Argos New Sywell 282/7920 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

New Sywell - 3+3 Drawer Chest

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 2 - 08/04/14

Important - Please read these instructions fully before starting assembly

ALR3013

282/7920

278/1406

Width - 98.5cm

Depth - 40cm

Height - 55.5cm

287/0049

275/7375

Issue 2 - 08/04/14

Increase drawer box size.

Add 12 wedges.

Add 4 plastinails.

Remove old cat codes and add new

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 28.5kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: If there is any

chance of this unit being pulled

over by children etc. it is

recommended that the unit is

secured to a wall using suitable

fixings (not supplied).

• Dispose of all packaging

carefully and responsibly.

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Top (D2564A)

(953 x 394mm)

Rail (D2566A)

(953 x 78mm) x 2

Divider (D2565A)

(498 x 393mm)

Drawer Front (D2567A)

(465 x 162mm) x 6

Drawer Base (T447-367)

(447 x 367mm) x 6

Back (X979-524)

(979 x 524mm)

Drawer Back (W436-124)

(436 x 124mm) x 6

1Left Side (D2547A)

(553 x 396mm)

2Right Side (D2548A)

(553 x 396mm)

4 6

7 8

Left Drawer Side (W370-124LH)

(370 x 124mm) x 6

Right Drawer Side (W370-124RH)

(370 x 124mm) x 6

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 7

Metal dowel (F901) x 22

D E

G H I

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

9mm Screw (F74) x 12 9mm Screw (F73) x 24

Drawer runner (F1004) x12

Electric drill

(do not use for

fitting screws)

Knock-in Peg (F171) x 24

Small locking

nut (F3) x 12

Large locking

nut (F900) x 10

Handle (F315) x 6

25mm Screw (F95) x 12

Feet (F854) x 2

Nail (F51) x 20

45mm Screw (F65) x 2

Plastic Nail (F91) x 4

Wedgefix (F639) x 12

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 6 x 6

x 6

Prepare the 6 drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: Arrow on locking

nut must point towards

hole in edge of panel.

Step 2

Step 3

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Small groove

x 6

Assembly Instructions

Step 4

Step 5

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

7 8

x 6

Fit the drawer back

down onto the drawer

base .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

7 8

x 6

Attach the handles

Attach a handle to

each drawer front

using 2 screws .

Step 6

x 6

Step 7

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

10 8

x 6

Finished

front edge

Finished

front edge

Assembly Instructions

Step 8

Finished

front edge

Finished

front edge

Step 9

Prepare the right side

a: Place 3 runners on

the right side . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

Screw 4 metal dowels

into the right side .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the right side .

Finished

front edge

Finished

front edge

Prepare the left side

a: Place 3 runners on

the left side . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

Screw 4 metal dowels

into the left side .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left side .

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

Prepare the top

Tap 2 wooden dowels

into the top .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the

top .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Screw 2 metal dowels

into the top .

Fit the top to the right

side

Push the top onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the top .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 11

10mm

Finished

front edge

plain

chipboard

surface

plain chipboard surface

Finished

front edge

Assembly Instructions

Step 12

Finished

front edge

Prepare the divider

a: Place 3 runners on

the divider . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

Insert 2 large locking

nuts into the divider

. .

Tap a wooden dowel

into the upright .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the divider .

Turn the divider over

c: Place 3 runners on

the divider . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

d: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the divider .

Finished

front edge

Finished

front edge

Finished

front edge

Turn the

divider over

Finished

front edge

Finished

front edge

Assembly Instructions

Step 13

Step 14

Prepare the 2 rails

Tap 2 wooden dowels

into each of the 2 rails .

Insert 2 large locking

nuts into each of the

2 rails .

Step 15

x 2

plain chipboard surface

Finished

front edge

Fit the divider

Push the divider onto

the top .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the divider .

Note: Support this

rail until the left

side has been fitted

in the next step.

Fit the rails

Push the 2 rails onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the rails .

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 266/0709 Bedienungsanleitung

Argos

Argos 461/8144 Bedienungsanleitung

Argos

Argos Mason 872/4072 Bedienungsanleitung

Argos

Argos Ashley Dolls House Bookcase Bedienungsanleitung

Argos

Argos Eden 414/1594 Bedienungsanleitung

Argos

Argos Phoenix 162/2690 Bedienungsanleitung

Argos

Argos Arvika 355/7794 Bedienungsanleitung

Argos

Argos HOME Chesterfield Sofa Handbuch

Argos

Argos 831/9188 Bedienungsanleitung

Argos

Argos Kids Sywell Bedienungsanleitung

Argos

Argos RIO 4 Seater Sofa Set 608/9805 Bedienungsanleitung

Argos

Argos Chrome Tidy Rail 875/8457 Bedienungsanleitung

Argos

Argos Costa Swivel Chair 6893307 Bedienungsanleitung

Argos

Argos Suki 609/7426 Bedienungsanleitung

Argos

Argos Home Wow Oslo 482/2844 Bedienungsanleitung

Argos

Argos Walton 143/6886 Bedienungsanleitung

Argos

Argos Misaki 632/4546 Bedienungsanleitung

Argos

Argos Beech Effect TV Bench 609/0162 Bedienungsanleitung

Argos

Argos BASIC TALLBOY MIRROR CABINET 402/9166 Bedienungsanleitung

Argos

Argos Mix Bedienungsanleitung

Argos

Argos Campbell Oak Effect Dining Table 280/7823 Bedienungsanleitung

Argos

Argos Phoenix 314/9449 Bedienungsanleitung

Argos

Argos SAN DIEGO 408/8365 Bedienungsanleitung

Argos

Argos Malibu Series Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung