Argos Camden 259/3773 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 116.5cm

Depth - 49.5cm

Height - 183.5cm

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 4 - 25/04/14

Important - Please read these instructions fully before starting assembly

259/3773

274/8944

ALR2987

Camden - 2 Drawer 3 Door Mirror Robe

Issue 2 -07/12/12 - Handle holes on the Doors altered to match the height of the handle on the 3 Door Robe.

An extra step has been added to show handle holes being drilled.

Issue 3 -12/12/13 - Extra cat code added.

Issue 4 - 25/04/14 - Drawer depth increased.

Old cat codes removed and new added.

The flange head screws for the backs have been replaced with 6 Nail Screws and Back Holders.

Brace Bars replaced with Wedgefixes.

Length of Backs increased to 1712mm.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 71kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 1, 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Rule

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Ruler - Use this ruler to help correctly identify the screws

Components - Panels

Please check you have all the panels listed below

1 2

80%

x 3

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

7 8

4 5

Hanging Rail (FHR343)

(343mm long)

Hanging Rail (FHR715)

(715mm long)

Mirror Door

(D2018MA)

(1345 x 358mm)

(Mirror - SG06

1344 x 358mm

Safety Back SAR)

Left Side (D2019A)

(1800 x 491mm)

Right Side (D2015A)

(1800 x 491mm)

Small Back Rail (D2013A)

(349.5 x 130mm)

Large Back Rail (D2014A)

(725.5 x 130mm)

Plinth (D2012A)

(1090 x 96mm) x 2

Horizontal (D2010A)

(1090 x 473mm)

Plain Door (D2018A)

(1345 x 358mm) x 2

Top (D2009A)

(1166 x 492mm)

Upright (D2016A)

(1344 x 472mm)

Drawer Front (D2017A)

(1084 x 173mm) x 2

Drawer Base (T1050-357)

(1050 x 357mm) x 2

Drawer Back (W1039-124)

(1039 x 124mm) x 2

Left Drawer Side

(W350-124LH)

(350 x 124mm) x 2

Right Drawer Side

(W350-124RH)

(350 x 124mm) x 2

18 Small Back

(X1712-363)

(1712 x 363mm)

19 Large Back (X940)

(1712 x 740mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

B C

D E F

G H I

Nail (F51) x 38

Hinge plate

(F523) x 9

Rail Holder

(F891) x 4 13mm Screw (F63) x 38

Hollow core

locking nut

(F892) x 4

Small metal dowel (F893) x 4

Metal dowel (F901) x 16

Large locking

nut (F900) x 14

Wooden dowel (F22) x 12

Bracket (F327) x 1

Small locking

nut (F3) x 4

19mm Screw (F461) x 8

Knock-in Peg (F171) x 8

Double metal dowel (F566) x 1

13mm Screw (F52) x 12

13mm Screw (F79) x 1

Hinge (F522) x 9

40mm Screw (F910) x 2

Handle (F309) x 4

432mm

Wedgefix

(F639) x 8

Nail screw (F277) x 6 Back holder (F276) x 6

*These can

also be round

R Runner (F160) x 1

L Runner (F161) x 1

L Runner (F159) x 1

R Runner (F162) x 1

350mm long

Assembly Instructions If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Prepare the 2 drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten metal

dowels up fully against

the panels.

Prepare drawer sides

and drawer backs

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

x 2

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Groove

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

x 2 x 2

13 14

Assembly Instructions

Step 4

Step 5

x 2

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

13 14

Attach the handles

Attach a handle to

each drawer front

using 2 screws .

Step 6

x 2

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

13 14

11 x 2

Assembly Instructions

Step 7

Step 8

x 2

Fit the runners to the

drawers

Fit the runner to the

bottom edge of the left

drawer side , as

shown, making sure that

it is pushed up against

the back of the drawer

front . Use a bradawl

to mark the fixing

positions, then secure

with 2 screws .

Fit the runner to the

bottom edge of the right

drawer side using the

same method.

S c

S d

Fit the wedgefixes

Turn the 2 drawer

assemblies over and

slide 4 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

x 2

Runners must be

pushed up against

the drawer front

S d

S c

Finished

front edge

Assembly Instructions

Step 9

Prepare the upright

a: Tap 2 wooden

dowels into the ends

of the upright .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the upright . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Turn upright panel over

Turn the upright over

10mm

b: Fit 3 hinge plates

onto the upright ,

making sure that the slot

is facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the upright . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Insert 2 large locking

nuts into the upright.

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Finished

front edge

Assembly Instructions

Step 10

Prepare the top

Screw 4 small metal

dowels into the holes

on the top .

Screw 2 metal

dowels into the holes

on the top .

Note: Tighten metal

dowels up fully against

the panels.

Step 11

Prepare the horizontal

Insert 4 large locking

nuts into the

horizontal .

Tap 2 wooden dowels

into the horizontal .

plain chipboard surface

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 12

Fit the horizontal to

the upright

Push the horizontal

onto the upright and

secure using 2 screws .

Fit the upright to the

top

Push the top onto

the upright .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the upright .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 13

Step 14

Finished

front edge

Finished

front edge

plain chipboard surface

Prepare the small

back rail

Insert 2 large locking

nuts into the small

back rail .

Tap 2 wooden dowels

into the small back rail

. .

Finished

front edge

Plain chipboard

surface

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Aubrey 549/6516 Bedienungsanleitung

Argos

Argos HOME Bedienungsanleitung

Argos

Argos Penelope Ottoman 899/8190 Bedienungsanleitung

Argos

Argos Wow Raye Wooden Chair Bedienungsanleitung

Argos

Argos Adult Malibu 532/8038 Bedienungsanleitung

Argos

Argos ColourMatch Gas Lift Bar Stool 600/6060 Bedienungsanleitung

Argos

Argos Capella 615/6831 Bedienungsanleitung

Argos

Argos 4FT6 BED FRAME Bedienungsanleitung

Argos

Argos Malibu 305/1764 Bedienungsanleitung

Argos

Argos PENTON 490/9475 Bedienungsanleitung

Argos

Argos Silbury 4142919 Bedienungsanleitung

Argos

Argos 496/1932 Bedienungsanleitung

Argos

Argos 487/8317 Bedienungsanleitung

Argos

Argos AVR 4 Seater Patio Set Bedienungsanleitung

Argos

Argos Tolga 460/4378 Bedienungsanleitung

Argos

Argos Ottawa 600/0444 Bedienungsanleitung

Argos

Argos 548/5259 Bedienungsanleitung

Argos

Argos 758/5432 Bedienungsanleitung

Argos

Argos Dutch Glam 846/1108 Bedienungsanleitung

Argos

Argos SKYE WOOD Datenblatt

Argos

Argos 356/3018 Bedienungsanleitung

Argos

Argos 833 /3559 Bedienungsanleitung

Argos

Argos avignon 544/2687 Bedienungsanleitung

Argos

Argos Capella Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung