Argos Anderson 2 plus 2 Sideboard Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 80cm

Depth - 40cm

Height - 77.5cm

Anderson - 2+2 Sideboard

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800

Important - Please read these instructions fully before starting assembly

Issue 9 - 28/04/15

ALR2742

Issue 2 - 15/05/12 - Back size reduced by 3mm. Rebate removed from top in stage 18.

Issue 3 - 17/05/12 - Extra holes added to doors to fit handles at top of door. Instructions added for customer to drill doors

Issue 4 - 04/07/12 - Plinth changed to 762 x 60mm.

NEW MK3 VERSION

Issue 5 - 05/03/13 - Rebates taken off, panel numbers updated.

289/8533

609/5538

Issue 6 - 25/07/14 - Nail Holder is no longer used and has been removed.

Note: Bracket is now part C and the Handle and its Screw are now parts L

Issue 7 - 20/01/15 - Overbalance bracket replaced with Strap.

Updated helpline number.

Issue 8 - 23/01/15 - Replaced Argos code 609/5552 with 289/8533

412/7714

Issue 9 - 28/04/15 - New Argos added - 412/7714.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 28kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Tools required

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Electric drill

(do not use for

fitting screws)

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

overbalance protector kit

supplied or, an alternative fixing

method of your choice.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Left Drawer Side (W509LH)

(330 x 115mm) x 2

Right Drawer Side (W509RH)

(330 x 115mm) x 2

Drawer Base (T603)

(333 x 327mm) x 2

Drawer Back (W537)

(321 x 115mm) x 2

119 10

Left Side (D2182A)

(747 x 375mm)

Top (D2184A)

(796 x 396mm)

Divider (D1528A)

(150 x 371mm)

Right Side (D2183A)

(747 x 375mm)

Door (D2262A)

(524 x 390mm) x 2

Plinth (D2265A)

(762 x 60mm)

Drawer Front (D2263A)

(390 x 157mm) x 2

Base (D2185A)

(762 x 374mm)

Shelf (D2261A)

(762 x 368mm)

Back (X786-705)

(786 x 705mm)

Divider (D2260A)

(150 x 374mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 4

Metal dowel (F901) x 14

Large locking

nut (F900) x 10

Small locking

nut (F3) x 4

G H I

Nail (F51) x 21

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

13mm Screw (F52) x 8

13mm Screw (F63) x 16

Shelf stud (F110) x 4

Knock-in Peg (F171) x 8

JHandle (F847a ) x 4

aJHandle Screw (F847b) x 8

Hinge (F518) x 4

Hinge plate

(F523) x 4

NR Runner (F160) x 2

L Runner (F161) x 2

L Runner (F159) x 2

R Runner (F162) x 2

KStrap

Screw Washer x 2

Overbalance protector kit (F269) x 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Step 1

x 2 x 2

x 2

Step 2

Prepare the drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Groove

FFF

910

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Assembly Instructions

Step 4

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 6

9 10

Attach the handle

Attach a handle to

each drawer front

using 2 screws .

x 2

J a

J b

J a

J b

Finished

front edge A

Assembly Instructions

Step 7

Fit runners to the

drawers

Fit the runner to the

bottom edge of the left

drawer side , as

shown, making sure that

it is pushed up against

the back of the drawer

front . Use a bradawl

to mark the fixing

positions, then secure

with 2 screws .

Fit the runner to the

bottom edge of the right

drawer side using the

same method.

Turn the drawers over

N c

N d

Runners must be

pushed up against

the drawer front

N c N d

Prepare the left side

Tap a wooden dowel

into the left side .

Screw 3 metal dowels

into the left side .

Insert a large locking

nut into the left side

. .

Fit the runner to the

left side .

The 1st screw uses

the 2nd hole in from the

front of the runner .

The 2nd screw uses

the hole that lines up

with the other panel hole.

Fit 2 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

Step 8

N a

10mm

N a

Finished front edge

1st

screw

2nd

screw

Note: Wooden dowels must

not stick out from the edge

by more than 10mm or they

may damage other panels.

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

N a

x 2

Assembly Instructions

Step 9

Step 10

Prepare the base

Insert 4 large locking

nuts into the base

N b

Finished front edge

I1st

screw

2nd

screw

Prepare the right side

Tap a wooden dowel

into the right side .

Screw 3 metal dowels

into the right side .

Insert a large locking

nut into the right side

. .

Fit the runner to the

right side .

The 1st screw uses

the 2nd hole in from the

front of the runner .

The 2nd screw uses

the hole that lines up

with the other panel hole.

Fit 2 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

N b

plain chipboard surface

Finished

front edge

E4.

Finished

front edge

Assembly Instructions

Step 11

Prepare the plinth

Tap 2 wooden dowels

into the plinth .

Insert 2 large locking

nuts into the plinth

Step 12

Fit the plinth

Push the plinth onto

the right side .

Use a screwdriver to

tighten the large locking

nut fitted to the plinth

. .

Step 13

Join the right side and

base

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

plain chipboard surface

Assembly Instructions

Step 14

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 3 large

locking nuts fitted to

the base and plinth

. .

Step 15

Prepare the top

Screw 4 metal dowels

into the top .

Dieses Handbuch passt für folgende Modelle

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Camden 239/9472 Bedienungsanleitung

Argos

Argos Amalfi 1455056 Bedienungsanleitung

Argos

Argos SKYE WOOD 476/7538 Bedienungsanleitung

Argos

Argos Home Jenson 926/9567 Bedienungsanleitung

Argos

Argos 831/8701 Bedienungsanleitung

Argos

Argos Nordic 3 Drawer Chest Bedienungsanleitung

Argos

Argos Under Basin Unit 833/2763 Bedienungsanleitung

Argos

Argos Puerto Rico 641/8720 Bedienungsanleitung

Argos

Argos 481/3640 Bedienungsanleitung

Argos

Argos Hygena Bedienungsanleitung

Argos

Argos Scandinavia Bedienungsanleitung

Argos

Argos Eden 412/3062 Bedienungsanleitung

Argos

Argos Kensington 411/7542 Bedienungsanleitung

Argos

Argos HOME Doublebed White 4Ft Bedienungsanleitung

Argos

Argos Dutch Glam 846/1108 Bedienungsanleitung

Argos

Argos Beech Effect TV Bench 609/0162 Bedienungsanleitung

Argos

Argos Atlas Internal Cube 339/5176 Bedienungsanleitung

Argos

Argos TOBY 8559230 Bedienungsanleitung

Argos

Argos Ohio 309/5256 Bedienungsanleitung

Argos

Argos Costa Swivel Chair 6893307 Bedienungsanleitung

Argos

Argos Malibu 617/1225 Bedienungsanleitung

Argos

Argos Perth 423/8029 Bedienungsanleitung

Argos

Argos Aubrey 549/6516 Bedienungsanleitung

Argos

Argos Walton 166/2629 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung