Argos 2 Door Robe Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

2 Door Robe

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 5 - 09/09/14

Important - Please read these instructions fully before starting assembly

249/3251

249/3660

244/2518

ALR3006

Width - 70.5cm

Depth - 51.5cm

Height - 183cm

NEW MK2 VERSION

Issue 2 - 11/06/13 - Rebates taken off Side panels - both gone up to issue B.

Issue 3 - 03/04/14 - Add 4 plastinails.

Remove old cat codes and add new ones.

Issue 4- 25/07/14 - Nail Holder is no longer used and has been removed.

Note:The Plasinails are now part G.

Issue 5- 09/09/14 - Removed‘Anderson’from the title so it can be used for both Anderson and Normandy.

Added 3 new cat codes for Normandy.

356/1003

343/3935

339/1194

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 48kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

x 2

6Door (D0530A)

(1724 x 345mm) x 2

3Top (D0532A)

(702 x 516mm)

4Horizontal (D0531A)

(670 x 490mm)

9Base (D0582A)

(670 x 490mm)

5Plinth (D0529A)

(670 x 80mm)

8Back (X754)

(1750 x 688mm)

Hanging Rail (FHR660)

(660mm long)

Left Side (D0527B)

(1808 x 491mm)

Right Side (D0528B)

(1808 x 491mm)

Please check you have all the fittings listed below

Components - Fittings

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 8

Metal dowel (F901) x 14

JHandle (F847a) x 2

aJHandle Screw (F847b) x 4

Hinge (F518) x 6

Hinge plate (F523) x 6

13mm Screw (F63) x 14

Rail holder

(F1014) x 2

Bracket (F327) x 1

13mm Screw (F79) x 1

Nail (F51) x 33

Large locking

nut (F900) x 14

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Step

ladder

Ruler - Use this ruler to help correctly identify the screws

Electric drill

(only use

when drilling

into walls)

mm 10 20 30 40 50 60 70 80 90 100

Plastic Nail (F91) x 4

Finished

front edge

Assembly Instructions

Step 1

80%

x 3

Prepare the left side

a: Screw 5 metal dowels

. into the holes shown

on the left side .

Note: Tighten metal

dowels up fully against

the panel.

Push a rail holder into

the hole shown. Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

b: Fit 3 hinge plates

onto the left side ,

making sure that the slot

is facing towards the

finished front edge.

Insert 2 large locking

nuts into the left side

. as shown.

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Tap a wooden dowel

into the left side as

shown.

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Finished

front edge

10mm

Assembly Instructions

Step 2

Prepare the right side

a: Screw 5 metal dowels

. into the holes shown

on the right side .

Note: Tighten metal

dowels up fully against

the panel.

Push a rail holder into

the hole shown. Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

b: Fit 3 hinge plates

onto the right side ,

making sure that the slot

is facing towards the

finished front edge.

Insert 2 large locking

nuts into the right

side as shown.

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Tap a wooden dowel

into the right side as

shown.

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 3

Prepare the horizontal

and base

Insert 4 large locking

nuts into both the

horizontal and the

base as shown.

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Tap 2 wooden dowels

into both the horizontal

. and the base as

shown.

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Join the horizontal

and base to the right

side

Push the horizontal

and base onto the

right side as shown.

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

both the horizontal

and base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 4

4 9

The base has a plain

chipboard surface

plain

chipboard

surface

Assembly Instructions

Step 5

Prepare the plinth

Insert 2 large locking

nuts into the plinth

as shown.

Tap 2 wooden dowels

into the plinth as

shown.

Fit the plinth

Push the plinth onto

the right side as

shown.

Use a screwdriver to

tighten the large locking

nut fitted to the plinth

. .

Note: Turn the large

locking nut as far as it

will go - more than 1/2 a

turn.

Step 6

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 5 large

locking nuts fitted to

the horizontal , plinth

. and base .

Step 7

5 9

Assembly Instructions

Step 8

Prepare the top

Screw 4 metal dowels

into the holes shown on

the top .

Fit the top

Push the top onto

the side panels and

. .

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the side panels and

. .

Step 9

Rounded

front edge

Rounded

front edge

Assembly Instructions

Step 10

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Fit the back and plas-

tic nails

a: Square up the unit by

making sure that

measurement x to x

equals y to y.

b: Place the back

onto the unit.

Nail around the

outside edges of the

back .

Note: Nails should

be spaced about 150mm

apart.

Tap 2 plastic nails into

the bottom edge of each

of the sides and . .

Stand the unit up for

the next step.

Warning: The

unit is heavy.

Lift with care.

1 2

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Home Tall Unit Shelf and Drawer 699/9524 Bedienungsanleitung

Argos

Argos Wow Hygena Bay 457/6169 Bedienungsanleitung

Argos

Argos Monk’s Bench Style Linen Bin 832/5299 Bedienungsanleitung

Argos

Argos 906/4638 Bedienungsanleitung

Argos

Argos Gabe Bedienungsanleitung

Argos

Argos Mia 3 Drawer Chest Bedienungsanleitung

Argos

Argos Camden 259/3773 Bedienungsanleitung

Argos

Argos Oslo Oak Table 603/3071 Bedienungsanleitung

Argos

Argos 389/6039 Bedienungsanleitung

Argos

Argos Twister CD/DVD tower Bedienungsanleitung

Argos

Argos 609/5741 Bedienungsanleitung

Argos

Argos Merrick 184/6335 Bedienungsanleitung

Argos

Argos Evelyn 340/3790 Bedienungsanleitung

Argos

Argos 600/1986 Bedienungsanleitung

Argos

Argos Home New Pagnell 601/9435 Bedienungsanleitung

Argos

Argos Marlow 417/7654 Bedienungsanleitung

Argos

Argos Scandinavia 615/6374 Bedienungsanleitung

Argos

Argos HOME 607/7446 Bedienungsanleitung

Argos

Argos Kids Sywell 246/7634 Bedienungsanleitung

Argos

Argos 280/0332 Bedienungsanleitung

Argos

Argos Rattan 752/6965 Bedienungsanleitung

Argos

Argos RONDA 8 SEATER CORNER DINING SET 7473441 Bedienungsanleitung

Argos

Argos HOME Apartment Tall Boy Bedienungsanleitung

Argos

Argos 620/4721 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung