Arbor Technology ARTS-1450 Bedienungsanleitung

ARTS-1450

Fanless Vehicle PC with Intel®Atom™ E3845

User’s Manual

Version 1.0

2015.03

P/N: 4012145000100P

Revision History

Version Release Time Description

1.0 March, 2015 Initial release

- i -

Contents

Preface........................................................................................... iii

Declaration of Conformity .........................................................................iii

CE......................................................................................................iii

FCC Class A.......................................................................................iii

RoHS .................................................................................................iv

SVHC / REACH .................................................................................iv

Important Safety Instructions.................................................................... v

Warning .................................................................................................... v

Replacing Lithium Battery.........................................................................vi

Technical Support .....................................................................................vi

Warranty ..................................................................................................vii

Chapter 1 - Introduction................................................................ 1

1.1. Product Highlights ............................................................................. 2

1.2. About this Manual .............................................................................. 2

1.3. Specications .................................................................................... 3

1.5. Ordering Information.......................................................................... 5

1.5.1. Optional Accessories ............................................................... 5

1.5.2. Congure-to-Order Service...................................................... 6

Chapter 2 - Getting Started........................................................... 7

2.1. Dimensions........................................................................................ 8

2.2. Take A Tour ........................................................................................ 9

2.3. Driver Installation Notes .................................................................. 11

Chapter 3 - System Conguration ............................................. 13

3.1. Board Layout ................................................................................... 14

3.1.1. Main Boards........................................................................... 14

3.2. Jumpers and Connectors ................................................................ 16

3.2.1. Jumpers ................................................................................. 16

3.2.2. Connectors............................................................................. 20

Chapter 4 - Installation and Maintenance.................................. 39

4.1. Install Hardware............................................................................... 40

4.1.1. Open the Computer ............................................................... 40

4.1.2. Install/uninstall SIM Card ....................................................... 41

4.1.3. Install SATA SSD .................................................................. 43

4.1.4. Disassemble SSD bracket .................................................... 45

4.1.5. Install Memory Module on CPU Module ................................ 46

4.1.6. Insert a SD card..................................................................... 47

4.2. Mount the Computer........................................................................ 48

4.3. Wire DC-in Power Source................................................................ 49

4.31 Vehicle Application .................................................................. 49

4.3.2 Automation Application............................................................ 50

- ii -

Contents

Chapter 5 - BIOS.......................................................................... 51

5.1. Main................................................................................................. 54

5.2. Advanced......................................................................................... 55

5.2.1. Boot Conguration ................................................................. 56

5.2.2. PCI Express Conguration..................................................... 56

5.2.3. SATA Conguration................................................................ 56

5.2.4. SIO Fintek 81216................................................................... 57

5.2.5. H/W Monitor........................................................................... 57

5.3. Security............................................................................................ 58

5.4. Power .............................................................................................. 59

5.5. Boot ................................................................................................. 60

5.6. Exit................................................................................................... 61

Appendices .................................................................................. 63

Appendix A: HSPA-1450 Hardware Installation ...................................... 64

Appendix B: WIFI-AT2350 Hardware Installation ................................... 69

Appendix C: GPS Module Hardware Installation.................................... 74

Appendix D: CANBUS Module Hardware Installation ............................ 77

- iii -

Preface

The information in this document is subject to change without prior notice in order to

improve the reliability, design and function. It does not represent a commitment on the

part of the manufacturer.

Under no circumstances will the manufacturer be liable for any direct, indirect, special,

incidental, or consequential damages arising from the use or inability to use the product

or documentation, even if advised of the possibility of such damages.

This document contains proprietary information protected by copyright. All rights are

reserved. No part of this document may be reproduced by any mechanical, electronic, or

other means in any form without prior written permission of the manufacturer.

Declaration of Conformity

The CE symbol on the computer indicates that it is in compliance with the directives of

the Union European (EU). A Certicate of Compliance is available by contacting Technical

Support.

This product has passed the CE test for environmental specications when shielded

cables are used for external wiring. We recommend the use of shielded cables. This

kind of cable is available from ARBOR. Please contact your local supplier for ordering

information.

Warning

This is a class A product. In a domestic environment this product may cause

radio interference in which case the user may be required to take adequate

measures.

FCC Class A

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including

interference that may cause undesired operation.

Preface

- iv -

Preface

NOTE:

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated

in a commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

RoHS

ARBOR Technology Corp. certies that all components in its products are in compliance

and conform to the European Union’s Restriction of Use of Hazardous Substances in

Electrical and Electronic Equipment (RoHS) Directive 2002/95/EC.

The above mentioned directive was published on 2/13/2003. The main purpose of

the directive is to prohibit the use of lead, mercury, cadmium, hexavalent chromium,

polybrominated biphenyls (PBB), and polybrominated diphenyl ethers (PBDE) in electrical

and electronic products. Member states of the EU are to enforce by 7/1/2006.

ARBOR Technology Corp. hereby states that the listed products do not contain

unintentional additions of lead, mercury, hex chrome, PBB or PBDB that exceed a

maximum concentration value of 0.1% by weight or for cadmium exceed 0.01% by

weight, per homogenous material. Homogenous material is dened as a substance or

mixture of substances with uniform composition (such as solders, resins, plating, etc.).

Lead-free solder is used for all terminations (Sn(96-96.5%), Ag(3.0-3.5%) and Cu(0.5%)).

SVHC / REACH

To minimize the environmental impact and take more responsibility to the earth we live,

Arbor hereby conrms all products comply with the restriction of SVHC (Substances of

Very High Concern) in (EC) 1907/2006 (REACH --Registration, Evaluation, Authorization,

and Restriction of Chemicals) regulated by the European Union.

All substances listed in SVHC < 0.1 % by weight (1000 ppm)

- v -

Preface

Important Safety Instructions

Read these safety instructions carefully

1. Read all cautions and warnings on the equipment.

2. Place this equipment on a reliable surface when installing. Dropping it or letting it fall

may cause damage

3. Make sure the correct voltage is connected to the equipment.

4. For pluggable equipment, the socket outlet should be near the equipment and should

be easily accessible.

5. Keep this equipment away from humidity.

6. The openings on the enclosure are for air convection and protect the equipment

from overheating. DO NOT COVER THE OPENINGS.

7. Position the power cord so that people cannot step on it. Do not place anything over

the power cord.

8. Never pour any liquid into opening. This may cause re or electrical shock.

9. Never open the equipment. For safety reasons, the equipment should be opened

only by qualied service personnel.

10. If one of the following situations arises, get the equipment checked by service

personnel:

a. The power cord or plug is damaged.

b. Liquid has penetrated into the equipment.

c. The equipment has been exposed to moisture.

d. The equipment does not work well, or you cannot get it to work

according to the user’s manual.

e. The equipment has been dropped or damaged.

f. The equipment has obvious signs of breakage.

11. Keep this User’s Manual for later reference.

Product Heat

The computer generates heat during operation. Contact the computer's

chassis with your body could cause discomfort or even a skin burn.

Warning

- vi -

Preface

The Box PC and its components contain very delicately Integrated Circuits (IC). To protect

the Box PC and its components against damage caused by static electricity, you should

always follow the precautions below when handling it:

1. Disconnect your Box PC from the power source when you want to work on the inside.

2. Use a grounded wrist strap when handling computer components.

3. Place components on a grounded antistatic pad or on the bag that came with the Box

PC, whenever components are separated from the system.

Replacing Lithium Battery

Incorrect replacement of the lithium battery may lead to a risk of explosion.

The lithium battery must be replaced with an identical battery or a battery type

recommended by the manufacturer.

Do not throw lithium batteries into the trash can. It must be disposed of in

accordance with local regulations concerning special waste.

Technical Support

If you have any technical difculties, please consult the user’s manual rst at:

http://www.arbor.com.tw

Please do not hesitate to call or e-mail our customer service when you still cannot nd

out the answer.

http://www.arbor.com.tw

E-mail:info@arbor.com.tw

- vii -

Preface

Warranty

This product is warranted to be in good working order for a period of one year from the

date of purchase. Should this product fail to be in good working order at any time during

this period, we will, at our option, replace or repair it at no additional charge except as set

forth in the following terms. This warranty does not apply to products damaged by misuse,

modications, accident or disaster.

Vendor assumes no liability for any damages, lost prots, lost savings or any other

incidental or consequential damage resulting from the use, misuse of, or inability to use

this product. Vendor will not be liable for any claim made by any other related party.

Vendors disclaim all other warranties, either expressed or implied, including but not limited

to implied warranties of merchantability and tness for a particular purpose, with respect

to the hardware, the accompanying product’s manual(s) and written materials, and any

accompanying hardware. This limited warranty gives you specic legal rights.

Return authorization must be obtained from the vendor before returned merchandise will

be accepted. Authorization can be obtained by calling or faxing the vendor and requesting

a Return Merchandise Authorization (RMA) number. Returned goods should always be

accompanied by a clear problem description.

- viii -

This page is intentionally left blank.

Inhaltsverzeichnis

Andere Arbor Technology Autozubehör Handbücher

Arbor Technology

Arbor Technology FPC-9000-V1 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung