Argos Newport Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 103.5cm

Depth - 50cm

Height - 172cm

Newport - 3 Door Robe

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 08456 400800

Issue 3 - 16/10/14

Important - Please read these instructions fully before starting assembly

ALR3078

331/9152

339/6199

Issue 2 - 07/10/14 - Overbalance Strap has replaced Bracket and Screw.

Code 355/3743 was not required on this AI and has been deleted.

Issue 3 - 16/10/14 - Correct dimensions added to the front page.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 58kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

Rule

Tools required

Rule

ScissorsSquare

Spirit

level

Hammer Bradawl

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Step

ladder

Electric drill

(only use

when drilling

into walls)

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

bracket supplied.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

80%

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Left End (DF285)

(1703 x 495mm)

Right End (DF286B)

(1703 x 495mm)

Top (DF520)

(1032 x 496mm)

Base (DF522)

(996 x 470mm)

Door (DF288B)

(1635 x 328mm) x 3

Loose Shelf (DF526)

(332 x 468mm) x 2

Divider (DF525)

(1623 x 469mm)

Plinth (DF521)

(996 x 65mm)

9Small Back (X1650-351)

(1650 x 351mm)

Large Back (X1650-668)

(1650 x 668mm)

Hanging Rail (FHR657)

(657mm long)

10 11

Shelf (DF526)

(332 x 468mm) x 2

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Wooden dowel (F22) x 2

Metal dowel (F901) x 10

E F

G H I

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

25mm Screw (F50) x 3

Nail (F51) x 36

Plastic Nail (F91) x 4

Large locking

nut (F900) x 10

13mm Screw (F63) x 20

Handle (F314) x 3

Rail holder

(F1014) x 2

40mm Screw (F910) x 4

Nail screw (F277) x 6 Back holder (F276) x 6

*These can also be round

Hinge plate

(F523) x 6 Hinge arm (F522) x 6

Hinge arm (F518) x 3

Hinge plate

(F523) x 3

These hinge plates and

arms are in the bag of

6 labelled AHP1546

These hinge plates and

arms are in the bag of

3 labelled AHP1043

Shelf stud (F110) x 8

NStrap Screw Washer x 2

Overbalance protector kit (F269) x 1

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 08456 400800 quoting the reference

numbers below

Step 1

Finished

front edge

Step 2

Prepare the left side

Screw 3 metal dowels

into the left side .

Note: Tighten the metal

dowels up fully against

the panels.

Insert 2 large locking

nuts into the

left side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Fit 3 hinge plates to

the left side making

sure that the slot is

facing towards the

finished front edge.

Push a rail holder into

the left side . Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

Note: The hinge plates

used on the left and right

ends are in the bag of 6

labelled AHP1546.

Note: The hinge plates

used on the left and right

ends are in the bag of 6

labelled AHP1546.

Prepare the right side

Screw 3 metal dowels

into the right side .

Insert 2 large locking

nuts into the

right side .

Fit 3 hinge plates to

the right side making

sure that the slot is

facing towards the

finished front edge.

Finished

front edge

Assembly Instructions

Step 3

Prepare the base

Insert 4 large locking

nuts into the base .

Finished

front edge

Finished

front edge

Finished

front edge

Step 4

Fit the base to the

right side

Push the base onto

the right side .

Use a screwdriver to

tighten the 2 large

locking nuts fitted to

the base .

Note: Turn the large

locking nuts as far as

they will go - more than

1/2 a turn.

Polystyrene

block

Polystyrene

block

Finished

front edge

Assembly Instructions

Step 5

Prepare the divider

Fit the 3 hinge plates

to the divider making

sure that the slot is

facing towards the

finished front edge.

Push a rail holder into

the divider . Make

sure that it is fitted

straight, in line with the

panel edges and then

secure with screw .

QFinished

front edge

Note: The hinge plates used

on the divider are in the bag

of 3 labelled AHP1043.

Fit the divider to the

base

Attach the divider to

the base using 2

screws .

Note: To make the

assembly easier, place

polystyrene blocks from

the packaging

underneath the divider

and the base.

Step 6

Assembly Instructions

Step 7

Step 8

Prepare the plinth

Tap 2 wooden dowels

into the plinth .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Insert 2 large locking

nuts into the plinth .

Fit the plinth

Push the plinth onto

the right side .

Use a screwdriver to

tighten the large locking

nut fitted to the plinth

. .

Step 9

7Finished

front edge

Fit the left side

Push the left side

onto the assembly.

Use a screwdriver to

tighten the 3 large

locking nuts fitted

to the base and

plinth .

Assembly Instructions

Step 10

Step 11

Prepare the top

Screw 4 metal dowels

into the top .

Finished

front edge

Fit the top

Push the top onto

the left side and right

side .

Attach the top to the

divider using 2

screws .

Step 12

Secure the top

Use a screwdriver to

tighten the 4 large

locking nuts fitted to

the left side and

right side .

Assembly Instructions

Step 13

Fit the back panels

a: Square up the unit by

making sure that

measurement x:x equals

y:y.

Place the small back

and large back down,

onto the unit as shown.

Make sure that the 2

backs are pushed up

tight against each other

and that they meet in the

centre of the divider’s

back edge.

b: Nail around the

outside edges of the 2

backs.

Note: Do not nail where

the 2 backs meet and

nails should be spaced

about 150mm apart.

c: Push the 6 nail

screws through the 6

back holders and tap

them down between the

small back and large

back and into the

back edge of the divider

. .

Keep tapping the nail

screws in until the

back holders dig into

the small and large back.

LK +

Note: These can

also be round

Note: If ever you need to take

the backs off to dismantle the

unit, the nail screws can be

taken out using a screwdriver.

The measurement from top corner X to bottom corner X must be

equal to the measurement from top corner Y to bottom corner Y

Andere Argos Inneneinrichtung Handbücher

Argos

Argos Heavy Duty Bunk Bed 557/5554 Bedienungsanleitung

Argos

Argos 935/5189 Bedienungsanleitung

Argos

Argos Amalfi 1455056 Bedienungsanleitung

Argos

Argos Wow Lima 600/6503 Bedienungsanleitung

Argos

Argos 609/0117 Bedienungsanleitung

Argos

Argos COT Bedienungsanleitung

Argos

Argos New Sywell 427/1237 Bedienungsanleitung

Argos

Argos 609/2256 Bedienungsanleitung

Argos

Argos New Penton Bedienungsanleitung

Argos

Argos Canterbury 5 DRW CHEST Bedienungsanleitung

Argos

Argos Theo Folding Bar Stool 600/0262 Bedienungsanleitung

Argos

Argos Hygena Genoa 464/2718D Bedienungsanleitung

Argos

Argos Home 334/7722 Bedienungsanleitung

Argos

Argos Gloss Double HOME Wall Cabinet Grey Bedienungsanleitung

Argos

Argos 3279515 Bedienungsanleitung

Argos

Argos Kensington Installationsanleitung

Argos

Argos 343761 Bedienungsanleitung

Argos

Argos Matrix Glass Nest Table Bedienungsanleitung

Argos

Argos 833/2811 Bedienungsanleitung

Argos

Argos Kingston 602/9779 Bedienungsanleitung

Argos

Argos Mix Bedienungsanleitung

Argos

Argos 428/7070 Bedienungsanleitung

Argos

Argos Jenson 937/4610 Bedienungsanleitung

Argos

Argos HOME 618/9138 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung