ARJO HUNTLEIGH Enterprise 8600 Bedienungsanleitung

Enterprise 8000+ & 9000+

Instructions for Use

...with people in mind

746-505-AM Rev 06 • 05/2015

Contents

1. Introduction............................................................................3

2. Clinical applications...............................................................4

3. Installation..............................................................................5

4. Operation................................................................................8

5. Power operation...................................................................23

6. Bed exit detection (Enterprise® 8000+ range) ...................36

7. Patient weighing and VariZone movement detection

(Enterprise® 9000+ range)...................................................38

8. Decontamination..................................................................44

9. Maintenance .........................................................................46

10.Accessories..........................................................................48

11.Warranty and service...........................................................50

12.Dimensions and technical data...........................................51

1 746-505-AM-6

Warnings, Cautions and Notes

WARNINGS given in this manual identify possible hazards in

procedures or conditions, which if not correctly followed, could result in

death, injury or other serious adverse reactions.

Cautions given in this manual identify possible hazards in procedures or

conditions, which if not correctly followed, could result in equipment

damage or failure.

Notes given in this manual (indicated by ) are used to explain or

amplify a procedure or condition.



Items marked with this symbol refer to optional features that are not

available on all beds.

General Warnings

WARNING

Do not use accessories that have not been designed or

approved for use with this bed.

Electrical equipment can be hazardous if misused.

Do not use electrically powered beds in the presence of

flammable gases such as anesthetic agents.

Do not use electrically powered beds in operating suites.

To disconnect the bed from the electrical supply for cleaning

or maintenance, remove the power cord from the wall socket.

WARNING

ELECTROMAGNETIC COMPATIBILITY (EMC)

This product complies with the requirements of applicable

EMC standards. However, medical electrical equipment

requires special precautions regarding electromagnetic

compatibility and should be installed and used in accordance

with the EMC information in the product Service Manual.

Medical electrical equipment can be affected by portable and

mobile RF communications equipment, e.g. cellular

telephones.

2 746-505-AM-6

1. Introduction

This manual contains instructions for the installation, use and

maintenance of the ArjoHuntleigh Enterprise®range of acute care

hospital beds. These beds have multiple functions to provide the optimum

nursing position for both patient and caregiver.

The features available on the various models in the Enterprise®range are

shown in the table:

Model Number

8000+ Range 9000+ Range

8500

8600

8700

8800

9600

9700

9800

Feature

Infra red anti-entrapment system (AES)



Bed exit detection



VariZone patient movement detection



Standard nurse call connection



Two-way nurse call connection



Integrated patient weighing scale



Controls for lighting, radio and TV



All beds in the Enterprise®range have the following standard features:

•Electrical adjustment of bed height, thigh section angle and kneebreak

angle

•Electrically operated retracting backrest

•Bio-Contouradvanced profiling system

•Electrical adjustment of head down tilt (Trendelenburg) and foot down

tilt (reverse Trendelenburg)

•Fowler (chair) or Vascular position selectable by caregiver

•Mattress support surface with removable plastic panels

•Integrated mattress platform extension

•Pull-out linen shelf

•Drainage bag rails below mattress platform

3 746-505-AM-6

2. Clinical applications

Areas of use

General medical and surgical floors, care of the

elderly, ICU, coronary care and oncology.

Indications

The bed is appropriate for patients who pose a

movement and handling risk and / or whose clinical

condition requires that they be positioned with

minimal physical handling.

Patients with a moderate amount of independence can,

at the caregiver’s discretion, use the controls to adjust

their own position.

Contra-

indications

The total safe working load of

the bed is 550 lbs. (250 kg).

The bed is intended for use by

patients over the age of twelve

years.

WARNING

The use of head down tilt (Trendelenburg) or foot down tilt

(reverse Trendelenburg) may be contraindicated for certain

medical conditions.

The tilt facility should only be used under the guidance of a

clinically qualified person after assessment of the patient’s

condition.

4 746-505-AM-6

3. Installation

All models

Position the bed on a flat, level surface and apply the

brakes (refer to Chapter 4).

9000+ range

only

Remove the four transport locking bolts (A) and

washers (B); there are two bolts at the head end of the

bed and two at the foot end.

Removing the transport locking bolts

Caution

To prevent damage to the weighing mechanism, replace the

transport locking bolts and washers before transporting the

bed by road. This is not necessary when moving the bed

short distances over smooth surfaces.

5 746-505-AM-6

All models

Connect the power cord to a suitable outlet socket.

The power cord is equipped with a plastic hook. When

not in use or before moving the bed, clip the hook (C)

onto the head end panel, coil up the cable and place it

over the hook.

Cables and equipotential terminal

An equipotential terminal (D) is located at the head end of

the bed, above the roller buffer on the patient’s right side.

When other electrical equipment is within patient / user

reach, the potential difference between this equipment can

be equalized by interconnecting the equipotential

terminals of each piece of equipment.

6 746-505-AM-6

Nurse call connection 

Connect one end of the nurse call cable to the 37-pin socket

(E), located below the head end of the bed on the patient’s

right.

Connect the other end of the nurse call cable (F) to the

socket on the headwall panel. The type of connector will

vary depending on the nurse call system.

Connecting the nurse call cable

WARNING

Make sure that the coiled power cord is not stretched excessively.

Do not allow the cables to trail on the floor where they may cause

a trip hazard.

Make sure that the cables do not become entangled with the

moving parts of the bed.

Before moving the bed, disconnect both cables and store the

power cord as shown on the previous page.

Connection to a nurse call system



must be made with the

correct cable. Use of the wrong cable may cause malfunction of

the bed and/or nurse call system.

Verify correct operation of the nurse call system



before placing

a patient on the bed.

Caution

Do not allow the cables to touch the bed frame as this may affect

the accuracy of the weighing system.



7 746-505-AM-6

4. Operation

Safety

•Always use a mattress of the correct size and type. A

range of suitable pressure redistributing mattresses is

available from ArjoHuntleigh.

•To reduce the risk of injury due to falls, leave the bed at

minimum height when the patient is unattended.

•Where risk assessment indicates that a patient is at high

risk of entrapment owing to their medical condition or

other circumstances, and where there is no medical

benefit from their being left in a contoured position,

place the mattress platform in the flat position when the

patient is left unattended.

•Patients should not be left in the Trendelenburg position

when unattended.

•It is recommended to use the Function Lockout facility

on the Attendant Control Panel (ACP) to prevent

unintended movement.

•When the bed is operated, make sure that obstacles such

as bedside furniture do not restrict its movement.

•Before operating the bed, make sure that the patient is

positioned correctly to avoid potential entrapment or

imbalance.

•Always apply the brakes when the bed is stationary.

•Keep these instructions in a safe place for reference.

8 746-505-AM-6

WARNING

Operate the brake pedals with your feet while wearing suitable

shoes. Do not operate the pedals with your hands.

Brakes and

steering The pedals have three positions as shown below:

• BRAKE: brakes are applied on all four castors.

• FREE: all four castors are free to rotate and swivel.

• STEER: all four castors can rotate, but the steering

castor (see below) is locked so that it cannot swivel.

This helps to keep the bed on a straight line.

BRAKE FREE STEER

Using the

steering

castor

Position the bed so that all the castors line up in the direction of

travel. Raise the pedals to lock the steering castor and move the

bed by pushing it from the opposite end of the steering castor.

The steering castor may be at either end of the bed, as specified

by the customer.

Head end

brake pedals Brake pedals can be fitted at the head end of the bed. These

operate in the same way as the foot end pedals.

9 746-505-AM-6

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ARJO HUNTLEIGH Medizinische Geräte Handbücher

ARJO HUNTLEIGH

ARJO HUNTLEIGH Carevo Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Bari-Breeze Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Alpha Response Service-Handbuch

ARJO HUNTLEIGH

ARJO HUNTLEIGH Maxi Sky 600 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH CALYPSO Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Maxi Sky 2 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH FLOWTRON UNIVERSAL Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Alpha Active 3 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Maxi Sky 2 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Flowtron Hydroven 12 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH KWIKtrak Turntable Series Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Prelude Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH AUTO LOGIC Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Enterprise 8000 series Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH MAXI MOVE Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH NIMBUS 4 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Auralis Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Ninjo Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Carendo Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Maxi Sky 2 Betriebsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Sorrento Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH Flowtron ACS800 Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH alpha trancell deluxe Bedienungsanleitung

ARJO HUNTLEIGH

ARJO HUNTLEIGH FLOWTRON UNIVERSAL Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung