Argos Lima Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 79.5cm

Depth - 39cm

Height - 51cm

Lima - Corner TV Unit

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 1 - 01/07/14

Important - Please read these instructions fully before starting assembly

276/4296

ALR3075

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 14kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Upright (D1319A)

(477 x 280mm)

Plinth (D1320A)

(721 x 96mm)

Top (D1315A)

(795 x 391mm)

Horizontal (D1318A)

(721 x 352mm) x 2

6Drawer Front (D1913A)

(717 x 200mm)

Left Drawer Side (W454LH)

(200 x 115mm)

Right Drawer Side (W454RH)

(200 x 115mm)

Drawer Base (T454)

(700 x 197mm)

Side (D1912A)

(477 x 230mm) x 2

Drawer Back (W454)

(689 x 115mm)

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 2

Metal dowel (F901) x 14

D E

Large locking

nut (F900) x 12

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

Small metal dowel (F893) x 4

Hollow core

locking nut

(F892) x 4

45mm Screw (F65) x 4

Small locking

nut (F3) x 2

19mm Screw (F461) x 2

Knock-in Peg (F171) x 4

Drawer runner (F307) x 2

J K

9mm Screw (F74) x 2 9mm Screw (F73) x 4

Handle (F306) x 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Prepare the drawer

front

Screw 2 metal dowels

into the holes shown on

the back of the drawer

front .

Note: Tighten metal

dowels up fully against

the panel.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Small groove

Assembly Instructions

Step 4

Attach the handle

Attach the handle to

the drawer front

using 2 screws .

Step 6

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

7 8

Assembly Instructions

Step 7

Prepare the left side

a: Place a runner

onto one of the sides .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the side .

c: Screw 5 metal

dowels into the side

. .

Push 2 hollow core

locking nuts into the

side , making sure

that they are flush

against the panel’s

surface.

Using a hammer, tap in

the pin on the hollow

core locking nut .

Note: The pin should be

tapped in flush with the

top surface of the hollow

core locking nut .

front edge

back edge

Assembly Instructions

Step 8

Prepare the right side

a: Place a runner

onto one of the sides .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the side .

c: Screw 5 metal

dowels into the side

. .

Push 2 hollow core

locking nuts into the

side , making sure

that they are flush

against the panel’s

surface.

Using a hammer, tap in

the pin on the hollow

core locking nut .

Note: The pin should be

tapped in flush with the

top surface of the hollow

core locking nut .

Front edge

Back edge

Assembly Instructions

Step 9

Step 10

Prepare the top

Screw 2 metal dowels

into the top .

Screw 4 small metal

dowels into the holes

on the top .

Note: Tighten metal

dowels up fully against

the panels.

Join the top to a side

Attach the top to the

right side .

Note: You will need to

slide the 2 small metal

dowels into the top of

the 2 hollow core locking

nuts .

Insert a screwdriver into

the 2 hollow core locking

nuts and turn the nuts

inside as far as they will

go.

D D

Prepare the 2

horizontals

Insert 4 large locking

nuts into each

horizontal .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

x 2

Step 11

Assembly Instructions

Step 12

Step 13

Fit the other

horizontal

Push the other

horizontal onto the

right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the horizontal .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Fit a horizontal

Push a horizontal

onto the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the horizontal .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

10mm

Prepare the plinth

Tap 2 wooden dowels

into the plinth .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 2 large locking

nuts into the plinth

. .

Step 14

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos White Media Storage Unit With Glass Doors... Bedienungsanleitung

Argos

Argos Wow Hygena Bay 457/6169 Bedienungsanleitung

Argos

Argos 618/2915 Bedienungsanleitung

Argos

Argos Jarvia 143/6202 Bedienungsanleitung

Argos

Argos Jenson 937/8032 Bedienungsanleitung

Argos

Argos New Penton 245/7864 Bedienungsanleitung

Argos

Argos Hygena Genoa 464/2718D Bedienungsanleitung

Argos

Argos Wow Leo 167/9605 Bedienungsanleitung

Argos

Argos Lavendon 275473 Bedienungsanleitung

Argos

Argos Tolga 323/5164 Bedienungsanleitung

Argos

Argos Camden 239/9472 Bedienungsanleitung

Argos

Argos Stakka 475/9955 Bedienungsanleitung

Argos

Argos 456/2764 Bedienungsanleitung

Argos

Argos Hygena 833/4448 Bedienungsanleitung

Argos

Argos Canterbury 517/0571 Bedienungsanleitung

Argos

Argos Austen HOME 804/3416 Bedienungsanleitung

Argos

Argos 481/3640 Bedienungsanleitung

Argos

Argos Ohio 6+2 Sideboard 314/7128 Bedienungsanleitung

Argos

Argos 619/1834 Bedienungsanleitung

Argos

Argos New Sywell 282/7920 Bedienungsanleitung

Argos

Argos 609/2263 Bedienungsanleitung

Argos

Argos Murano 332/6138 Datenblatt

Argos

Argos Grafton 360/9109 Bedienungsanleitung

Argos

Argos Landon 241/7990 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung