Argos Winchester 395/5798 Bedienungsanleitung

MADE IN

BRITAIN

Dimensions

Width - 90cm

Depth - 33cm

Height - 92cm

Winchester - Console Table

Assembly Instructions - Please keep for future reference

If you need help or have damaged or missing parts, call the Customer Helpline: 03456 400800

Issue 2 - 28/07/15

Important - Please read these instructions fully before starting assembly

ALR3166

395/5798

Issue 2 - 28/07/15 - The 2 Backs are now secured to the 2 Shelves.

4 extra nails have been added to the kit.

Safety and Care Advice

Important - Please read these instructions fully before starting assembly

• Warning: This unit weighs

approximately 30kgs.

Please lift with care.

• Check you have all the

components and tools listed on

pages 2 and 3.

• Remove all fittings from the

plastic bags and separate them

into their groups.

• Keep children and animals

away from the work area, small

parts could choke if swallowed.

• Parts of the assembly will be

easier with 2 people.

• Make sure you have enough

space to layout the parts before

starting.

• Do not stand or put weight on

the product, this could cause

damage.

• Assemble the item as close to

its final position (in the same

room) as possible.

• Assemble on a soft level

surface to avoid damaging the

unit or your floor (use opened

out unit carton).

Care and maintenance

• Only clean using a damp cloth

and mild detergent, do no use

bleach or abrasive cleaners.

• From time to time check that

there are no loose screws on

this unit.

• This product should not be

discarded with household

waste. Take to your local

authority waste disposal centre.

Note: If required the next page

can be cut out and used as

reference throughout the

assembly. Keep this page with

these instructions for future

reference.

• We do not

recommend the

use of power

drill/drivers for

inserting screws,

as this could damage the unit.

Only use hand screwdrivers.

• Safety note: It is

recommended that this unit is

secured to a wall using the

overbalance protector kit

supplied or, an alternative fixing

method of your choice.

• Dispose of all packaging

carefully and responsibly.

Components - Panels

Please check you have all the panels listed below

1 2 6

80%

x 2

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Left End (DF2944)

(894 x 307mm)

Top (DF3377)

(897 x 327mm)

Shelf (DF2949)

(827 x 306mm) x 3

Cross Rail (DF2946)

(827 x 92mm) x 3

Drawer Front (DF2947)

(259.5 x 192mm) x 3

Right End (DF2945)

(894 x 307mm) Divider (DF2950)

(198 x 305mm) x 2

Side Plinth (DF2941)

(307 x 91mm) x 2

Front Plinth (DF2948)

(889 x 92mm)

Left Drawer Side (W260-124LH)

(260 x 124mm) x 3

Right Drawer Side (W260-124RH)

(260 x 124mm) x 3

Drawer Back (W232-124)

(232 x 124mm) x 3

Back (X820-426)

(820 x 426mm) x 2

Drawer Base (T243-257)

(243 x 257mm) x 3

789

10 11 12

Please check you have all the fittings listed below

Components - Fittings If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Note: The quantities below are the correct amount to complete the assembly. In some cases

more fittings may be supplied than are required.

Ruler - Use this ruler to help correctly identify the screws

mm 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160 170

A B

D E F

G H

Small locking

nut (F3) x 6

9mm Screw (F73) x 12

Knock-in Peg (F171GY) x 12

Large locking

nut (F900) x 28

Metal dowel (F901) x 34

Wedgefix (F639) x 6

9mm Screw (F74) x 6

OStrap Screw Washer x 2

Overbalance protector kit (F269) x 1

38mm Screw (F81) x 3 25mm Screw (F50) x 8

Plastic Nail (F91) x 4

Nail (F51) x 26

Wooden dowel (F22) x 28

Handle (F463) x 3

Drawer runner (F307) x 6

Tools required

Rule Scissors Hammer

Eye protection

(when using a

hammer or drill)

Cross-head

screwdriver

Electric drill

(do not use for

fitting screws)

Assembly Instructions

If you have damaged or missing components, call the

Customer Helpline: 03456 400800 quoting the reference

numbers below

Step 1

x 3

x 3 x 3

x 3

Step 2

Prepare the 3 drawer

fronts

Screw 2 metal dowels

into each of the 3 drawer

fronts .

Note: Tighten the metal

dowels up fully against

the panels.

Prepare the drawer

sides

Insert a small locking

nut into the hole

shown on the left drawer

side and the right

drawer side .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Step 3

Attach the drawer

sides to the drawer

fronts

Push the left drawer side

. and right drawer side

. onto the back of the

drawer front .

Turn the small locking

nuts on the left

drawer side and right

drawer side .

Note: Turn the locking

nuts clockwise to

secure panels - more

than 1/2 a turn.

10 11

Assembly Instructions

Step 4

Fit the drawer bases

Slide the drawer base

down the grooves in the

drawer sides and

and down into the

groove in the drawer

front .

