Argos New Sywell 259/1892 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 74.5cm

Depth - 40cm

Height - 88.5cm

New Sywell - 5 Drawer 1 Door Chest

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 4 - 22/07/14

Important - Please read these instructions fully before starting assembly

ALR3016

259/1892

278/7589

278/1750

282/6990

Issue2 - 25/11/13 - Cat codes were incorrect.

Issue3 - 08/04/14 - Drawer box sizes increased.

Add 10 wedges.

Add 4 plastinails.

Issue4 - 22/07/14 - The Wedgefixes have been corrected to part ‘R’ and the Plastinails to part ‘S’.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 32.5kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

12 3

90%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

7Drawer Front

(D2545A)

(359 x 162mm) x 5

Drawer Base (T341-367)

(341 x 367mm) x 5

11 12

Drawer Back

(W330-124)

(330 x 124mm) x 5

Divider (D2554A)

(828 x 393mm)

Shelf (D2558A)

(337 x 368mm)

Door (D2556A)

(822 x 333mm)

Right Side (D2553A)

(883 x 396mm)

5Top (D2551A)

(715 x 394mm)

6Base (D2557A)

(715 x 394mm)

Left Side (D2596A)

(883 x 396mm)

Back (X854-741)

(854 x 741mm)

Left Drawer Side

(W370-124LH)

(370 x 124mm) x 5

Right Drawer Side

(W370-124RH)

(370 x 124mm) x 5

Please check you have all the fittings listed below

Tools required

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 8

Metal dowel (F901) x 22

D E F

G H I

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

J K

9mm Screw (F74) x 10 9mm Screw (F73) x 20

Drawer runner (F1004) x 10

see malibu fitment mk2 for large number of panels and fittings

Electric drill

(do not use for

fitting screws)

Knock-in Peg (F171) x 20

13mm Screw (F79) x 1

Small locking

nut (F3) x 10

Large locking

nut (F900) x 12

Nail (F51) x 22

Bracket (F327) x 1 Handle (F315) x 6

13mm Screw (F63) x 4

Hinge plate

(F523) x 2 Hinge (F522) x 2

Shelf support (F121) x 4

25mm Screw (F95) x 12

SPlastic Nail (F91) x 4

RWedgefix (F639) x 10

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

x 5 x 5

x 5

Prepare the drawer

fronts

Screw 2 metal dowels

into the holes shown on

the back of each drawer

front .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and right drawer

side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 2

Step 3

Attach the drawer

sides to the drawer

front

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

x 5

Note: The locking nuts can be on

either surface of the drawer sides.

Make sure that the small groove

is on the inside, as shown.

Small groove

Note: Due to the manufacturing process, the holes for the

locking nut can be on either surface of the drawer sides.

910

Assembly Instructions

Step 4

Step 5

Fit the drawer base

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

9 10

Fit the drawer back

down onto the drawer

base .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

9 10

Attach the handles

Attach a handle to

each drawer front

using 2 screws .

Step 6

x 5

Step 7

Fit the wedgefixes

Turn the drawer

assemblies over and

slide 2 wedgefixes

into the front and back

grooves, as shown, and

tighten up the screws.

x 5

11 10

Finished

front edge

Assembly Instructions

Step 8

Prepare the top

Tap 2 wooden dowels

into the top .

Insert 4 large locking

nuts into the top .

Screw 2 metal dowels

into the top .

Fix the bracket

170mm in from the side

and flush to the back

edge using screw .

Step 9

Prepare the base

a: Tap 4 wooden

dowels into the base

. .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 4 large locking

nuts into the base .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Turn the base over

b: Screw 2 metal

dowels into the base

. .

Turn the base over

10mm

Finished

front edge

Finished

front edge

170mm

plain chipboard surface

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

Fit the top to the

divider

Push the top onto

the divider .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the divider .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Step 11

Finished

front edge

Prepare the divider

a: Place 5 runners on

the divider . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

Tap 2 wooden dowels

into the divider .

b: Slide the runners

back the other way and

fit the 2nd screw into

the corresponding hole

in the divider .

Insert 4 large locking

nuts into the

divider .

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 12

Prepare the right side

Screw 4 metal dowels

into the right side .

Fit 2 hinge plates onto

the right side , making

sure that the slot is

facing towards the

finished front edge.

Step 13

Fit the base

Push the base onto

the divider .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the divider .

plain

chipboard

surface

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 14

Step 15

Fit the right side

Push the right side

onto the top and

base .

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the top and base .

Prepare the left side

a: Place 5 runners on

the left side . Slide

back the top of the

runner and use the 2nd

hole from the front to fit

the 1st screw .

Screw 4 metal dowels

into the left side .

b: Slide the runner

back the other way and

fit the 2nd screw into

the corresponding hole

in the left side .

Finished

front edge

Dieses Handbuch passt für folgende Modelle

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Ohio 309/5256 Bedienungsanleitung

Argos

Argos Avebury 3ft Bed 355/2108 Bedienungsanleitung

Argos

Argos Camden 305/0679 Bedienungsanleitung

Argos

Argos 609/2201 Bedienungsanleitung

Argos

Argos Curve 377/3530 Bedienungsanleitung

Argos

Argos 06006170 Bedienungsanleitung

Argos

Argos HOME New Pagnell Deep 3+2 Chest 610/8793 Bedienungsanleitung

Argos

Argos Malibu Bedienungsanleitung

Argos

Argos 906/4009 Bedienungsanleitung

Argos

Argos TC NEW PAOLO 5554001 Bedienungsanleitung

Argos

Argos HOME HM Maine 806/4402 Bedienungsanleitung

Argos

Argos Osaka Dressing Table 2273237 Bedienungsanleitung

Argos

Argos Retro 226/2877 Bedienungsanleitung

Argos

Argos Walton 143/6886 Bedienungsanleitung

Argos

Argos 258/3312 Bedienungsanleitung

Argos

Argos Harrington Bedienungsanleitung

Argos

Argos Aspley 498/9622 Bedienungsanleitung

Argos

Argos BASIC TALLBOY MIRROR CABINET 402/9166 Bedienungsanleitung

Argos

Argos 609/5741 Bedienungsanleitung

Argos

Argos Chequer 399/901 Bedienungsanleitung

Argos

Argos Devon 532/7623 Bedienungsanleitung

Argos

Argos 634/1880 Bedienungsanleitung

Argos

Argos New Penton 245/7864 Bedienungsanleitung

Argos

Argos PENTON Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung