Asko CC4527S Bedienungsanleitung
Instructions for use
Mode d’emploi
Built-in unit
Unité encastrée
CC4527S / 4000
CC4727S / 4000
CC4927S / 4000
CC41227S / 4000
EN Manual EN 3 - EN 13
FR Notice dútilisation FR 3 - FR 13
Pictograms used - Pictogrammes utilisés:
Important information - Important à savoir
Tip - Conseil
EN 3
CONTENT
Your built in unit
Description 4
Introduction 4
Use
Controls 5
Maintenance
Cleaning 7
Removing the grease filters 8
Replacing the carbon filter 8
Changing the light bulbs 8
Installation
General 9
Electrical connection 10
Installing the built in unit 11
Technical specifications
12
Appendix
Disposal of appliance and packaging 13
EN 4
Description
A Switch fan on/off
B Reduce extractor capacity
C Increase extractor capacity
D Engage intensive mode
E Clean air function/filter indication
F Timer function
G Switch lighting on/off
H Dim lighting
I Display
Introduction
This user manual gives you a quick overview of all the possibilities
offered by the appliance. You will find information on safety measures
and maintaining the appliance.
Please retain this user manual and the installation guide.
They may be of use to future users of the appliance.
Declaration of conformity
We declare that our products meet the applicable European Directives,
Decisions and Regulations and the requirements listed in the standards
referenced.
Read the separate safety instructions before
using the device!
YOUR BUILT IN UNIT
I
EN 5
USE
Controls
Switching the fan on and off
• Switch the fan on with the on/off button (A) and select the desired
extractor setting with buttons ‘B’ and ‘C’.
The ‘I’ display indicates which setting has been selected.
• Use button ‘D’ to switch on the intensive setting.
“HI” appears in the ‘I’ display.
After 6 minutes the intensive mode is automatically reduced to the
setting previously selected.
Switching the lighting on and off
• Use the ‘G’ button to switch the lighting on and off.
Dimming the lighting
• Dim the lighting with button ‘H’.
The strength of the lighting varies between maximum and minimum,
and vice-versa.
Clean Air function:
With the Clean Air function you can refresh the air in the kitchen
over maximum 24 hours.
• Make sure the extractor cap has been switched off.
• Press on the Clean Air button ‘E’.
Every hour, the extractor cap will switch on for 10 minutes
automatically, at the lowest extraction setting. The display reads
“24” and an indicator flashes at the bottom right.
I
EN 6
USE
Switching on the timer
• Switch on the extractor cap with button ‘A’.
• Set the extraction strength with buttons ‘B’ and ‘C’.
• Press the Timer button ‘F’.
The extractor cap switches off automatically after 30 minutes.
Switch off the Timer function by pressing button ‘F’ again, or by
switching off the extractor cap with button ‘A’. The display shows
the selected speed and the remaining time.
Grease filter indicator
After 100 hours of use the “FF” indicator is shown in the display.
• Clean the grease filters.
• Reset the filter indicator. While the cap is switched off, press button
‘E’ for 3 seconds until the filter indicator disappears.
Carbon filter indicator
After 200 hours of use the “EF” indicator is shown in the display.
• Replace the carbon filters.
• Reset the filter indicator. While the cap is switched off, press button
‘E’ for 3 seconds until the filter indicator disappears.
EN 7
Cleaning
Attention! Before performing any maintenance operation, isolate the
hood from the electrical supply by switching off at the connector and
removing the connector fuse. Or if the appliance has been connected
through a plug and socket, then the plug must be removed from the
socket.
The built in unit should be cleaned regularly (at least with the same
frequency with which you carry out maintenance of the fat filters)
internally and externally. Do not use abrasive products. Do not use
alcohol!
Attention! Failure to carry out the basic cleaning recommendations of
the built in unit and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or failure
to observe the above safety recommendations.
Built in unit
Clean the built in unit with soapy water and a soft cloth. Then wipe
with clean water to rinse. Do not use aggressive cleaning agents such
as soda. The built in unit paintwork will stay looking nice if you wax it
occasionally.
Stainless steel built in units
Do not use any sort of scourer. Treat with a stainless steel care product
and polish with the structure of the stainless steel.
Metal grease filters
These must be cleaned once a month (or when the filter saturation
indication system – if envisaged on the model in possession – indicates
this necessity) using non aggressive detergents, either by hand or in
the dishwasher, which must be set to a low temperature and a short
cycle. The openings must be placed downwards to let the water run
out of the filters. The cleaning agents will make the aluminium filter turn
dull, this is normal.
MAINTENANCE
EN 8
Grease filters
Removing the grease filters
Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Open the panel and pull the special
handle to remove the filter.
Replacing the carbon filter
The carbon filter must always be used if the built in unit is not ducted.
1. Open the panel.
2. Remove the grease filters.
3. Fit the carbon filter by wedging it into the casing (D).
4. Replace the filter grids in the extractor hood.
Note:
• Saturation of the activated charcoal will eventually occur after more
or less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• In all cases it is necessary to replace the cartridge at least every
four months.
• DO NOT wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly, change the filter regularly.
Lighting
Changing the light bulbs
Faulty LEDs must be replaced by a professional installer.
MAINTENANCE
EN 9
INSTALLATION
General
This appliance should be connected to the power supply by a
recognized fitter who is familiar with, and works according to the
correct safety regulations. This appliance meets the European
requirements.
Important that you know:
• The minimum distance between the supporting surface for the
cooking vessels on the gashob and the lowest part of the range
hood must be not less than 65 cm. For use with an electric, ceramic
or induction hob, this distance must be at least 55 cm.
• If the built in unit is to be fitted to an existing duct no other
appliances, such as a geyser or heater, may be connected to that
same duct.
• Consider local regulations with respect to the ventilation of gas
appliances.
• The shorter the duct, and the fewer the bends in it, the better the
built in unit will work.
• Before you start drilling check that there are no installation cables
present.
• The connecting pipe for the built in unit has a diameter of 120 or
150 mm. It is best also to use a flue pipe of the same diameter.
• The installation material supplied with this range hood is designed
for fixing to reinforced concrete or masonry walls. For some types
of walls you may need special plugs and screws.
EN 10
INSTALLATION
Electrical connection
This appliance is manufactured in class I, it must therefore be
connected to the earth system.
Make sure the supply voltage ratings correspond with those stated on
the appliance data plate. The connection to the mains is carried out as
follows:
BROWN = phase L
BLUE = phase N
YELLOW/GREEN = Earth
During the electrical connection make sure that the electrical socket is
equipped with earth connection.
This built in unit has been provided with a power plug. When installing
the hood, make sure that this plug remains accessible.
Attention:
If you want to make a fixed connection, ensure that a multi-pole switch
with a distance between contacts of 3 mm is installed in the supply
cable.
max. 100 mm
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Sprachen:
Andere Asko Dunstabzugshaube Handbücher
Asko
Asko CW4930G Bedienungsanleitung
Asko
Asko EN4359RVS/E02 Bedienungsanleitung
Asko
Asko CBB861S Bedienungsanleitung
Asko
Asko CBB862W Bedienungsanleitung
Asko
Asko CCT1252WC Bedienungsanleitung
Asko
Asko CC4727S / 4000 Bedienungsanleitung
Asko
Asko CC4520 Bedienungsanleitung
Asko
Asko CH060-60 Bedienungsanleitung
Asko
Asko CW 4985 Bedienungsanleitung
Asko
Asko CBB901SB Bedienungsanleitung
Asko
Asko CD4634B/4000 Bedienungsanleitung
Asko
Asko CW4934S/4000 Bedienungsanleitung
Asko
Asko CCT1252W Bedienungsanleitung
Asko
Asko CW4931 Bedienungsanleitung
Asko
Asko CCT9051SC Bedienungsanleitung
Asko
Asko CW4939S/WS90FETGG Bedienungsanleitung
Asko
Asko CW4935SCN Bedienungsanleitung
Asko
Asko ES1011QAM Bedienungsanleitung
Asko
Asko CW4938GCN Bedienungsanleitung
Asko
Asko CBB761S Bedienungsanleitung
