Argos Camden 305/0772 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 116.5cm

Depth - 49.5cm

Height - 183.5cm

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 3 - 12/12/13

Important - Please read these instructions fully before starting assembly

305/0772

305/0765

ALR2833

Camden - 2 Drawer 3 Door Mirror Robe

Issue 2 -07/12/12 - Handle holes on the Doors altered to match the height of the handle on the 3 Door Robe.

An extra step has been added to show handle holes being drilled.

Issue 3 -12/12/13 - Extra cat code added.

162/3204

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 76kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 1, 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Rule

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

Components - Panels

Please check you have all the panels listed below

1 2

80%

x 3

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

7 8

4 5

Hanging Rail (FHR343)

(343mm long)

Hanging Rail (FHR715)

(715mm long)

11 13

18 19 Foldy Back (X946)

(1368 x 740mm)

Mirror Door

(D2018MA)

(1345 x 358mm)

(Mirror - SG06

1344 x 358mm

Safety Back SAR)

Left Side (D2019A)

(1800 x 491mm)

Right Side (D2015A)

(1800 x 491mm)

Small Back Rail (D2013A)

(349.5 x 130mm)

Large Back Rail (D2014A)

(725.5 x 130mm)

Plinth (D2012A)

(1090 x 96mm) x 2

Horizontal (D2010A)

(1090 x 473mm)

Plain Door (D2018A)

(1345 x 358mm) x 2

Top (D2009A)

(1166 x 492mm)

Upright (D2016A)

(1344 x 472mm)

Drawer Front (D2017A)

(1084 x 173mm) x 2

Drawer Base (T559)

(1050 x 317mm) x 2

Drawer Back (W559)

(1039 x 105mm) x 2

Left Drawer Side (W418LH)

(320 x 105mm) x 2

Right Drawer Side (W418RH)

(320 x 105mm) x 2

Back (X947)

(1368 x 363mm)

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Ruler - Use this ruler to help correctly identify the screws

B C

D E F

G H I

Nail (F51) x 38

Hinge plate

(F523) x 9

Rail Holder

(F891) x 4 13mm Screw (F63) x 38

Hollow core

locking nut

(F892) x 4

Small metal dowel

(F893) x 4

Metal dowel (F901) x 16

Large locking

nut (F900) x 14

Wooden dowel (F22) x 12

Bracket (F327) x 1

Small locking

nut (F3) x 4

19mm Screw (F461) x 8

Knock-in Peg (F171) x 8

Double metal dowel (F566) x 1

13mm Screw (F52) x 12

SR Runner (F160) x 2

L Runner (F161) x 2

L Runner (F159) x 2

R Runner (F162) x 2

13mm Screw (F79) x 13

Hinge (F522) x 9

Brace bar (F177) x 2

40mm Screw (F910) x 2

Handle (F309) x 4

432mm

307mm

Assembly Instructions If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

I13

Prepare the 2 drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten metal

dowels up fully against

the panels.

Prepare drawer sides

and drawer backs

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

x 2

x 2 x 2

x 2

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Groove

Assembly Instructions

Step 4

Step 5

x 2

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

13 14

Attach the handles

Attach a handle to

each drawer front

using 2 screws .

Step 6

x 2

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

13 14

11 x 2

Assembly Instructions

Step 7

Step 8

x 2

Fit runners to the

drawers

Fit the runner to the

bottom edge of the left

drawer side , as

shown, making sure that

it is pushed up against

the back of the drawer

front . Use a bradawl

to mark the fixing

positions, then secure

with 2 screws .

Fit the runner to the

bottom edge of the right

drawer side using the

same method.

S c

S d

Fit the brace bars

Turn the 2 drawer

assemblies over and fit a

brace bar to each

one.

Position the brace bar

in the middle of the

drawer base between

the drawer front and

drawer back .

Once in position secure

the brace bar with 2

screws .

x 2

Runners must be

pushed up against

the drawer front

S c

S d

Finished

front edge

Assembly Instructions

Step 9

Prepare the upright

a: Tap 2 wooden

dowels into the ends

of the upright .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the upright . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Turn upright panel over

Turn the upright over

10mm

b: Fit 3 hinge plates

onto the upright ,

making sure that the slot

is facing towards the

finished front edge.

To fit the rail holder ,

screw through the top

hole with screw and

into the mark hole drilled

in the upright . Make

sure that it is fitted

straight, in line with the

panel edges and then fit

another screw using

the lower hole.

Insert 2 large locking

nuts into the upright.

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Finished

front edge

Assembly Instructions

Step 10

Prepare the top

Screw 4 small metal

dowels into the holes

on the top .

Screw 2 metal

dowels into the holes

on the top .

Note: Tighten metal

dowels up fully against

the panels.

Step 11

Prepare the horizontal

Insert 4 large locking

nuts into the

horizontal .

Tap 2 wooden dowels

into the horizontal .

plain chipboard surface

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 12

Fit the horizontal to

the upright

Push the horizontal

onto the upright and

secure using 2 screws .

Fit the upright to the

top

Push the top onto

the upright .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the upright .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 13

Step 14

Finished

front edge

Finished

front edge

plain chipboard surface

Prepare the small

back rail

Insert 2 large locking

nuts into the small

back rail .

Tap 2 wooden dowels

into the small back rail

. .

Finished

front edge

Plain chipboard

surface

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Trestle Datenblatt

Argos

Argos 602/9748 Bedienungsanleitung

Argos

Argos Capella 268/1647 Bedienungsanleitung

Argos

Argos 603/7840 Bedienungsanleitung

Argos

Argos Malibu 279/6288 Bedienungsanleitung

Argos

Argos Dutch Glam Boutique Coffee Table Bedienungsanleitung

Argos

Argos SKYE WOOD 476/7538 Bedienungsanleitung

Argos

Argos 619/1834 Bedienungsanleitung

Argos

Argos Arizona 4607904 Bedienungsanleitung

Argos

Argos Canterbury 4 DR 6 DRW ROBE Bedienungsanleitung

Argos

Argos HOME Bedienungsanleitung

Argos

Argos Home New Pagnell 601/9435 Bedienungsanleitung

Argos

Argos BALI TV UNIT OMO Bedienungsanleitung

Argos

Argos Adele 247/9866 Bedienungsanleitung

Argos

Argos Wooden Filer Bedienungsanleitung

Argos

Argos Aurora 158/9544 Bedienungsanleitung

Argos

Argos Chicago Dining Set Bench Bedienungsanleitung

Argos

Argos AVR 4 Seater Patio Set Bedienungsanleitung

Argos

Argos New Sywell 282/7920 Bedienungsanleitung

Argos

Argos Malibu Double Cupboard MK2 Bedienungsanleitung

Argos

Argos 875/4664 Bedienungsanleitung

Argos

Argos Hygena 833/4448 Bedienungsanleitung

Argos

Argos TC Marston White Shake XL Blanket Box... Bedienungsanleitung

Argos

Argos 355/3932 D Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung