START ING

INSTALLATION. REMOVE CONTENTS FROM BOX AND

VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS

RECOMMENDED.

*ROCKER PANEL MOUNT

*NO DRILLING REQUIRED

Fastener Size Tightening Torque (ft-lbs) Required

6mm 6-7 √

8mm 16-18 √

10mm 31-32 X

12mm 56-58 X

14mm 92-94 X

Front

1# 1#

Customer Support: info@iboardauto.com

Rev. 20220401

iBoard

Hardware Package A (For Bracket Installation)

Item QTY Description Item QTY Description

1# 2Driver / Passenger Front Mounting Brackets 5# 8M8 Lock Washers

2# 2Driver / Passenger Rear Mounting Brackets 6# 4M8X1.25 Hex Nuts

3# 8M8X1.25-30 Hex Bolts 7# 4M8 Clip Nuts

4# 12 M8 Large Flat Washers

1# 3#

Hardware Package B (For Step Bar Installation)

Item QTY Description Item QTY Description

1# 8M6X1-20mm Square Head Bolts 3# 8 M6 Nylon Lock Nuts

2# 8M6 Large Flat Washers

7 #

6 #

5 #

4 #

3 #

Customer Support: info@iboardauto.com

Rev. 20220401

iBoard

STEP 1

Start installation under the Driver Side Front Mounting Location.

Remove the large oval rubber cover located on the inner side

panel toward the front, (Fig 1). Insert (1) M8 Clip Nut into the

round hole (Fig 2). NOTE: Threaded nut must go towards the

inside of the side panel.

STEP 22

Select (1) Driver Front Mounting Bracket. Attach the Bracket to

the installed M8 Clip Nut with the included (1) M8X1.25-30mm

Hex Bolt, (1) M8 Lock Washer and (1) M8 Large Flat Washer,

(Fig 3).

Align the bottom holes in the front Bracket with the (1) hole in

the pinch weld (Fig 2). Bolt the Bracket to the pinch weld using

the included (1) M8X1.25-30mm Hex Bolt, (2) M8 Large Flat

Washers, (1) M8X1.25 Lock Washer and (1) M8 Hex Nut, (Fig

(Fig 1) Driver Side Front Mounting Location

(Fig 2) Insert M8 Clip Nut into the Round Hole

3).

NOTE: Insert the bolt up from the bottom of the pinch weld and

through the Bracket.

(Fig 3) Driver Front Mounting Bracket Installation

STEP 3

Next, move along the vehicle to the Driver Side Rear Mounting

Location, select a Driver Rear Mounting Bracket, repeat Steps

1-2 to install the rear bracket. Do not fully tighten hardware at

this time.

(Fig 4) Driver Rear Mounting Bracket Installation

Remove the Rubber

cover if equipped

(1) M8 Clip Nut

(1) M8X1.25-30mm Hex Bolt

(1) M8 Lock Washer

(1) M8 Large Flat Washer

(1) M8x1.25-25mm Hex Bolt

(2) M8 Large Flat Washers

(1) M8 Lock Washer

(1) M8X1.25 Hex Nut

(1) M8x1.25-25mm Hex Bolt

(2) M8 Large Flat Washers

(1) M8 Lock Washer

(1) M8X1.25 Hex Nut

(1) M8 Clip Nut

(1) M8X1.25-30mm Hex Bolt

(1) M8 Lock Washer

(1) M8 Large Flat Washer

The Bottom

Hole

Customer Support: info@iboardauto.com

Rev. 20220401

iBoard

STEP 4

Select a Running Board. Slip (2) M6X1-20mm Square Head

Bolts into each bottom channel (Fig 5). Carefully position the

Running Board onto the (2) Mounting Brackets. Attach the Run-

ning Board to each Mounting Bracket with (2) M6X1-20mm

Square Head Bolts, (2) M6 Large Flat Washers and (2) M6

Nylon Lock Nuts (Fig 6). Do not fully tighten at this time.

IMPORTANT: Do not slide the Running Board on the Brackets

or the bottom surface of the board will be damaged.

(Fig 5) Slip M6X1-20mm Square Head Bolts Into The Bottom

Channels

M6X1-20mm Square Head Bolts

STEP 6

Repeat Steps 1-5 for the other side Running Board installation.

The installation is completed .

Attention

Do periodic inspections to the installation to make

sure that all hardware is secure and tight.

In order to protect your bars/boards, please use mild

soap/non-abrasive products for cleaning only.

(Fig 6) Running Board Installed Onto Mounting Bracket

(2) M6X1-20mm Square Head Bolts

(2) M6 Large Flat Washers

(2) M6 Nylon Lock Nuts

STEP 5

Level and adjust the Running Board and fully tighten all hard-

ware.

Important: Please follow the recommended Tightening Tor-

ques shown in the table on page 1. Don’t over tighten, or

the nuts/bolts will be damaged.

Inhaltsverzeichnis

Andere APS Autozubehör Handbücher

APS

APS iArmor Bedienungsanleitung

APS

APS iBoard IB-R921 Bedienungsanleitung

APS

APS iBoard IB-R054 Bedienungsanleitung

APS

APS ELM205-V10 Bedienungsanleitung

APS

APS iBoard Bedienungsanleitung

APS

APS iArmor IA-S159 Bedienungsanleitung

APS

APS IA20SJI8B Bedienungsanleitung

APS

APS iArmor IA-S926H Bedienungsanleitung

APS

APS iBoard IB-R905 Bedienungsanleitung

APS

APS iArmor IA-S022 Bedienungsanleitung

APS

APS iBoard IB-R004 Bedienungsanleitung

APS

APS IA06SJD4B Bedienungsanleitung

APS

APS iBoard IB-R062 Bedienungsanleitung

APS

APS GR18GEC00U Bedienungsanleitung

APS

APS iBoard IB-019&020A-B Bedienungsanleitung

APS

APS iArmor Bedienungsanleitung

APS

APS IB14DBB5B Bedienungsanleitung

APS

APS IA04SBE8B Bedienungsanleitung

APS

APS iBoard IB-R922 Bedienungsanleitung

APS

APS iBoard IB-R911 Bedienungsanleitung

APS

APS GR18HEC11A Bedienungsanleitung

APS

APS iArmor Bedienungsanleitung

APS

APS IA10SAA1B Bedienungsanleitung

APS

APS IB03DJJ7A Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

APS iBoard IB-R009 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken