Argos 357/7097 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 63cm

Depth - 39cm

Height - 75cm

Capella - 3+2 Drawer Chest

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 1 - 28/11/14

Important - Please read these instructions fully before starting assembly

357/7097

330/7559

339/2344

ALR3120

03/08/11 - Drawer assembly changed to Knock-in Pegs.

Drawer Sides and Drawer Back changed to take Knock-in Pegs.

Issue 4 - 16/05/12 - New Argos code added

Issue 5 - 27/03/14 - Increase drawer size.

Add 6 drawer wedges.

Add 4 Plastinails.

Remove old cat codes and add new ones

Issue 6 - 09/05/14 - Increased drawer wedges to 12.

Added‘x3’ to the Drawer Side, Drawer Back and Drawer Base on the components page.

Issue 7 - 21/05/14 - Changed wording at Steps 8B and 9B from“use the third hole from the back” to“use the corresponding hole”.

Step 12 diagram amended to show correct Dowel position.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 24kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Large Drawer Front (D1010A)

(592 x 157mm) x 3

Back (X647-622A)

(647 x 622mm)

Large Drawer Base (T575-367)

(575 x 367mm) x 3

8 9

Small Drawer Back (W259 -124)

(259 x 124mm) x 2

Left Drawer Side (W370-124LH)

(370 x 124mm) x 5

Right Drawer Side (W370-124RH)

(370 x 124mm) x 5

Left Side (D1039A)

(744 x 390mm)

Small Left Drawer Front

(DF1852A) (294 x 157mm)

Right Side (D1040A)

(744 x 390mm)

Small Right Drawer Front

(DF1853A) (294 x 157mm)

3Top (DF1848A)

(596 x 369mm)

Rail (D1009A)

(596 x 103mm) x 2

14 Small Drawer Base (T270-367)

(270 x 367mm) x 2

11 Large Drawer Back (W564 -124)

(564 x 124mm) x 3

Divider (DF1851A)

(368 x 155mm)

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 8

Metal dowel (F901) x 20

D E

Large locking

nut (F900) x 10

G H I

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Small locking

nut (F3) x 10

Nail (F51) x 16

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Drawer runner (F1004) x 10

Handle (F930) x 5

25mm Screw (F50) x 10 9mm Screw (F74) x 10 9mm Screw (F73) x 20

Knock-in Peg (F171GY) x 20

Plastic Nail (F91) x 4

Wedgefix (F639) x 16

NStrap

Screw Washer x 2

Overbalance protector kit (F269) x 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 3

Prepare the drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each large

drawer front .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

Step 3

x 3

Attach the drawer

sides to the drawer

fronts

Push the left drawer sides

. and right drawer sides

. onto the back of the

large drawer fronts .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Assembly Instructions

Step 4

Attach the handle

Attach a handle to

each large drawer front

using 2 screws .

Step 6

x 3

Fit the large drawer

base

Slide the large drawer

base down the

grooves in the drawer

sides and and

down into the groove in

the large drawer front .

Step 5

Fit the large drawer

back

Fit the large drawer back

. between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

8 9

x 3

8 9

Fit the wedgefixes

Turn the large drawer

assemblies over and

slide 4 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

Step 7

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 8

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 9

Step 10

x 2 x 2

Step 1

x 2

Prepare the 2 small

drawer fronts

Screw 2 metal dowels

into the small left drawer

front and the small

right drawer front .

Note: Tighten the metal

dowels up fully against

the panels.

Attach the drawer

sides to the small

drawer fronts

Push the left drawer sides

. and right drawer sides

. onto the back of the

2 small drawer fronts

and .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

6 7

Note: The small right

drawer front has a shallow

identification mark.

Assembly Instructions

Step 11

Fit the small drawer

base

Slide the small drawer

base down the

grooves in the drawer

sides and and

down into the groove in

the small drawer fronts

. and .

Step 12

Fit the small drawer

back

Fit the small drawer back

. between the drawer

sides and .

Make sure that the small

drawer base fits into

the groove in the small

drawer back .

Hold the small drawer

back in position and

tap the knock-in pegs

through the holes in the

drawer sides and .

Step 13

8 9

6 7

8 9

Attach the handles

Attach a handle to

each small drawer front

. and using 2

screws .

Note: Do not

overtighten the screw.

6 7

x 2

8 9

x 2

Step 14

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

Profiled

front edge

Profiled

front edge

Profiled

front edge

Assembly Instructions

Step 15

Profiled

front edge

Back edge

Prepare the left side

a: Place 4 runners on

the left side . Slide

back the top of the

runner and use the 1st

hole from the front to fit

the 1st screw .

b: Slide the runner back

the other way and use

the 3rd hole from the

back to fit the 2nd screw

c: Screw 4 metal

dowels into the left

side .

Assembly Instructions

Step 16

Prepare the right side

a: Place 4 runners on

the right side . Slide

back the top of the

runner and use the 1st

hole from the front to fit

the 1st screw .

b: Slide the runner back

the other way and use

the 3rd hole from the

back to fit the 2nd screw

. .

c: Screw 4 metal

dowels into the right

side .

Profiled

front edge

Back edge

Profiled

front edge

Profiled

front edge

Profiled

front edge

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 709/2626 Bedienungsanleitung

Argos

Argos 603/7840 Bedienungsanleitung

Argos

Argos SAN DIEGO 412/2214 Bedienungsanleitung

Argos

Argos hygena 464/3597 Bedienungsanleitung

Argos

Argos 600/0774 Bedienungsanleitung

Argos

Argos Home New Pagnell 601/9435 Bedienungsanleitung

Argos

Argos WILLOW 4814443 Bedienungsanleitung

Argos

Argos Tolga 483/8364 Bedienungsanleitung

Argos

Argos Double Tidy Rail Bedienungsanleitung

Argos

Argos 932/7722 Bedienungsanleitung

Argos

Argos 831/9188 Bedienungsanleitung

Argos

Argos 338/8619 D Bedienungsanleitung

Argos

Argos Tolga 414/5758 Bedienungsanleitung

Argos

Argos 609/2263 Bedienungsanleitung

Argos

Argos 246/6848 Bedienungsanleitung

Argos

Argos 482/0688D Bedienungsanleitung

Argos

Argos 365/9654 Bedienungsanleitung

Argos

Argos Amalfi 1455056 Bedienungsanleitung

Argos

Argos Normandy 428/2611 Bedienungsanleitung

Argos

Argos Le Marais Double Unit Grey 502/6797 Bedienungsanleitung

Argos

Argos Aspley 497/1379 Aspley 483/8209 Bedienungsanleitung

Argos

Argos SAN DIEGO 408/8365 Bedienungsanleitung

Argos

Argos Corners 9583119 Bedienungsanleitung

Argos

Argos Cheval 258/7260 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung