Argos Cheval 147/5634 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

of each

cupboard

Width - 76cm

Depth - 39.5cm

Height - 50cm

Cheval - Overbed Cupboards

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 1 - 20/01/14

Important - Please read these instructions fully before starting assembly

ALR2971

147/5634

151/3314

146/9918

144/1390

We recommend that you assemble any

Cheval Robe(s) you may have purchased

BEFORE you assemble these cupboards.

This will enable you to measure the correct

space and height required for the cupboards.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: The combined

weight of the units is

approximately 47kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

brackets supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

4 5

6 7

Left Side (D2761A)

(484 x 372mm) x 3

Door (D2765A)

(480 x 373mm) x 6

Right Side (D2762A)

(484 x 372mm) x 3

Back (X738-476)

(738 x 476mm) x 3

Base (D2764A)

(728 x 371mm) x 3

Shelf (D2773A)

(727 x 350mm) x 3

3Top (D2763A)

(760 x 393mm) x 3

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

see malibu fitment mk2 for large number of panels and fittings

Wooden dowel (F22) x 12

Metal dowel (F901) x 24

D E

Large locking

nut (F900) x 24

G H I

J K

19mm Screw (F461) x 20

13mm Screw (F63) x 24

Handle (F273) x 6

25mm Screw (F50) x 12

Hanging bracket

(F849) x 6

Wall bracket (F198) x 6

Tools required

Rule

Scissors

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

Square

mm 10 20 30 40 50 60 70 80 90 100

Connecting Sleeve (F432) x 8 Shelf stud (F110) x 12

L M

Hinge plate

(F523) x 12 Hinge (F518) x 12

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Prepare the left side

Screw 2 metal dowels

into the left side .

Note: Tighten the metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the left side

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Fit 2 hinge plates onto

the left side , making

sure that the slot is

facing towards the

finished front edge.

Fit a hanging bracket

to the left side using

2 screws , making

sure that the hook is

towards the back edge.

Step 2

80% C

Prepare drawer fronts

and wraps x 3

a: Screw 2 metal dowels

. into the holes on the

back of the drawer fronts

. .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the right side

Screw 2 metal dowels

into the right side .

Insert 2 large locking

nuts into the right

side .

Fit 2 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

Fit a hanging bracket

to the right side using

2 screws , making

sure that the hook is

towards the back edge.

Finished

front edge

Finished

front edge

These instructions will show you

how to build 1 overbed cupboard

Finished

front edge

Assembly Instructions

Fit the base to the

right side

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 3

Step 4

10mm

Prepare the base

Tap 4 wooden dowels

into the base .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the base .

Finished

front edge

Fit the back

Slide the back along

the groove in the base

and on into the groove in

the right side .

Important: Make sure

that the cut-outs on the

back are at the top of

the assembly.

Step 5

Note: Support the

back panel until the

left side has been

fitted in the next step.

Cut-outs

at the top

Assembly Instructions

Step 6

Fit the left side

Push the left side

onto the base

making sure that the

back slots into the

groove.

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Hold the back in

place and carefully stand

the unit up

Prepare the top

Screw 4 metal dowels

into the top .

Step 7

Fit the top

Lower the top down

onto the assembly,

making sure that the

back slots into its

groove.

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the sides and .

Step 8

Finished

front edge

1 2

722mm

Assembly Instructions

Step 9

Step 10

18mm

37mm

722mm

18mm

K K

Outline of

the unit

To adjust the height of

the unit on the wall,

turn the bottom screw

Pull the unit up

against the wall

by tightening

the top screw

Warning: The

unit is heavy.

Lift with care.

Fit the unit to the wall

To fix the unit to the wall,

place the unit in the

required position and

lightly mark the outline of

the top corners of the

unit with a pencil.

Fit the 2 wall brackets

to the dimensions shown

in the top diagram.

The screws and plugs

are not supplied as they

need to be the correct

type to suit your wall.

Place your unit onto the

wall brackets , via the

hanging brackets

which you have fitted to

the sides and of

the unit.

Turn the lower screw in

the wall brackets to

adjust the height of the

unit.

Finally, pull the unit up

against the wall by

tightening the top screw

in the hanging brackets

. .

Warning: Take

care when

drilling the wall

that you do not drill into

any pipes, wires etc. If in

doubt, consult an expert.

1 2

IMPORTANT

If you are fitting these cupboards between

two robes or, a robe and a wall, please

measure the space required to fit the

cupboards and the height of the robe(s)

Assembly Instructions

Step 10

Joining units together

Fittings have been

supplied so you are able

to join the units together.

If required, position any

robes that you have

assembled up against

the cupboards.

Using a 5mm drill bit,

drill through the two

5mm part-drilled holes in

the side panel into the

adjoining side panel of

the other unit.

Push the connecting

sleeves into the holes

and then screw the

screws in from the

other side.

5mm G

Assembly Instructions

Step 11

Step 10

Hx 4

Fit the shelf

Insert 4 shelf studs at

the required height.

Lower the shelf down

onto the shelf studs .

Step 12

Prepare the 2 doors

Push fit 2 hinges into

each of the doors .

Secure each hinge with

2 screws .

Note: Before securing

with the screws, make

sure that the hinges are

positioned at 90 degrees

with the edge of the

door.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Malibu 621/3310 Bedienungsanleitung

Argos

Argos Wow Raye 322/5837 Bedienungsanleitung

Argos

Argos 487/8317 Bedienungsanleitung

Argos

Argos Nest of Tables 609/1439 Bedienungsanleitung

Argos

Argos Eden 412/3062 Bedienungsanleitung

Argos

Argos 044 0502 Series Bedienungsanleitung

Argos

Argos Camden 305/0772 Bedienungsanleitung

Argos

Argos ColourMatch Gas Lift Bar Stool 600/6060 Bedienungsanleitung

Argos

Argos Wow Pine Kitchen Trolley 424/6963 Bedienungsanleitung

Argos

Argos Iceland 178/6361 Bedienungsanleitung

Argos

Argos Jenson Bedienungsanleitung

Argos

Argos Home New Pagnell 601/9435 Bedienungsanleitung

Argos

Argos 609/7024 Bedienungsanleitung

Argos

Argos Ohio 309/5256 Bedienungsanleitung

Argos

Argos 609/1006 Bedienungsanleitung

Argos

Argos Hygena 600/5968 Bedienungsanleitung

Argos

Argos White Media Storage Unit With Glass Doors... Bedienungsanleitung

Argos

Argos Brixham 617/9131 Bedienungsanleitung

Argos

Argos Princess Dining Chair 398/1298 Bedienungsanleitung

Argos

Argos SAN DIEGO 408/8365 Bedienungsanleitung

Argos

Argos Star 7607729 Bedienungsanleitung

Argos

Argos Stratford White Bedienungsanleitung

Argos

Argos 875/7276 Bedienungsanleitung

Argos

Argos 932/7502 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung