Asko CO4927S Bedienungsanleitung
Instructions for use
Telescopic cooker hood
CO4627S / 4000
CO4927S / 4000
EN Manual EN 3 - EN 16
Pictograms used :
Important information
Tip
EN 3
CONTENT
Your telescopic cooker hood
Description 4
Introduction 4
Use
Controls 5
Maintenance
Cleaning 7
Cleaning the glass panel 8
Metal grease filters 8
Resetting the alarm signal 8
Cleaning the filters 9
Charcoal filter (recirculation version) 9
Changing the charcoal filter 10
Lighting unit 10
Installation
General 11
Electrical connection 12
Mounting the cooker hood 13
Technical specification
15
Appendice
Disposal of appliance and packaging 16
EN 4
Description
A Switch fan on/off
B Reduce extractor capacity
C Increase extractor capacity
D Engage intensive mode
E Clean air function/filter indication
F Timer function
G Switch lighting on/off
H Dim lighting
I Display
Introduction
This user manual gives you a quick overview of all the possibilities
offered by the appliance. You will find information on safety measures
and maintaining the appliance.
Please retain this user manual and the installation guide.
They may be of use to future users of the appliance.
Declaration of conformity
We declare that our products meet the applicable European Directives,
Decisions and Regulations and the requirements listed in the standards
referenced.
Read the separate safety instructions before
using the device!
YOUR TELESCOPIC COOKER HOOD
I
EN 5
USE
Controls
Switching the fan on and off
The cooker hood works only with the glass plate fully extended. If
the glass plate is extended (in the Off position), the cooker hood
automatically starts in position 1.
• Switch the fan on with the on/off button (A) and select the desired
extractor setting with buttons ‘B’ and ‘C’.
The ‘I’ display indicates which setting has been selected.
• Use button ‘D’ to switch on the intensive setting.
“HI” appears in the ‘I’ display.
After 6 minutes the intensive mode is automatically reduced to the
setting previously selected.
Switching the lighting on and off
• Use the ‘G’ button to switch the lighting on and off.
Dimming the lighting
• Dim the lighting with button ‘H’.
The strength of the lighting varies between maximum and minimum,
and vice-versa.
Clean Air function:
With the Clean Air function you can refresh the air in the kitchen
over maximum 24 hours.
• Fully extend the glass plate.
• Switch off the cooker hood.
• Make sure the cooker hood has been switched off.
• Press on the Clean Air button ‘E’.
Every hour, the cooker hood will switch on for 10 minutes
automatically, at the lowest extraction setting. The display reads
“24” and an indicator flashes at the bottom right.
I
EN 6
USE
Switching on the timer
• Switch the fan on with the on/off button (A) and select the desired
extractor setting with buttons ‘B’ and ‘C’.
• Press the Timer button ‘F’.
The cooker hood switches off automatically after 30 minutes. Switch
off the Timer function by pressing button ‘F’ again, or by switching
off the cooker hood with button ‘A’. The display shows the selected
speed and the remaining time.
Grease filter indicator
After 100 hours of use the “FF” indicator is shown in the display.
• Clean the grease filters.
• Reset the filter indicator. While the cooker hood is switched off,
press button ‘E’ for 3 seconds until the filter indicator disappears.
Carbon filter indicator
After 200 hours of use the “EF” indicator is shown in the display.
• Clean the carbon filters.
• Reset the filter indicator. While the cooker hood is switched off,
press button ‘E’ for 3 seconds until the filter indicator disappears.
EN 7
Cleaning
Attention! Before performing any maintenance operation, isolate the
hood from the electrical supply by switching off at the connector and
removing the connector fuse. Or if the appliance has been connected
through a plug and socket, then the plug must be removed from the
socket.
The cooker hood should be cleaned regularly (at least with the same
frequency with which you carry out maintenance of the fat filters)
internally and externally. Do not use abrasive products. Do not use
alcohol!
Attention! Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or failure
to observe the above safety recommendations.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth. Then wipe
with clean water to rinse. Do not use aggressive cleaning agents such
as soda. The cooker hood paintwork will stay looking nice if you wax it
occasionally.
Stainless steel canopy hoods
Do not use any sort of scourer. Treat with a stainless steel care product
and polish with the structure of the stainless steel.
Metal grease filters
These must be cleaned once a month (or when the filter saturation
indication system – if envisaged on the model in possession – indicates
this necessity) using non aggressive detergents, either by hand or in
the dishwasher, which must be set to a low temperature and a short
cycle. The openings must be placed downwards to let the water run
out of the filters. The cleaning agents will make the aluminium filter turn
dull, this is normal.
MAINTENANCE
EN 8
Cleaning the glass panel
• Open the glass panel by pulling it out.
• Pull the 2 hooks to unlock the glass panel for a further external
movement.
• Now the full glass surface can be cleaned.
• It is recommended to use a neutral detergent liquid and a damp
cloth to clean the glass.
• Close the glass panel.
Metal grease filters
The filters can be washed in a dishwasher, and need to be cleaned
whenever the FF sign appears on the display or at least once every
month use. A more frequent cleaning can be necessary if the use is
particularly intensive.
Resetting the alarm signal
• Turn the Lights and the motor off, then disable the 24h function,
if enabled.
• Press button E.
MAINTENANCE
1
2
3
I
EN 9
MAINTENANCE
Cleaning the Filters
• Open the glass panel
• Remove the filters one at a time, pushing them towards the back of
the unit and at the same time pulling downward.
• Wash the filters without bending them, and leave them to dry
completely before replacing. (Due to intensive dishwasher cleaning,
the filters color might change.)
• Replace, taking care to ensure that the handle faces forwards.
• Close the glass panel.
Charcoal Filter (Recirculation Version)
The regenerable active charcoal filter must be washed by hand
with neutral cleaning products, or in the dishwasher at a maximum
temperature of 65 °C (the washing should be done without any plates,
dishes, cups, etc. in the machine).
Remove the excess water without damaging the filter, remove the
holder and let the filter dry in the oven for at least 15 minutes at a
maximum temperature of 100 °C.
To keep the regenerable charcoal filter efficient, this action should
be repeated every 4 months or when indicated by the filter indicator
(EF shown in display).
The filter must be replaced after no more than 3 years, or if it has
been damaged.
It is important that the grease filters and the regenerable active
charcoal filter are thoroughly dry before repositioning.
Activating the alarm signal
• In recirculation version hoods, the filter saturation alarm must be
activated on installation or at a later date.
• Turn the lights and the motor off.
• Press Dand hold for approximately 5 Seconds:
- The message ‘FC’ flashes twice, filter saturation alarm ACTIVATED
- The message ‘FC’ flashes once, filter saturation alarm DEACTIVATED
I
EN 10
MAINTENANCE
Resetting the alarm signal
• Turn the lights and the motor off, then disable the 24h function,
if enabled.
• Press button E.
Changing the Filter
• Open the glass panel.
• Remove the metal grease filters.
• Remove the saturated charcoal filter by releasing the fixing hook.
• Fit the new filter and fasten it in its correct position.
• Replace the metal grease filters.
• Close the glass panel.
Lighting unit
Warning: This appliance is fitted with a white LED lamp classed as
1M according to EN 60825-1: 1994 + A1:2002 + A2:2001 standards;
maximum optical power emitted @439nm: 7µW.
Do not look directly at the light through optical devices (binoculars,
magnifying glasses…).
For replacement contact technical support.
I
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Asko Dunstabzugshaube Handbücher
Asko
Asko CH060-60 Bedienungsanleitung
Asko
Asko CG1 Bedienungsanleitung
Asko
Asko CBB861S Bedienungsanleitung
Asko
Asko CC4520 Bedienungsanleitung
Asko
Asko EN4359RVS/E02 Bedienungsanleitung
Asko
Asko CC4727S / 4000 Bedienungsanleitung
Asko
Asko CW4634S/4000 Bedienungsanleitung
Asko
Asko CW4939S/WS90FETGG Bedienungsanleitung
Asko
Asko CBB761S Bedienungsanleitung
Asko
Asko CBB862W Bedienungsanleitung
Asko
Asko WS90CNTHJ Bedienungsanleitung
Asko
Asko CW4611 Bedienungsanleitung
Asko
Asko CC4840S Bedienungsanleitung
Asko
Asko CCT9051S Bedienungsanleitung
Asko
Asko CC4527S Bedienungsanleitung
Asko
Asko CD4634B/4000 Bedienungsanleitung
Asko
Asko CBB761SC Bedienungsanleitung
Asko
Asko CCT1252WC Bedienungsanleitung
Asko
Asko CW4938GCN Bedienungsanleitung
Asko
Asko CW4624 Bedienungsanleitung