Step 5

Fit the drawer backs

Fit the drawer back

between the drawer

sides and .

Make sure that the

drawer base fits into

the groove in the drawer

back .

Hold the drawer back

in position and tap the

knock-in pegs

through the holes in the

drawer sides and .

Step 7

10 11

Fit the wedgefixes

Turn the drawer

assembies over and slide

2 wedgefixes into the

front and back grooves,

as shown, and tighten up

the screws.

x 3

Step 6

Attach the handle

Attach a handle to

each drawer front

using screw .

Finished

front edge

Assembly Instructions

Step 8

Finished

front edge

Finished

front edge

Prepare the left end

a: Place a runner

onto the left end .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

use the 2nd hole from

the back to fit the 2nd

screw .

c: Screw 9 metal

dowels into the left

end .

Insert 2 large locking

nuts into the left end

. .

Note: The arrow on the

locking nut must point

towards the hole in the

edge of the panel.

Tap 2 wooden dowels

into the left end .

Note: Wooden dowels

must not stick out from

the edge by more than

10mm or they may

damage other panels.

Finished

front edge

10mm

Assembly Instructions

Step 9

Prepare the right end

a: Place a runner

onto the right end .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

use the 2nd hole from

the back to fit the 2nd

screw .

c: Screw 9 metal

dowels into the right

end .

Insert 2 large locking

nuts into the right end

. .

Tap 2 wooden dowels

into the right end .

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 10

Prepare the 2 dividers

a: Place a runner

onto the divider .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

b: Slide the runner

back the other way and

use the 2nd hole from

the back to fit the 2nd

screw .

Turn the divider over

c: Place a runner

onto the divider .

Slide back the top of

runner and use the 2nd

hole from the front to fit

the 1st screw .

d: Slide the runner

back the other way and

use the 2nd hole from

the back to fit the 2nd

screw .

e: Insert 2 large locking

nuts into the divider .

Tap 2 wooden dowels

into the divider .

Finished

front edge

Note: Due to the manufacturing process,

the 2 holes for the large locking nut can

be on either surface of the 2 dividers.

Turn the divider over

Finished

front edge

Finished

front edge

Finished

front edge

Finished

front edge

x 2

Finished

front edge

Finished

front edge

Finished

front edge

Assembly Instructions

Step 11

Prepare 2 of the cross

rails

Screw 2 metal dowels

into 2 of the cross rails

. .

Insert 2 large locking

nuts into 2 of the

cross rails . .

Tap 2 wooden dowels

into 2 of the cross rails

. .

Finished

front edge

x 2

Fit a divider to a cross

rail

Push a divider onto a

cross rail .

Use a screwdriver to

tighten the large locking

nut fitted to the

divider .

Note: Turn the large

locking nut as far as it

will go - more than 1/2 a

turn.

Step 12

Fit another divider

Push another divider

onto the cross rail .

Use a screwdriver to

tighten the large locking

nut fitted to the

divider .

Step 13

Remember: The large locking

nuts can be on either surface

of the dividers.

Inhaltsverzeichnis

Andere Argos Inneneinrichtung Handbücher

Argos

Argos 609/2263 Bedienungsanleitung

Argos

Argos Nest of Tables 609/1439 Bedienungsanleitung

Argos

Argos Rattan 752/6965 Bedienungsanleitung

Argos

Argos 609/2555 Bedienungsanleitung

Argos

Argos Puerto Rico Bedienungsanleitung

Argos

Argos Sywell 643/8047 Bedienungsanleitung

Argos

Argos 144/3556 Bedienungsanleitung

Argos

Argos MC0497 Bedienungsanleitung

Argos

Argos Aspley 391/8168 Bedienungsanleitung

Argos

Argos Heavy Duty Bunk Bed 557/5554 Bedienungsanleitung

Argos

Argos Wow Hygena Bay 457/6169 Bedienungsanleitung

Argos

Argos Habitat Winchester 3+2 Sideboard 417/9906 Bedienungsanleitung

Argos

Argos 875/5429 Bedienungsanleitung

Argos

Argos Eden 414/1594 Bedienungsanleitung

Argos

Argos Seattle 4Ft6 Bedienungsanleitung

Argos

Argos 832 Bedienungsanleitung

Argos

Argos New Sywell 427/1237 Bedienungsanleitung

Argos

Argos New Penton 245/7864 Bedienungsanleitung

Argos

Argos Scandinavia 459/8305 Bedienungsanleitung

Argos

Argos Aspley 498/9622 Bedienungsanleitung

Argos

Argos Habitat hygena Square+ 4 x 2 620/2493 Bedienungsanleitung

Argos

Argos Belle HOME 879/0240 Bedienungsanleitung

Argos

Argos 033 3560 Series Bedienungsanleitung

Argos

Argos 149113 Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung